What is the appropriate temperature for car air conditioning?

1 Answers
LaRonan
07/24/25 11:04am
It is best to keep the car interior temperature between 18-25 degrees Celsius. Generally, a temperature difference of within 10 degrees between the inside and outside of the car is appropriate. The most comfortable temperature for the human body is 20-25 degrees. If it exceeds 28 degrees, people will feel hot, and if it is below 14 degrees, people will feel cold. How to activate the air conditioning heating: In winter, if you need to use the car air conditioning, you should start the car first and wait a few minutes. The engine will begin to warm up. When the engine temperature gauge reaches the middle position, turn on the air conditioning heating. However, you should also set the air circulation mode to external circulation to expel the cold air from the car. After 5 minutes, you can switch back to internal circulation and start driving. When the car is just started, the engine coolant temperature has not yet risen. Turning on the air conditioning heating immediately will dissipate the already limited heat. Each car's engine has its optimal working state. If the temperature is too high or too low, it will not only damage the engine but also increase fuel consumption. How car air conditioning works: Car air conditioning does not have a heating function. The warm air in car air conditioning comes from the engine's heat dissipation. Therefore, those who need to use the heater in winter do not have to worry about additional fuel consumption like in summer when using the air conditioning for cooling. Just pay attention to the timing of turning on the heater. Also, please note that the term 'air conditioning heating' mentioned in this article actually refers to turning on the heater.
Was this review help?
6
1
Share
More Forum Discussions

What is the installation method for the Cruze crankshaft rear oil seal?

First, rotate the crankshaft pulley to the position of the first cylinder. There is a small dot on the crankshaft pulley that should align with the longest protruding strip on the front oil seal housing, then install the rear crankshaft oil seal. After assembling the crankshaft into the cylinder block, the main bearing caps should be installed. Before assembling the rear main bearing cap, apply sealant to the rear part of the mating surface.
9
2
Share

How Many Liters of Transmission Fluid Should Be Added?

Approximately 4 liters of transmission fluid should be added. Transmission fluid is an oil product used to keep the gear system clean, and its functions include: 1. Ensuring the normal operation of the transmission and extending the service life of the transmission device; 2. Providing effective lubrication at low temperatures; 3. Reducing oil loss under harsh operating conditions. The methods for replacing transmission fluid in a car are: 1. Gravity replacement: After loosening the tightening nut at the bottom of the oil pan, the transmission fluid will automatically flow out from the drain hole; 2. Circulation machine replacement: Connect the transmission and the circulation machine through pipeline interfaces, and use new fluid to push out the old fluid; 3. Remove the oil pan for fluid replacement.
13
1
Share

How to Handle 36 Points Deducted from Driver's License?

If a motor vehicle driver accumulates 12 or more points in a single scoring cycle, the relevant authorities will confiscate the driver's license. Participate in a 5-day road traffic safety training course. After completing the training, take the subject one exam with the "Training Completion Certificate" to clear the deducted points upon passing.
17
0
Share

What car has a winged emblem?

Cars with winged emblems include Aston Martin, Bentley, BMW Mini, and Chery Riich. Taking the Bentley Continental 2021 6.0T GT W12 Mulliner as an example: it is a 2-door, 4-seater hardtop coupe with a length, width, and height of 4850mm, 1954mm, and 1405mm respectively, a wheelbase of 2851mm, and a top speed of 333 km/h. The Bentley Continental 2021 6.0T GT W12 Mulliner's engine has a maximum power of 467 kW and a maximum torque of 900 Nm, with a fuel tank capacity of 90L. It is equipped with front seatbelt reminder, brake force distribution, traction control, child seat interface, electronic stability control, and front and rear radar.
13
4
Share

How to Set Up the Reversing Camera on an Older Audi A6?

To set up the reversing camera, you need to select the Parking Assistance System in the MMI system menu, and then several options will appear. You can configure them according to your preferences. Carefully read the instruction manual and user guide to quickly familiarize yourself with the functions of your beloved car.
9
0
Share

How to Adjust the Steering Wheel Weight of Haval H6?

Haval H6 steering wheel weight adjustment method: Some models use a mechanical hydraulic power steering system, which cannot be adjusted; some models use an electric power steering system, which can be adjusted, but the adjustment needs to be done at a 4S shop. The function of the steering wheel is to convert the force applied by the driver to the edge of the steering wheel into torque and then transmit it to the steering shaft. Taking the 2021 Haval H6 Third Generation 2.0T Automatic Two-Wheel Drive Max as an example: its length, width, and height are 4653mm, 1886mm, and 1730mm respectively, with a wheelbase of 2738mm. It is equipped with a 2.0T turbocharged engine, with a maximum power of 155kw and a maximum torque of 325nm.
20
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.