What is the alphabetical order of license plate numbers in Hunan?

What is the maximum wading depth of the Audi A4L?

The maximum wading depth of the Audi A4L is 320mm. The wading depth of the Audi A4L is determined by the height of the vehicle's chassis, which is the ground clearance listed in the model's parameter configuration table. Generally speaking, the greater the ground clearance, the higher the chassis, and the higher the safety factor when driving through waterlogged roads. Therefore, in terms of safe wading depth, the advantages of off-road vehicles and SUVs are obvious. However, for most compact and small cars with low chassis, the position of the vehicle's air intake should be used as a reference when passing through waterlogged roads. If the air intake of the Audi A4L is below the water level when wading, water will be sucked into the engine's cylinders. Since water cannot be compressed like air, it will cause serious damage to the engine's mechanical components (such as connecting rods, pistons, crankshafts, etc.). Therefore, the wading depth should not exceed the height of the engine's air intake. The height of the engine's air intake, and thus the maximum wading depth, can also be increased by installing a snorkel. If wading is unavoidable, the following safe and correct operations should be performed: Before driving through water, be sure to turn off the auto start-stop function to prevent the vehicle from automatically restarting after stalling in the water, which could cause severe engine damage due to water intake. Assess the underwater road conditions based on the passage of vehicles ahead and choose an appropriate entry point. Observe the paths taken by other vehicles and follow their tracks at low speed, avoiding sudden acceleration or deceleration. For roads prone to water accumulation, observe warning water level markers, trees, or reference points such as the wheels and doors of other vehicles to estimate the water depth before deciding whether to proceed. Know your vehicle's safe wading depth. If the water depth exceeds half the height of the tires or the engine's air intake, do not proceed and choose an alternative route instead.

6

3

Share

Can Audi A6L Use 92 Octane Gasoline?

According to the official vehicle manual recommendation, Audi A6L should use 95 octane gasoline. In addition to checking the appropriate gasoline grade in the vehicle manual, you can also find it marked on the fuel tank cap of the Audi A6L. Generally, the gasoline grade can also be determined based on the engine's compression ratio. Vehicles with an engine compression ratio between 8.6-9.9 should use 92 octane gasoline, while those with a compression ratio between 10.0-11.5 should use 95 octane gasoline. However, with the application of some new technologies nowadays, the gasoline grade cannot be solely determined by the compression ratio. High compression ratio engines can also be tuned to use lower octane gasoline because, apart from the compression ratio, other factors such as ignition timing, turbocharging technology, and Atkinson cycle technology also play a role. Generally, the higher the gasoline octane number, the higher the octane value and the better the anti-knock performance. 92 octane gasoline contains 92% isooctane and 8% n-heptane, while 95 octane gasoline contains 95% isooctane and 5% n-heptane. If the Audi A6L occasionally uses the wrong gasoline grade, simply switch back to the correct grade after consumption. However, long-term use of the wrong gasoline grade can have the following effects: For vehicles recommended to use lower octane gasoline, using higher octane gasoline will not cause damage, but the increase in octane value will alter the fuel's ignition point, leading to delayed combustion in the engine. This means both the engine's power output and thermal efficiency will decrease, resulting in poorer performance in actual driving experience. For vehicles recommended to use higher octane gasoline, using lower octane gasoline can cause engine knocking. Due to the significantly lower octane value, the gasoline's ignition point decreases, causing premature ignition during the compression stroke. If combustion occurs before the spark plug ignites during the compression stroke, resistance will arise during the upward stroke. This resistance makes the engine run very unstably. If it's mild knocking, it only increases noise without obvious engine damage. However, if there's noticeable knocking, it indicates severe engine conditions, affecting not only driving stability but also causing abnormal wear on pistons and cylinders, and in severe cases, cylinder scoring.

6

5

Share

How many points are deducted for crossing the line when changing lanes on the highway?

Crossing the solid line when changing lanes on the highway will result in a 3-point deduction and a fine of 200 yuan. On highways, vehicles are prohibited from reversing, driving against the flow, crossing the central divider, or stopping within the lane, as these actions violate prohibitory signs and markings. Below are the relevant traffic regulations: According to the "Scoring Standards for Road Traffic Safety Violations," Article 3 states that drivers committing any of the following violations will be penalized with 3 points: 1. Driving a passenger vehicle (excluding buses and school buses) with passengers exceeding the approved capacity by less than 20%; 2. Driving medium-sized or larger passenger or cargo vehicles, or hazardous material transport vehicles on roads other than highways or urban expressways, or driving other vehicles at speeds exceeding the limit by less than 20%; 3. Driving a cargo vehicle with a load exceeding the approved weight by less than 30%; 4. Driving a vehicle on the highway below the minimum speed limit; 5. Driving a vehicle prohibited from entering the highway onto the highway; 6. Driving a vehicle on the highway or urban expressway without using the designated lane; 7. Driving a vehicle that fails to slow down, stop, or yield to pedestrians at a crosswalk as required; 8. Driving a vehicle in violation of prohibitory signs or markings.

20

2

Share

Reasons for Abnormal Noise During Slow Braking?

There are several reasons for abnormal noise during slow braking: 1. There is sand or other foreign objects between the brake pads and brake discs; 2. If the noise is muffled, it may be due to issues with the brake caliper, such as wear on the sliding pins or detachment of the spring clips. 3. Braking after driving through water can also cause abnormal noise. 4. Excessive wear of the brake pads may expose the fixed points of the friction material, leading to noise when rubbing against the brake disc or brake drum. Below are some related solutions: 1. When a hissing sound occurs during braking, it is recommended to first check if there are any issues with the friction between the caliper, brake disc, and brake pads. 2. When a sharp noise occurs during braking, aside from the break-in period of new pads, the first step should be to check the brake pads for wear or foreign objects. If the brake pads are worn out, they should be replaced immediately. If foreign objects are found, the brake pads should be removed, the objects taken out, and then reinstalled. 3. When a muffled noise occurs during braking, check the brake caliper for wear on the sliding pins or detachment of the spring clips. If any issues are found, they should be replaced immediately. 4. When a rattling noise occurs during braking, check if any attachments on the brake pads are loose. The best solution is to reinforce them or replace the brake pads with new ones.

12

0

Share

How to Test an Automotive Ignition Coil?

There are three methods to test an automotive ignition coil: 1. Visual Inspection: Examine the ignition coil visually. If the insulation cover is cracked or the outer casing is damaged, it may absorb moisture and lose its ignition capability, requiring replacement. 2. Primary and Secondary Winding Open Circuit, Short Circuit, and Grounding Tests: (1) Resistance Measurement Method. Use a multimeter to measure the resistance of the primary winding, secondary winding, and additional resistor of the ignition coil. The values should meet technical standards; otherwise, it indicates a fault and requires replacement. (2) Test Lamp Method. Connect a test lamp to the two terminals of the primary winding. If the lamp does not light, it indicates an open circuit. To check for grounding faults, connect one end of the test lamp to the primary winding and the other end to the casing. If the lamp lights, it indicates a grounding fault. Short circuit faults are not easily detected with a test lamp. 3. Spark Intensity Test: To check the high voltage generated by the ignition coil, it can be tested on a test bench in conjunction with a distributor. Adjust the discharge electrode gap to 7mm, start at low speed, and once the ignition coil reaches operating temperature (60~70°C), adjust the distributor speed to the specified value (generally 1900r/min for four- and six-cylinder engine ignition coils, and 2500r/min for eight-cylinder engine ignition coils). If it can continuously produce blue sparks within 0.5 minutes, the ignition coil is in good condition.

19

1

Share

What is the maximum number of points that can be deducted through traffic law learning?

The maximum number of points that can be deducted through traffic law learning within one scoring cycle is 6 points. According to Article 5 of the Notice issued by the Ministry of Public Security on January 14, 2020 (Public Traffic Management [2020] No. 14), titled "Regulations on Reducing Points for Road Traffic Violations by Accepting Traffic Safety Education (Trial)": Motor vehicle drivers who apply to participate in traffic safety education to reduce points for traffic violations must participate in corresponding road traffic safety laws, regulations, and related knowledge learning, examinations, or traffic safety public welfare activities based on their highest permitted vehicle type and meet the relevant requirements to apply for point reduction. Point reduction through learning is a measure for drivers holding a driver's license who have been penalized with points due to traffic violations. After participating in online traffic safety learning and passing the examination, their points can be reduced. This is a convenient traffic management measure uniformly deployed by the Traffic Management Bureau of the Ministry of Public Security. Specific considerations are as follows: Applicable individuals: Motor vehicle drivers who hold a driver's license of the People's Republic of China, regardless of the permitted vehicle type or whether they are commercial vehicle drivers, can participate in point reduction through learning. They must participate in corresponding road traffic safety laws, regulations, and related knowledge learning and examinations based on their highest permitted vehicle type. Specific rules: Motor vehicle drivers participating in online road traffic laws, regulations, and related content learning must complete 5 minutes of continuous learning each time. The total learning time must accumulate to 30 minutes within 3 days, and they must register for the examination within 7 days. Passing the examination will reduce 1 point. Drivers can also participate in on-site learning, with each session lasting no less than 1 hour. After completing the required learning hours, they can apply for the examination. Passing the examination will reduce 2 points. Cases where applications will not be accepted: Under any of the following circumstances, the application will not be accepted: The driver has more than two full-point records in the previous scoring cycle. Within a 3-point cycle, the driver has fled the scene of a traffic accident, driven under the influence of alcohol, or engaged in the manufacture or alteration of documents or license plates. The driver's license is in the probationary period or has not been reviewed as required. The driver has unresolved traffic violation records under their name. The driver has a motor vehicle under their name with an expired safety technical inspection or not deregistered as required. The driver has already reduced the maximum of 6 points within the cycle.

1

2

Share

What is the alphabetical order of license plate numbers in Hunan?

What is the maximum wading depth of the Audi A4L?

Can Audi A6L Use 92 Octane Gasoline?

How many points are deducted for crossing the line when changing lanes on the highway?

Reasons for Abnormal Noise During Slow Braking?

How to Test an Automotive Ignition Coil?

What is the maximum number of points that can be deducted through traffic law learning?

What are the contents of the new policy on the transfer of new energy vehicles?

How to Use the Automatic Transmission D+?

How often should a car be inspected after 15 years?

Where is the Reverse Radar Switch?