What is the age limit for obtaining a driver's license according to national regulations?

1 Answers
TaliaRose
07/30/25 5:41am
National regulations stipulate that individuals over 70 years old cannot apply for a small car driver's license. However, there is no upper age limit after obtaining the license, but those over 70 must submit an annual medical examination report to the vehicle management office. The age requirements for obtaining a driver's license are as follows: 1. Motorcycles (D, E licenses): Applicants must be between 18 and 60 years old. 2. Small cars (C1, C2, C5 licenses): Applicants must be between 18 and 70 years old. 3. Large trucks, heavy and medium-duty trucks (B2 license): Applicants must be between 20 and 50 years old. 4. Tractor trailers (A2 license): Applicants must be between 24 and 50 years old and must have held a B1 or B2 license for at least three years. 5. Medium-sized passenger vehicles (B1 license): Applicants must be between 21 and 50 years old and must have held a small car license or above for at least three years. 6. City buses (A3 license): Applicants must be between 20 and 50 years old.
Was this review help?
20
5
Share
More Forum Discussions

Why Does the Front Shock Absorber of the Bora Make Noise?

The reasons for the front shock absorber noise in the Bora are as follows: Shock absorber oil leakage: Oil leakage can reduce the resistance of the shock absorber, which may lead to the valve assembly hitting the bottom of the barrel. Additionally, the reduction in oil may increase the friction between the internal valve and the barrel, causing abnormal noise. Improper spring installation: The shock absorber noise may be caused by improper spring installation. For shock absorbers with a tray, the spring should be installed with a certain distance from the limit on the shock absorber tray to avoid the spring touching the limit during deformation, which can cause abnormal noise. Friction between the shock absorber push rod and oil seal: Noise can also be caused by friction between the shock absorber push rod and the oil seal. If the shock absorber is left unused for a long time, the lubricant at the oil seal may dry out, resulting in dry friction between the oil seal and the push rod, leading to abnormal noise.
1
1
Share

Where is the drain screw for the BMW 5 Series radiator located?

The drain screw for the BMW 5 Series radiator is located at the bottom of the radiator. Opening the screw will allow the water to drain. Introduction to the car radiator: The radiator is the main component of the car's cooling system, also known as the overflow tank. Its function is to maintain the engine temperature. How the radiator works: Through the circulation of coolant in the engine water passages, it absorbs heat from the cylinder block and then dissipates it through large-area cooling fins to maintain the engine's optimal operating temperature. The radiator is composed of hollow copper tubes, where the high-temperature coolant enters the radiator, dissipates heat, and then circulates back to the engine cylinder walls. Main functions of the radiator: When the engine's water temperature is high, the water pump circulates water repeatedly to lower the engine's temperature, thereby protecting the engine. In winter, if the water temperature is too low, the water circulation will stop to prevent the engine from becoming too cold.
18
5
Share

Why are the headlights of an Audi A8 not very bright at night?

Audi A8 headlights not being bright enough can be resolved by upgrading to xenon headlights or replacing them with brighter bulbs. Reasons for insufficient brightness of car headlights: It is due to the accumulation of excessive dust and debris inside and outside the headlights during long-term driving, which reduces the projection performance of the headlights. You can choose to clean the inner and outer covers of the headlights. Prolonged use can inadvertently allow a lot of dust to settle inside the car lights, causing them to turn yellow with accumulated stains. This not only affects aesthetics but also significantly compromises the safety of nighttime driving. Methods to enhance the brightness of Audi A8 headlights: Car headlight enhancers use a scientific voltage-boosting method to provide a constant optimal working voltage exclusively for the car's headlights. They offer a preheating protection for the bulb filaments during startup (3~6 seconds), after which the headlights emit a steady, bright white light. This brightness does not fluctuate with changes in engine speed and does not alter the original light distribution of the headlights.
15
2
Share

What is the height setting for the tailgate of the Mercedes-Benz GL450?

To set the tailgate of the Mercedes-Benz GL450 to the desired height, hold the closing switch for 5 seconds. Methods for adjusting the tailgate height: Press the trunk open button on the key or use the manual release on the tailgate to open it. Stop at the desired height by pressing the trunk button on the remote control. At this point, you can manually fine-tune the height by moving the tailgate up or down. Once adjusted, press and hold the close button on the tailgate until you hear a confirmation beep. Precautions for using the power tailgate: When operating the power tailgate, safety should be a priority, especially for some SUV models. Always check for obstacles behind the vehicle before opening the tailgate. Obstacles may damage the tailgate cover. SUV tailgates are generally larger, so it's important to ensure there are no obstructions before opening. If the vehicle is equipped with a power tailgate, avoid using hands to open or close it, as this may damage the electric actuator.
8
4
Share

Why is there a gap in the Volkswagen CC steering column?

The reasons for the gap in the Volkswagen CC steering column are as follows: Wear of the internal gear rack in the steering gear: Wear of the internal gear rack in the steering gear leads to excessive clearance in the gear rack, resulting in a gap in the steering column. Wear of the universal joint: It may be due to wear of the universal joint inside the steering column connected to the steering wheel, causing excessive clearance in the steering column. Improper assembly between steering system components: Excessive clearance in the steering column could be caused by improper assembly between steering system components or wear of the components. Function of the automotive steering column: The automotive steering column is mainly used to control the direction of the vehicle, transmit torque, and absorb energy during a collision. To meet the comfort requirements of the driver, the steering column can be adjusted in the up-down and front-back directions. After being connected with the ignition lock, it can achieve the anti-theft locking function of the vehicle.
5
2
Share

At how many kilometers should the timing belt of Fukang be replaced?

The timing belt of Fukang should generally be replaced at around 50,000 to 60,000 kilometers. Method for replacing the car timing belt: Remove the upper cover of the timing belt. After removal, turn the large crankshaft bolt below clockwise. There is a small round hole on the pulley. When the small hole rotates to the top, align it with the small round hole on the cylinder head. Then, check the connection between the engine and the transmission below to ensure alignment. Remove the inserted screws above or the internal square wrench below, ensuring the belt does not rotate. This completes the process. Function of the timing belt: It connects with the crankshaft and ensures accurate intake and exhaust timing through a specific transmission ratio. Belts are used instead of gears for transmission because they produce less noise, have minimal self-variation, and are easier to compensate. The timing belt connects the camshaft and the crankshaft, controlling the opening and closing of valves and the rotation of the crankshaft and the up-and-down movement of pistons.
17
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.