What is the actual wheel horsepower of the tenth-generation Accord?

2 Answers
VanBrynlee
07/24/25 10:18am
The tenth-generation Accord is equipped with a new powertrain, and the actual wheel horsepower figures are as follows: High-power 1.5T engine: Maximum power of 194 horsepower. Low-power 1.5T engine: Maximum power of 177 horsepower. Details about the tenth-generation Accord are as follows: Body dimensions: Length*Width*Height (mm) is 4893×1862×1449, with a wheelbase of 2830 (mm). Suspension system: Front suspension is MacPherson independent suspension, and rear suspension is multi-link independent suspension. Safety systems: Include ACE Advanced Compatibility Engineering body structure, door-mounted side impact protection beams, ABS anti-lock braking system, EBD electronic brake-force distribution system, TCS traction control system, BA brake assist system, VSA vehicle stability assist system, HSA hill start assist system, ESS emergency stop signal system.
Was this review help?
10
1
Share
MacAlyssa
08/11/25 5:27am
I've been driving the 10th-gen Accord 1.5T for almost three years. The official rating is 192 horsepower, but the actual wheel horsepower is less. Last year, I tested it on a dyno at a tuning shop, and it showed around 150-160 horsepower, depending on road and vehicle conditions. The front-wheel-drive system has significant power loss, estimated at 15%-20%, mainly due to the transmission and drive shaft. Hot weather reduces horsepower more, while cold weather is better—for example, in winter during peak city traffic, I get around 155 horsepower. Worn-out tires have an even bigger impact; after replacing them, I gained about 5-6 horsepower. Daily driving is fine, and overtaking feels fairly nimble, but don't expect a racing sensation. Upgrading the air filter or tuning the ECU can help, but consult a professional shop for safety before making any modifications. This generation of the Accord has low fuel consumption and stable horsepower, making it quite practical.
Was this review help?
7
4
Share
Expand All
More Forum Discussions

Why Does the Cruise Control Function Fail?

The following are the reasons and solutions for cruise control function failure: 1. Speed does not meet the requirements: Cruise control activation requires the vehicle speed to meet the system's specified conditions, otherwise the cruise control system cannot start normally. Solution: Ensure the vehicle speed reaches 40 kilometers per hour. 2. Malfunction during driving: The system cannot be stopped by pressing the brake or clutch during driving. There are two main reasons: one is cruise switch damage or circuit failure (such as brake pedal sensor failure, wheel speed sensor failure, or related circuit failures); the other is the ECU's inability to receive signals from the cruise control solenoid valve. Solution: Immediate repair at a service center is required in such cases.
16
2
Share

Is 12 points definitely deducted for hit-and-run in a parking lot?

For a hit-and-run incident in a parking lot, if it does not constitute a crime, 12 points will be deducted and a fine imposed, with the possibility of detention for up to 15 days; if it constitutes a crime and involves fleeing the scene, in addition to the revocation of the motor vehicle driving license, the offender will be banned from driving for life; if there are other particularly egregious circumstances, the offender may face imprisonment of three to seven years; if the hit-and-run results in death, the offender may face imprisonment of seven years or more. According to the Road Traffic Safety Regulations, in the event of a traffic accident, the driver must immediately stop the vehicle and protect the scene. If there are casualties, the driver must immediately rescue the injured and promptly report to the traffic police on duty or the traffic management department of the public security organ. If the scene is altered due to rescuing the injured, the positions should be marked, and passengers, passing drivers, and pedestrians should assist.
7
2
Share

How to Remove the Rear Seats of a Kia K3?

The steps to remove the rear seats of a Kia K3 are as follows: 1. First, unscrew the two M12 flange bolts (commonly referred to as 12mm hex bolts) securing the seat cushion. 2. The specific locations of these two bolts are along the centerline below the seat back, at the gap between the seat cushion and the backrest. 3. Next, release the two clips at the front of the seat cushion by pulling upward firmly. 4. To remove the backrest, unscrew the two M12 flange bolts located on each side at the lower part of the seat back. 5. It is recommended to have two people for this step: simultaneously pull the lower part of the backrest outward to gradually loosen it, then lift the entire backrest upward as there are clips on both sides near the windows and one in the middle.
1
1
Share

What are the symptoms of a bad lower control arm ball joint?

The symptoms of a bad lower control arm ball joint are as follows: 1. The tires will swing abnormally during driving, causing abnormal tire wear and increased noise. 2. When the car is driving at high speed, the steering wheel will shake, and there will be noise from the chassis when driving on bumpy roads. 3. There will be a "clicking" sound from the steering wheel. Since the lower control arm is part of the steering system, a damaged lower control arm bushing directly leads to abnormal vehicle dynamics, causing the vehicle to pull to one side, increased wear affecting steering control, which is very detrimental to safety. It is recommended to go to a repair shop for relevant inspections and perform a four-wheel alignment after adjustments.
12
1
Share

Where is the fuel tank cap switch of the Langdong?

The fuel tank cap switch of the Langdong is located under the driver's seat near the door side, where there are two pull switches: one for the fuel tank and the other for the trunk. Here are some related introductions about the Langdong: 1. Interior facilities: Equipped with a large-screen DVD intelligent navigation, dual-barrel instrument panel, and dual-zone automatic air conditioning. 2. Power system: Powered by a 1.6L γ engine and a 1.8L Nu engine. The transmission options include a 6-speed manual and a manual-automatic integrated transmission. 3. Body dimensions: The length, width, and height are 4570mm, 1775mm, and 1445mm respectively, with a wheelbase of 2700mm.
8
1
Share

Where is the air conditioning filter located in the Qashqai?

The air conditioning filter in the Qashqai is located near the left foot area of the front passenger seat. Below are the steps for replacing the Qashqai's air conditioning filter: 1. Remove the decorative panel on the right side of the driver's seat. It's easier to start from the top and work your way down. 2. The filter cover is connected to a gray sealing sponge and has a handle in the middle. The bottom of the cover has a clip; use your finger to pull it, and the cover will come off. 3. After removing the cover, you can pull out the air conditioning filter. Note: The filter has a front and back side. While original equipment manufacturer (OEM) filters have markings indicating front and back, other filters may have a thin extra material on the short edge of the frame to distinguish the sides. 4. Installing the filter can be challenging, mainly due to the awkward position. You can bend the filter toward the front of the car and, once fully inserted, pull it back and forth a few times to ensure it's properly seated. Finally, replace the cover. Without an air conditioning filter, particles can enter the cabin, contaminating the car's air conditioning system and reducing the cooling system's performance. Inhaling dust and harmful gases can cause allergic reactions, lung damage, and irritation from ozone exposure, along with unpleasant odors, all of which can affect driving safety. A high-quality air filter can capture fine particles, reduce respiratory discomfort, minimize irritation for allergy sufferers, enhance driving comfort, and protect the air conditioning and cooling system.
5
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.