What is the actual measured ground clearance of the 2021 Equinox?

1 Answers
MilaDella
07/29/25 6:19pm
The actual measured ground clearance of the 2021 Equinox is 170mm. The minimum ground clearance of the 2021 Equinox refers to the distance between the lowest point (excluding the wheels) and the supporting plane, which indicates the vehicle's ability to pass over obstacles such as rocks and tree stumps without collision. The higher the ground clearance of the 2021 Equinox, the better its off-road capability. However, if the ground clearance is too high, the stability at high speeds may decrease. The 2021 Equinox is a mid-size SUV launched by Chevrolet. Its body dimensions are 4646mm in length, 1843mm in width, and 1684mm in height, with a wheelbase of 2725mm. In terms of power, this model offers two engine options: a 1.5T and a 2.0T turbocharged engine. The 1.5T engine delivers a maximum power of 124kW and a maximum torque of 250Nm, while the 2.0T engine provides a maximum power of 191kW and a maximum torque of 353Nm. Generally, the ground clearance of sedans ranges between 110mm and 150mm, while SUVs typically have a ground clearance between 200mm and 250mm. However, the ground clearance of the 2021 Equinox is not static; it also depends on the load condition. Therefore, changes in ground clearance should be considered based on the load variation of the 2021 Equinox. When selecting a vehicle, ground clearance can be one of the reference factors. The choice should depend on the vehicle's intended use and the road conditions. For well-paved urban roads, a vehicle with lower ground clearance can enhance stability and comfort. For long-distance travel or driving in areas with poor road conditions, a vehicle with higher ground clearance is advisable to improve off-road performance and avoid damage to the undercarriage.
Was this review help?
16
2
Share
More Forum Discussions

Can I Modify the Direct-Push Master Cylinder Without Changing the Calipers?

It is possible to modify the direct-push master cylinder without changing the calipers. Additional Information: About Calipers: Calipers are also known as brake wheel cylinders. Inside the calipers, there are multiple pistons. The function of the calipers is to push the brake pads to clamp the brake disc, thereby slowing down the vehicle. When the brake pads clamp the brake disc, kinetic energy is converted into heat energy. The braking system is a crucial component of a vehicle, as it directly affects the driving stability and safety. About the Master Cylinder: The master cylinder is used for oil storage and control, while the slave cylinder (or wheel cylinder) pushes the brake piston to press the brake friction pads, clamping the brake disc to achieve braking. The master cylinder and slave cylinder are connected via a hydraulic line, transmitting hydraulic pressure from the master cylinder to the slave cylinder.
17
2
Share

Can Toothpaste Be Used to Clean Car Windows?

Toothpaste can damage car windows. Toothpaste is typically composed of many substances with abrasive properties, such as dicalcium phosphate, calcium carbonate, silicon dioxide, calcium pyrophosphate, aluminum hydroxide, etc. The characteristics of these substances determine that toothpaste has a friction function. If toothpaste is used to clean windows, under streetlights, you can see dense scratches one after another. Overview of Car Maintenance in Summer: Car maintenance refers to the preventive work of regularly inspecting, cleaning, replenishing, lubricating, adjusting, or replacing certain parts of the car, also known as car servicing. Currently, car maintenance mainly includes the scope of maintenance for the engine system, transmission system, air conditioning system, cooling system, fuel system, power steering system, etc. The Role of Car Maintenance: The purpose of car maintenance is to keep the car clean and in normal technical condition, eliminate hidden dangers, prevent faults, slow down the deterioration process, and extend the service life.
17
1
Share

Why Can't I Shift Gears When Pressing the Clutch in a Manual Transmission?

Manual transmission failing to shift gears is usually caused by incomplete clutch disengagement. In this Encore, the issue arises from a leaking clutch slave cylinder, which prevents it from pushing the pressure plate. The Encore features an integrated design for the release bearing and clutch slave cylinder. The function of the clutch: The clutch serves to cut off the engine's power when shifting gears or coming to a stop. If you don't press the clutch promptly as the car slows down, maintaining the connection between the engine and the vehicle speed, the engine may stall due to excessively low RPM. Therefore, fully depressing the clutch when stopping helps avoid engine stalling. Clutch operation techniques: During the gradual release of the clutch, pay attention to the tachometer on the dashboard. Before engagement, the RPM typically stabilizes around 800-1000 revolutions per second (R/S). Upon reaching the semi-engagement point, the needle will show a noticeable drop. For hill starts, this is the moment to release the brake.
2
0
Share

What happens if you don't turn off ESP during launch control?

If not turned off, the system will intervene when the tires slip during launch, cutting power output. Disabling ESP is to avoid this power interruption, which is why it's typically turned off during hard acceleration, but you still shouldn't floor the throttle at launch. Introduction to ESP: ESP, translated as "Electronic Stability Program" in Chinese, analyzes vehicle driving state information from various sensors and then sends correction commands to ABS, EBD, etc., to help maintain dynamic balance. ESP can keep the vehicle optimally stable under various conditions, with particularly noticeable effects in cases of oversteer or understeer. Components of ESP: The ESP system consists of a control unit and various sensors: steering angle sensor (monitors the steering wheel's angle), wheel speed sensors (monitor the speed of each wheel), yaw rate sensor (monitors the vehicle's rotation around the vertical axis), and lateral acceleration sensor (monitors centrifugal force during turns).
11
0
Share

Is the penalty points deducted from the driver's license or the vehicle license?

Penalty points are not deducted from the vehicle license; all deductions are applied to the driver's license, meaning all points are recorded on the driver's license of the vehicle operator. Deducting points from the driver's license is part of handling traffic violations. If you violate traffic rules or engage in improper driving behavior while on the road, you will receive corresponding penalty points and fines. A driver's license only has 12 points, and once all points are deducted, the license will be revoked, requiring the driver to retake the driving test. During the annual inspection of your vehicle, the vehicle license plays a crucial role. You must first resolve any outstanding traffic violations, then bring both the vehicle license and driver's license to the vehicle management office for the annual inspection to pass. Introduction to the Vehicle License: The People's Republic of China Motor Vehicle Driver's License, commonly referred to as the driver's license or "driving license," is a mandatory document issued under Chinese law for individuals operating motor vehicles. Anyone driving civil motor vehicles on public roads must apply for a driver's license in accordance with the "People's Republic of China Motor Vehicle Driver's License Management Regulations." The driver's license is valid nationwide. It records the holder's ID number, name, gender, date of birth, permanent address, nationality, permitted vehicle class code, initial issuance date, validity period, and management records, along with the issuing authority's seal, file number, and the holder's photo. The design of the driver's license is standardized by the Ministry of Public Security. Examination Content for the Vehicle License: The test subjects include traffic regulations and related knowledge, field driving, and road driving (including safe and civilized driving).
7
3
Share

Benefits of Inflating Tires with Nitrogen in Summer?

Nowadays, more and more car owners prefer to follow the trend of inflating their car tires with nitrogen, especially in summer. It is said that nitrogen can prevent tire blowouts. Reduced Risk of Tire Blowouts: Compared to inflating tires with regular air, high-purity nitrogen, being oxygen-free, moisture-free, and oil-free, has a much lower thermal expansion coefficient. This effectively slows down the heat buildup in tires, significantly enhancing tire safety and thereby reducing the occurrence of blowouts. Reduced Driving Noise: Nitrogen is a diatomic gas with low chemical reactivity and extremely low audio conductivity, only about 1/5 that of ordinary air. Therefore, using nitrogen can effectively reduce tire noise during driving, noticeably improving driving quietness. Extended Tire Lifespan: After using nitrogen, tire pressure becomes more stable, and the volume change of the gas inside the tire is minimized. This greatly reduces irregular tire wear, effectively extending the tire's lifespan.
7
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.