What is the actual fuel consumption of the Santana 1.5?

Should the Clutch Pedal Be Kept Depressed While Driving?

It is not necessary to keep the clutch pedal depressed while driving. Releasing the clutch during steady driving will not stall the engine, and pressing the accelerator does not require depressing the clutch. Here are several situations when the clutch pedal should be used: 1. When starting the car: Quickly depress the clutch pedal and then release it to the half-engaged position. 2. When shifting gears: Reduce the speed to match the corresponding gear and quickly depress the clutch. The clutch pedal should be pressed and released swiftly without lingering in the half-engaged state, as this can accelerate clutch wear. Additionally, ensure proper coordination with the accelerator. 3. When stopping the car: Depress the clutch when the vehicle speed is below 15km/h, then use the brake to bring the car to a complete stop.

15

0

Share

What is the difference between GLE and ML?

The differences between the Mercedes-Benz GLE and ML are as follows: 1. Comparing the GLE-400-4MATIC model with the ML-400-4MATIC Luxury model, it is found that the GLE-400-4MATIC adds 7 configurations on the basis of the ML-400-4MATIC model, yet its price is lower. It can be said that the GLE offers better value for money compared to the ML. 2. The GLE-400-4MATIC is equipped with 20-inch dual 5-spoke light alloy wheels, while the ML-400-4MATIC Luxury model comes with 19-inch 5-spoke AMG light alloy wheels.

9

3

Share

How to Solve the Sunroof Noise Issue in Raeton CC?

Here are the solutions for addressing the sunroof noise issue in Changan Raeton CC: 1. The presence of noise indicates severe lack of lubrication in the sliding rails. Check for any deformation in the rails and perform timely lubrication maintenance. 2. After inspecting the sunroof sliding rails, you can add some lubricating oil. 3. Check the fastening condition of the sunroof, as looseness may also cause noise. 4. The sunroof sealing strip, being exposed to rain or sunlight for extended periods, is prone to aging. Rubber conditioner can temporarily restore the performance of the sealing strip. Open the sunroof fully and spray rubber conditioner onto the sealing strip.

3

5

Share

Where is the thermostat located in a car?

Automotive thermostats are generally installed at the upper water outlet of the engine. Below is relevant information about the thermostat: 1. The thermostat must maintain good technical condition; otherwise, it will severely affect the normal operation of the engine. If the main valve of the thermostat opens too late, it will cause the engine to overheat. If the main valve opens too early, the engine's warm-up time will be too short, resulting in the engine temperature being too low. 2. The thermostat automatically adjusts the amount of water entering the radiator based on the coolant temperature to ensure the engine operates within an appropriate temperature range, which can help save energy. This is because the engine consumes more fuel at low temperatures and causes greater damage to the vehicle, including the easy formation of carbon deposits and a series of related problems.

11

5

Share

Is it necessary to drain oil when replacing the fuel filter?

Generally, it is not necessary to drain oil when replacing the fuel filter. Here are some important points to note when replacing the fuel filter: 1. After replacing the fuel filter or oil filter, pay attention to the sealing of the interface to prevent oil leakage; 2. Smoking and open flames are strictly prohibited when replacing the fuel filter or performing maintenance on the fuel system; 3. The fuel filter must be replaced when the engine is cold, as the high-temperature exhaust gas from the exhaust pipe when the engine is hot can ignite the fuel; 4. The filter has arrow marks indicating the direction of fuel flow, so make sure not to install it backwards during replacement; 5. Before replacing the fuel filter, the pressure in the fuel system should be released according to the operating procedures specified by the car manufacturer.

12

0

Share

Why does the car steering wheel squeak when turning?

The causes of abnormal noise when turning the car steering wheel include: 1. Lack of lubrication in the steering column or low power steering fluid can cause the steering wheel to shake and produce noise. This situation usually requires replacing the steering tie rod end and performing a four-wheel alignment after replacement. 2. Universal joint failure; 3. Aging of the rubber bushings on the suspension stabilizer bar links. If the stabilizer bar bushings are loose, they can be fixed by adding shims, but if damaged, replacement is necessary. 4. Planar bearing failure; 5. Issues with the clock spring; check if the clock spring is damaged; 6. The shock absorber planar bearing producing abnormal noise.

10

0

Share

What is the actual fuel consumption of the Santana 1.5?

Should the Clutch Pedal Be Kept Depressed While Driving?

What is the difference between GLE and ML?

How to Solve the Sunroof Noise Issue in Raeton CC?

Where is the thermostat located in a car?

Is it necessary to drain oil when replacing the fuel filter?

Why does the car steering wheel squeak when turning?

How Often Should the Coolant in a Sedan Be Replaced?

What are the 4HLc and 4LLc central differential systems?

How to Downshift and Slow Down in an Automatic Transmission Car?

How Long Does a Wheel Alignment Take?