What is the actual fuel consumption of the Outlander 2.4 AWD?

1 Answers
LeilaRose
07/29/25 7:44pm
Outlander 2.4's comprehensive fuel consumption per 100 kilometers is approximately 8.4 liters. Basic introduction to the Outlander: 1. Model introduction: The Outlander is a compact SUV with relatively spacious interior and an affordable price. 2. Engine specifications: The Outlander is equipped with two engines: a 2.0L naturally aspirated engine and a 2.4L naturally aspirated engine. The 2.0L naturally aspirated engine, codenamed 4J11, has a maximum power of 122kW, maximum torque of 201 Nm, maximum power speed of 6000 rpm, and maximum torque speed of 4200 rpm. This engine features multi-point fuel injection technology and uses an aluminum alloy cylinder head and block.
Was this review help?
16
1
Share
More Forum Discussions

What Causes the Car Battery Light to Stay On?

Reasons for the car battery light staying on: 1. If the voltage generated by the alternator is lower than the battery voltage, the alternator is not working, or there is a fault in the power supply circuit, the car battery light will illuminate. In this case, the alternator and charging circuit should be inspected at a repair shop. 2. Insufficient battery charge can also cause the battery indicator light to illuminate. In this situation, the vehicle can still be used because the battery can be recharged by the alternator inside the engine while driving. 3. The battery light on the dashboard is a warning light indicating that the alternator is not generating electricity. Normally, it will light up when the ignition switch is turned to the ON position and turn off after the engine is started. If the light remains on after the engine is running, it may indicate that the alternator is not generating electricity or there is a problem with the circuit, requiring inspection at a service station.
18
5
Share

Where is the cabin air filter located in a Toyota Corolla?

Toyota Corolla's cabin air filter is located behind the glove compartment on the passenger side. To replace the cabin air filter, first open the glove compartment, remove the pull rod beside it, then press the edges of the glove compartment inward with both hands to fully lower it. You'll then see the cabin air filter cover. Press the clips on both sides of the cover with both hands to remove it, and you can then take out the cabin air filter. The Toyota Corolla is a compact sedan equipped with two types of engines - a 1.8L naturally aspirated engine and a 1.2L turbocharged engine, paired with either manual or automatic transmissions across six trim levels. During highway driving, the engine demonstrates excellent continuous acceleration capability.
14
4
Share

What is the suitable tire pressure for Wuling Hongguang in summer?

Wuling Hongguang's suitable tire pressure in summer is 2.4-2.5 bar. Due to seasonal factors, the tire pressure can be appropriately increased by 0.2 bar in winter and reduced by 0.1 bar in summer. This data follows the international GBT2978-2008 standard requirements. The tire pressure monitoring system in Wuling Hongguang S can be checked by pressing the tire pressure monitoring button on the center console area. The direct tire pressure monitoring device uses pressure sensors installed in each tire to directly measure the tire pressure. It transmits the pressure information from inside the tire to the central receiver module via wireless transmitters and then displays the tire pressure data for each tire. The system automatically alerts when the tire pressure is too low or there is a leak. Generally, a tire pressure above 2.8 bar is considered too high, and below 2.0 bar is too low. Hazards of excessive tire pressure: Reduced tire friction and adhesion, affecting braking performance; causes steering wheel vibration and deviation, reducing driving comfort; accelerates wear on the central tread pattern, shortening tire lifespan; increases vehicle vibration, indirectly affecting the lifespan of other components; overextends tire cords, reducing elasticity and increasing the load on the vehicle during driving. Hazards of insufficient tire pressure: Increases friction coefficient with the road surface, raising fuel consumption; makes the steering wheel heavy and prone to deviation, compromising driving safety; increases movement in various parts of the tire, causing abnormal heat due to excessive rolling; reduces the functionality of cords and rubber, leading to delamination or cord breakage and excessive friction with the rim, damaging the tire bead and causing abnormal wear; multiplies friction between the tire and ground, sharply raising tire temperature, softening the tire, and drastically reducing its strength. High-speed driving may lead to a tire blowout. If the tire pressure monitoring indicator light comes on (a yellow symbol with an irregular circle, no seal on top, four small spikes below, and an exclamation mark inside), it is generally due to one of the following three reasons: Abnormal tire pressure: Typically, an alarm is triggered when pressure is below 1.8 bar or above 3.0 bar. In this case, tire inspection and pressure adjustment are required. Tire pressure monitoring not reset: After inflating the tires, if the tire pressure is not reset in time, the system records the previous data, causing the indicator light to turn on. Simply reset the tire pressure to resolve this. Damaged tire pressure sensor: The tire pressure sensor, which monitors tire pressure, is installed inside the tire and connected to the inflation valve. If the sensor is damaged due to impact while driving, the tire pressure fault light will illuminate. For sensor damage, the only solution is to replace it with a new one.
13
2
Share

What are the steps to park and turn off a BMW X3?

BMW X3 parking and turning off steps are: First, press the brake pedal, wait for the car to come to a complete stop, shift into N gear, then pull up the electronic parking brake, press the ignition button to turn off the engine, shift into P gear, wait for the dashboard to return to the 0 position, and finally remove the car key. The BMW X3 is a mid-size SUV with dimensions of 4717mm in length, 1891mm in width, and 1689mm in height, with a wheelbase of 2864mm. The BMW X3 is equipped with a 2.0-liter turbocharged engine, delivering a maximum power of 135kW and a maximum torque of 290Nm. It features direct fuel injection technology and uses an aluminum alloy cylinder head and block, paired with an 8-speed automatic transmission (AT).
4
1
Share

How many cylinders does the Geely Vision X6 engine have?

Geely Vision X6 is equipped with a four-cylinder engine, with a maximum power of 104kW and a maximum torque of 235Nm. It features multi-point fuel injection technology, using an aluminum alloy cylinder head material and cast iron cylinder block material. The Vision X6 is a compact SUV under Geely Auto, with dimensions of 4546mm in length, 1834mm in width, and 1715mm in height, and a wheelbase of 2661mm. The front face of the Geely Vision X6 adopts a ripple-shaped grille paired with a clean and crisp exterior design, adding LED daytime running lights and a 360-degree panoramic imaging system, along with larger-sized wheels.
2
0
Share

What is the maximum wading depth of the Volvo XC90?

According to official information, the maximum wading depth of the Volvo XC90 is 45 cm. It uses 275/45R20 tires, has a body height of 1776 mm, a curb weight of 2015-2071 kg, and is a five-door, five-seat SUV. The maximum wading depth refers to the deepest water a vehicle can safely pass through. Generally, sedans have a maximum wading depth of no more than 30 cm, while SUVs can handle slightly deeper water, though it's best not to exceed 50 cm. Among common models, the GAC Trumpchi GS8 has a maximum wading depth of 30 cm, the Audi A4 has 32 cm, the Volkswagen Sagitar has 30 cm, the Land Rover Range Rover has 90 cm, the Jeep Compass has 48 cm, and the Highlander has 45 cm. SUVs clearly outperform sedans in wading depth. Generally, depending on the water depth and the vehicle's specifications, drivers should take different measures as follows: If the water reaches the exhaust pipe height, it is still safe. Even if water enters the exhaust pipe, the pressure inside is sufficient to expel it. As long as the engine is not turned off in the water, no backflow will occur. If the water reaches the door frame height, it becomes more dangerous. The vehicle's circuits, electronic components, and sensors are mostly located at the bottom, risking short circuits and damage to critical electrical parts, which may prevent the car from starting. If the water reaches the air intake height, it is extremely dangerous. Driving directly into such conditions may cause the engine to stall immediately, leading to permanent damage or rendering the engine unusable.
1
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.