What is the actual fuel consumption of the Honda CR-V?

1 Answers
DelAdriel
07/29/25 9:16pm
2021 Honda CR-V actual fuel consumption is 6.2L/100km. Here are specific methods to reduce fuel consumption: 1. During startup: The car consumes the most fuel when starting at low speeds, so gently press the accelerator to prevent high RPMs, which can effectively reduce fuel consumption. 2. While driving: Avoid unnecessary high RPMs as much as possible, as fluctuating engine speeds can significantly increase fuel consumption. 3. Pay attention to maintenance: Regular maintenance, changing the engine oil, and removing carbon deposits. 4. Avoid emergency braking and make good use of inertia: Try to avoid emergency braking; anticipating road conditions in advance not only improves driving safety but also saves fuel, such as gradually slowing down before traffic lights and using inertia to coast.
Was this review help?
16
5
Share
More Forum Discussions

What does a car hatchback mean?

A hatchback refers to a design where the trunk lid and rear window are integrated as one unit. More details about hatchbacks are as follows: 1. Structurally, hatchbacks feature an integrated tailgate and rear window, which forms a certain angle with the rear seats. The roof smoothly transitions to the rear through the hatchback-style tailgate, resembling the shape of a sedan, but the passenger compartment and trunk are not separated and are instead one unit. 2. Compared to sedans, this design avoids affecting the body's rigidity due to the total length of the side opening at the rear, while combining the advantages of both sedans and two-box cars, thus giving rise to what is commonly referred to as the 'five-door hatchback version of a certain car model.'
9
5
Share

What to Do When the Car Key Cannot Be Removed?

Car keys getting stuck is not a malfunction. There are two scenarios: one where the key cannot be removed after turning off the engine, and the other where the key cannot be turned after insertion. Below are the specific causes and solutions: 1. Key cannot be removed after turning off the engine: This commonly occurs in automatic transmission models. The reason the key cannot be removed is that the gear shift is not fully returned to the P (Park) position. It may appear to be in place, but it hasn't actually triggered the electronic sensor, or there might be an obstruction like a coin in the gear slot preventing it from fully returning. In this case, the owner should check the gear slot for any obstructions, remove them, start the car, and shift the gear again to ensure it is fully returned to the P position. The key can then be removed. 2. Key cannot be turned after insertion: This is actually the car's steering wheel auto-lock function, a simple anti-theft feature. It usually happens when, after parking and turning off the engine, the steering wheel is accidentally turned or the wheels are not aligned properly. The force applied can cause the steering wheel to turn, triggering the auto-lock mechanism, which locks the steering column and prevents movement. Even if the key is inserted, it cannot be turned. If you encounter this issue, you can gently turn the key with your right hand while simultaneously wiggling the steering wheel left and right with your left hand. This should allow the key to turn.
18
0
Share

What does DOUYIN mean?

douyin refers to an engine. The EcoBoost engine is one of Ford Motor Company's representatives of new power technologies, having already secured 125 patents and patent applications in the United States. More details about the EcoBoost engine are as follows: 1. Based on traditional gasoline engines, it further incorporates three key technological advantages: direct fuel injection into the cylinder, turbocharging, and a dual independent variable valve timing system. This not only ensures robust power output but also improves fuel economy by up to 20% and reduces CO2 emissions by 15%. 2. The Ford EcoBoost engine enhances fuel economy and reduces CO2 emissions thanks to its combustion system, which operates in a more efficient and cleaner mode. Its core technology is a high-pressure direct fuel injection system that injects precisely measured small amounts of fuel into each cylinder at pressures up to 200 bar—droplet sizes are typically less than 0.02 mm, about one-fifth the diameter of a human hair. 3. The Ford EcoBoost four-cylinder engine is equipped with independent variable valve timing systems on both the intake and exhaust camshafts, optimizing cylinder airflow at different speeds, particularly improving engine efficiency and performance under partial loads.
17
4
Share

Why does the tire pressure warning light come on after changing tires?

Since the vehicle's computer still defaults to the pre-tire change state after replacement, the warning light will activate. After changing tires, the tire pressure monitoring system must also be reset. Methods to eliminate the tire pressure warning light: 1. After the tire pressure indicator lights up, ensure the vehicle is parked safely by the roadside and check if the abnormal tire pressure detection function on the car's navigation screen is working properly. 2. Once it's confirmed that there is an issue with the tire, check whether the tire pressure is normal. 3. After resetting the tire pressure to the normal standard, start the car and drive for a while.
18
2
Share

Can Temporary License Plates Be Recognized in Parking Lots?

Temporary license plates cannot be recognized by parking lots, as parking systems only identify metal official license plates. Below are the advantages of license plate recognition parking systems: 1. License plate recognition parking allows for rapid vehicle passage: The vehicle management system with pure license plate recognition enables all vehicles to enter quickly without queuing, achieving seamless entry without stopping. 2. License plate recognition parking management is more intelligent: By implementing unmanned entry points and automatic fee calculation at exits, the system minimizes the number of staff and workload required for vehicle fee collection, avoiding unnecessary manual intervention.
7
1
Share

Is it okay to change the engine oil without replacing the oil filter?

Changing the engine oil without replacing the oil filter is not advisable. Here are the specific reasons why it is not recommended: 1. The oil filter is responsible for filtering out contaminants carried by the engine oil: The engine oil carries away impurities from inside the engine, which are then filtered out by the oil filter. If you change the oil without replacing the filter, these contaminants are not completely removed. Over time, not replacing the oil filter can cause it to become clogged with accumulated dirt, allowing pollutants to flow directly into the engine, accelerating wear on engine components. 2. Replacing only the engine oil without the oil filter: The contaminants in the old oil filter will re-enter the fresh oil and circulate, rendering the oil change ineffective. This will also increase engine wear and shorten the engine's lifespan.
3
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.