What is BMW's Driving Safety Assist System?

What Causes Inaccurate Fuel Gauge Readings When Refueling Without Turning Off the Engine?

If the fuel gauge of a new car suddenly drops to zero, it indicates a sensor issue, and you can directly request a replacement from the 4S store. For older cars, timely cleaning is necessary. Fuel Level Sensor Damage: Since gasoline contains many impurities, and the fuel level sensor is constantly immersed in it, over time it becomes contaminated, directly affecting the accuracy of the readings. If the fuel gauge suddenly rises, this is mainly due to the linkage between the fuel level sensor and the float getting stuck, preventing the float from moving up and down normally. As a result, the sensor does not register changes, causing the fuel gauge needle to remain fixed at a certain position. Fuel Pump Design: For many car models, the fuel gauge drops relatively slowly in the first half but accelerates after passing the middle mark. This is primarily related to the design of the fuel pump used to measure fuel levels, which cannot uniformly reflect changes in gasoline consumption. Achieving absolute uniform changes is difficult and cannot be easily altered through repairs or part replacements.

16

4

Share

Does a sedan need an annual inspection in its seventh year?

A sedan does not require an annual inspection in its seventh year. Vehicles exempt from inspection: Non-commercial sedans (including non-commercial sedans, non-commercial small and micro passenger vehicles). Starting from November 20, 2020, non-commercial small and micro passenger vehicles with 7-9 seats (excluding minivans) are included in the exemption scope, exempting them from on-site inspections for the first 6 years, only requiring an application for inspection marks every two years. Starting from November 20, 2020, for vehicles older than 6 years but less than 10 years, the inspection cycle is relaxed from once a year to once every two years. Vehicles over 10 years old: For private vehicles over 10 years old, the original inspection cycle still applies, i.e., once a year for vehicles aged 10-15, and once every six months for vehicles over 15 years old.

9

2

Share

How Many People Pass the Driving Test on Their First Attempt?

Not many people pass all subjects on their first attempt, approximately one-fifth. Relevant information about the driving test is as follows: 1. Introduction: The driver's test is a qualification examination organized by the Vehicle Management Office of the Public Security Bureau. Only by passing the driver's test can one obtain a driver's license and legally operate motor vehicles. 2. Content: The test for motor vehicle drivers is divided into the Road Traffic Safety Laws, Regulations, and Related Knowledge Test (also known as the 'Theory Test', referred to as 'Subject 1'), the Field Driving Skills Test (commonly known as the 'Pole Test', referred to as 'Subject 2'), and the Road Driving Skills and Safe and Civilized Driving Common Sense Test (commonly known as the 'Road Test', referred to as 'Subject 3'). The test content and passing standards are uniform nationwide, with corresponding test items specified according to different types of vehicles eligible for driving.

18

5

Share

What transmission does the Roewe RX5 use?

The transmission of the Roewe RX5 is a product of collaboration between SAIC, General Motors, and BorgWarner, and it is manufactured in China. The Roewe RX5 is equipped with a 7-speed wet dual-clutch transmission and a 6-speed manual transmission. The 7-speed dual-clutch transmission features seven forward gears and utilizes a wet clutch. The wet dual-clutch transmission consists of two sets of multi-plate clutches (one large and one small) mounted coaxially within a sealed oil chamber filled with hydraulic fluid. This design offers better adjustability and higher heat resistance, enabling it to handle higher torque. When using the Roewe RX5's transmission in daily driving, pay attention to the following points: Do not delay transmission fluid changes for too long. Prolonged neglect can damage internal components such as bearings and the housing. Avoid coasting in neutral for extended periods. While some experienced drivers may coast in neutral with manual transmissions, doing so in an automatic transmission can cause overheating and jerking when shifting back to Drive (D). Never shift into Drive (D) or Reverse (R) before the vehicle comes to a complete stop. Some drivers shift into reverse prematurely to showcase "smooth" driving, but this can severely damage the transmission gears, leading to issues like gear grinding over time. Avoid frequently climbing steep slopes in Drive (D). Automatic transmissions may overheat under heavy load or shift too early, causing a lack of power. Use manual mode to lock in lower gears or switch to sport mode to protect the transmission. Do not tow the vehicle over long distances. If the automatic transmission vehicle breaks down, use a flatbed tow truck and move the vehicle onto the tow platform while in Neutral (N). Avoid using tow ropes or direct towing with another vehicle.

7

3

Share

How many people can a sedan accommodate?

A sedan can accommodate 5 people including the driver. Introduction to passenger capacity limits for sedans: A standard sedan can seat 5 people, as long as it does not exceed the approved passenger capacity. Different vehicle models have varying passenger capacities, so it's essential to check the approved passenger limit specified in the vehicle's documentation. According to Article 55, Clause 1 of the Road Traffic Safety Law Implementation Regulations, passenger vehicles on highways must not exceed the approved passenger capacity, excluding children who are exempt from tickets as per regulations. When the passenger capacity is full, the number of exempt children must not exceed 10% of the approved passenger capacity. Penalties for overloading: Most private cars have a passenger limit of 5 people. Carrying even one additional person constitutes a 20% overcapacity violation, which can result in severe penalties if not careful. Overloading by more than 20% results in a 6-point deduction on the driver's license and a fine.

11

2

Share

Which country is the manufacturer of Jatco transmission?

Jatco transmission's largest manufacturer is in Japan. Introduction to Jatco transmission: Nissan's Jatco transmission can be said to be the best brand among CVTs, with the majority of CVTs on the market coming from Jatco. However, apart from Nissan itself, which dares to use steel belt chains on the 2.0T Altima, other brands use Jatco CVTs in low-end models, i.e., engines with torque not exceeding 250 Nm. Weaknesses of Jatco transmission: Like the jerkiness and overheating of dual-clutch transmissions, CVTs also have inherent weaknesses that are unavoidable. One is the inability to withstand high-torque engines, and the other is that after a few years of use, the CVT will inevitably experience steel belt slippage, occasionally leading to a loss of speed. If this happens, there's no need to panic—just drive to the nearest repair shop to replace the steel belt, which isn't too expensive.

6

2

Share

What is BMW's Driving Safety Assist System?

What Causes Inaccurate Fuel Gauge Readings When Refueling Without Turning Off the Engine?

Does a sedan need an annual inspection in its seventh year?

How Many People Pass the Driving Test on Their First Attempt?

What transmission does the Roewe RX5 use?

How many people can a sedan accommodate?

Which country is the manufacturer of Jatco transmission?

Are Sedans Classified as Motor Vehicles or Non-Motor Vehicles?

How to Replace the Key Battery for the New Mercedes-Benz GLS Class?

What issues should be paid attention to when driving through a tunnel?

Why Deflate Tires When Entering the Desert?