What Grade of Gasoline Should a Car Use?

Does crossing the stop line when the red light turns on count as running a red light?

If the vehicle stops, it does not count as running a red light. However, if it continues to drive past, it does count as running a red light. If the vehicle stops at the crosswalk without proceeding further, it is not considered running a red light but rather as stopping beyond the line. According to Article 4, Item 5 of the Scoring Standards for Road Traffic Safety Violations: Failing to drive or stop as required at intersections will result in a 2-point deduction. Running a red light refers to the act where the vehicle, while still behind the stop line, proceeds forward despite the traffic signal being red, and both the front and rear wheels cross the stop line. For electronic enforcement of red-light running, three photos are required: The vehicle is behind the stop line while the traffic signal is red. The vehicle continues to move forward under the red light, with both front and rear wheels crossing the stop line. The vehicle proceeds into the intersection: indicating whether the vehicle forcibly passed through during the red light. On October 8, 2012, the Ministry of Public Security revised and issued the Regulations on the Application and Use of Motor Vehicle Driving Licenses, increasing the penalty for violations such as running a red light from 3 points to 6 points. Running a yellow light will be treated as running a red light, also resulting in a 6-point deduction and a fine. Failing to yield to a 120 emergency vehicle will result in a 3-point deduction. Intentionally following a 120 emergency vehicle through a red light will result in a 6-point deduction and a fine. Running a red light is not considered illegal under the following circumstances: Yielding to special vehicles: Yielding to ambulances, fire trucks, or other special vehicles. If caught by surveillance cameras while yielding, manual review will not record the act as running a red light. Even if recorded, you can apply for reconsideration at the traffic police department. Extreme weather: When visibility is so low that even electronic police cannot clearly see the traffic lights. The photos of the violation may be blurry, and if you mistakenly run a red light, the traffic police will not impose penalties. Emergency situations: After delivering a critically ill patient, you can present proof from the hospital or the rescued person to the traffic police for verification. If confirmed, the violation record can be cleared. If possible, it is best to call an ambulance to avoid accidents caused by running a red light. Traffic police direction: During peak hours, traffic police may temporarily direct traffic at major intersections. Drivers must follow the gestures of the traffic police.

13

1

Share

What are the common methods for detecting pavement rutting?

Common methods for detecting pavement rutting include the rutting method. Pavement measurement method: Select the cross-section to be tested for rutting, place the reference ruler on the test cross-section, with its direction perpendicular to the road centerline. Requirements for the test section: Determine the test section, which should be free of standing water, ice, snow, and contamination. Adjust the tire pressure of all test equipment to the standard pressure required by the equipment, and check whether the vehicle and test equipment are functioning properly. ③ Check the weather forecast; testing should not be conducted when the wind speed exceeds level 6. When using a laser rutting instrument to measure the rut depth of the pavement, adjustments or avoidance should be made if sunlight affects the test results.

16

5

Share

What is the fuel consumption of the 7th generation Elantra 1.5?

The 7th generation Elantra 1.5L model has a combined fuel consumption of 4.9 liters per 100 kilometers under comprehensive driving conditions. This car excels in the following aspects: 1. Exterior design. The overall body appears gentle and elegant, but the redesigned front face exudes aggressiveness. Two prominent ridges on the engine hood extend forward to a small yet protruding grille, creating a strong sense of forward motion. The redesigned wedge-shaped headlights are more sporty than the peanut-shaped ones found on the Sonata. 2. Interior design. The Elantra's interior features clean lines, with a beige color scheme that gives a fresh feel. Matte metallic trim panels on the center console and door armrests add a touch of modernity. The plastic components on the dashboard are of decent quality, avoiding a particularly cheap impression. The Elantra measures 4495mm in length, 1720mm in width, and 1425mm in height, with a wheelbase of 2610mm, which is quite outstanding in its class. The interior space is also top-tier among its peers, with notable width and ample legroom and headroom in both the front and rear seats. 3. Chassis. The Elantra employs a front MacPherson strut and rear multi-link suspension system, equipped with gas-filled shock absorbers tuned for softness, delivering first-class comfort. On regular roads, road vibrations are effectively filtered out, and cabin noise reduction is well-executed, making the overall ride comfort comparable to that of a higher-class mid-size sedan.

1

5

Share

Is Yanchang Petroleum owned by Shell?

Yanchang Petroleum is Shell. Yanchang Petroleum: The business scopes of the two are different. Yanchang Shell Petroleum Co., Ltd. mainly engages in fuel retail, convenience stores, oil change centers, etc. It is a Sino-foreign joint venture jointly funded by three shareholders: Shaanxi Yanchang Petroleum (Group) Co., Ltd., Shell (China) Co., Ltd., and Shaanxi Tianli Investment Co., Ltd. Shell: Shell Company primarily operates in upstream and downstream petroleum and chemical businesses. Yanchang Shell Petroleum is a subsidiary of Yanchang Petroleum, belonging to a Sino-foreign joint venture, while Shell is a large multinational petroleum enterprise.

11

0

Share

What are the disadvantages of shifting to P gear after turning off the engine in N gear?

The disadvantage of shifting to P gear after turning off the engine in N gear is that under this operation, the vehicle may slightly move forward or backward due to uneven road surfaces, causing some impact on the transmission gears. Over time, this may lead to loosening of the transmission gears. Here is an extended explanation about parking: 1. Generally, two gears are used for parking: one is the P gear (Parking gear), which works by using a mechanical device to lock the rotating parts of the car, preventing it from moving. When parking for a long time, it is necessary to tighten the handbrake and shift to P gear. The other is the N gear (Neutral gear), which is equivalent to the neutral gear in a manual transmission. It is usually used when waiting at a red light or temporarily parking. Of course, to prevent the vehicle from sliding, remember to step on the brake when in N gear. 2. The correct sequence for parking an automatic transmission car: First, step on the brake to stop the car—shift to N gear—pull the handbrake—shift to P gear—turn off the engine and remove the key. Simply put, first step on the brake to stop the car, then shift to N gear to park. Remember not to release the brake during this time, then pull the handbrake. At this point, you can slightly release the brake to check if the car rolls, to determine if the handbrake is tight. Step on the brake again and shift to P gear, then slightly release the brake to check. Finally, step on the brake to turn off the engine and remove the key, then release the foot brake and exit the car.

20

2

Share

Is It Allowed to Make a U-Turn When the Traffic Light Is Red?

If the U-turn signal light is red, you must wait to make a U-turn; otherwise, it will be considered running a red light. According to the "Road Traffic Safety Law," this violation incurs a penalty of 6 demerit points and a fine of 200 yuan. If there is no U-turn signal light, and the gap is marked with a dashed line, the U-turn is not affected by the traffic signal, nor does it require crossing the pedestrian crossing. However, if the gap is marked with a solid line, the U-turn must cross the pedestrian crossing and is subject to the left-turn signal light. Making a U-turn directly without following these rules may result in being photographed by traffic cameras or penalized by on-site traffic police. When making a U-turn that requires crossing a pedestrian crossing, yielding to pedestrians is mandatory: If pedestrians are walking on the right side of the crosswalk and have not reached the centerline of the road, vehicles on the left side must slow down and ensure safety before proceeding through the crosswalk. If pedestrians are waiting outside the boundary line separating motorized and non-motorized lanes and have not entered the roadway, vehicles should slow down and proceed through the crosswalk only after ensuring safety. If pedestrians have crossed the boundary line separating lanes, vehicles must stop; failing to do so is a violation and subject to penalties. If pedestrians have entered the motorized lane from the crosswalk, vehicles in the adjacent lane must slow down and proceed only after ensuring safety. Failing to yield is a violation and subject to penalties. If pedestrians are waiting at the centerline of the road without entering the motorized lane, vehicles must stop; otherwise, it is a violation. If pedestrians cross the centerline into the motorized lane, vehicles must stop; otherwise, it is a violation. If the road is divided by a green belt and pedestrians are waiting in the central area, vehicles must slow down and proceed only after ensuring safety. Scenarios where U-turns are allowed: If there is a clear U-turn sign at the intersection, a U-turn is permitted. If there is a U-turn signal light, follow its instructions. If there is no signal light, make the U-turn only if it does not interfere with other vehicles or pedestrians. If there are no explicit "No U-Turn" or "No Left Turn" signs at the intersection, a U-turn is allowed. This means that as long as there are no prohibitive signs or solid centerlines, a U-turn is permitted. U-turns are also allowed in yellow grid zones. These zones are no-stopping areas marked at intersections prone to congestion due to temporary stops. While stopping in these zones is prohibited, making a U-turn is allowed unless there is a central barrier. If there is a U-turn signal light at the intersection, follow its instructions—only proceed when the light is green. If "No Left Turn" and "U-Turn Allowed" signs appear together, U-turns are permitted, but left turns are prohibited. Note that "No U-Turn" is not the same as "No Left Turn." Precautions when making a U-turn at an intersection: Check the road markings. If they are solid lines, U-turns are prohibited under any circumstances. Continue driving to find a suitable location. If there is a "No Left Turn" sign, even if "No U-Turn" is not mentioned, U-turns are not allowed at that intersection, as U-turns inherently involve left turns. U-turns must be made from the innermost left-turn lane. If you are in the second left-turn lane, a U-turn is not permitted at that intersection. Always yield to oncoming traffic before making a U-turn. Failing to do so may result in full liability for any accidents. Near the intersection stop line, lanes often have guiding arrows. The leftmost lane is not always for left turns only; if it has a straight arrow, U-turns are prohibited even without explicit "No U-Turn" signs.

7

0

Share

What Grade of Gasoline Should a Car Use?

Does crossing the stop line when the red light turns on count as running a red light?

What are the common methods for detecting pavement rutting?

What is the fuel consumption of the 7th generation Elantra 1.5?

Is Yanchang Petroleum owned by Shell?

What are the disadvantages of shifting to P gear after turning off the engine in N gear?

Is It Allowed to Make a U-Turn When the Traffic Light Is Red?

What are the letter codes for license plates in Shandong?

Do new energy electric vehicles have a vehicle license?

How to Fix P0366 Trouble Code?

How to operate one-touch power window?