What engine is used in the Changan Eado DT?

How to Check Fuel Consumption on the 10th Generation Accord?

To check the fuel consumption on the 10th Generation Accord, you can click on the settings in the central control screen, then select the trip mileage. After setting, exit to view the fuel consumption per 100 kilometers. The fuel consumption per 100 kilometers refers to the amount of fuel consumed by the vehicle when driving a certain speed on the road for 100 kilometers. It is a value measured by the manufacturer in an objective environment using a dynamometer installed on the vehicle's chassis, converted into speed parameters, and then calculated under specified speed conditions to determine the theoretical experimental fuel consumption data per 100 kilometers for the model. Below is some related information about the 10th Generation Accord: The 10th Generation Accord is equipped with a 1.5-liter turbocharged engine and a 2.0-liter naturally aspirated engine, paired with a CVT transmission. The vehicle's dimensions are 4893mm in length, 1862mm in width, and 1449mm in height, with a wheelbase of 2830mm.

18

2

Share

How to Turn Off the Rear Wiper on Volkswagen Tayron?

To turn off the rear wiper on the Volkswagen Tayron, lift the wiper lever upward. Pressing it downward will activate the wiper. The rear wiper is designed for the rear windshield and is commonly equipped on SUVs, MPVs, hatchbacks, and some liftback vehicles. Precautions for using wipers: 1. Maintain cleanliness. Streaks on the windshield may indicate dirt on the wiper blades. Use a towel dampened with alcohol to wipe along the edge of the wiper blade to remove accumulated dirt, debris, and dead leaves. 2. Check the rubber. If the wiper produces a harsh noise while operating, the rubber may be aged or cracked. If the wear is not severe, you can sand down rough spots on the surface with sandpaper. 3. Avoid sunlight. A cool, ventilated area is ideal for long-term parking, as high temperatures can accelerate the aging of rubber materials. 4. Refill fluid. Plain water cannot replace windshield washer fluid. To ensure the longevity of the components, always use proper windshield washer solution.

9

2

Share

Why Do Traffic Police Require a B2 Driver's License to Operate a Forklift?

Traffic police require a B2 driver's license to operate a forklift because forklifts are a special type of vehicle, classified under the vehicle types approved for a B2 license. Below is additional information about the B2 driver's license: 1. Vehicle types permitted with a B2 license: According to Annex 1 of the "Regulations on the Application and Use of Motor Vehicle Driver's Licenses" (Order No. 123 of the Ministry of Public Security of the People's Republic of China), a B2 license permits the operation of heavy and medium-duty trucks, as well as heavy and medium-duty special-purpose vehicles. Other permitted vehicle types include C1, C2, C3, C4, and M. Forklifts fall under the category of wheeled self-propelled machinery (M), so a B2 license allows the operation of forklifts. 2. Requirements for applying for a B2 license: The applicant must be between 20 and 50 years old, have a height of at least 155 cm, and possess uncorrected or corrected visual acuity of 5.0 or above on the standard vision chart.

7

0

Share

What is the Chinese name for the Porsche Macan?

The Chinese name for the Porsche Macan is Maikai. The term 'Macan' originates from the Indonesian language, meaning 'tiger.' The Macan utilizes the Audi Q5 chassis and comes standard with Michelin tires. It features Porsche's signature front grille and differs from the Q5 with its hatchback design. The Porsche Macan is a mid-size SUV. The interior design of the Macan is exceptionally refined, showcasing the distinct Porsche family style, incorporating elements from the Cayenne and Panamera models. The cockpit exudes a more pure technological feel, with an optimized dashboard equipped with the latest Porsche Communication Management system, featuring a 10.9-inch high-definition display for full connectivity. The vehicle also includes an air-purifying ion filter to enhance cabin air quality. Leather seats and extensive soft-touch materials elevate the car's luxury feel. Additionally, the new model features a sporty three-spoke steering wheel, with well-equipped button functions on either side of the gearshift. The Macan's dashboard includes a clock—more accurately, a compass, a common feature in high-end vehicles—with a stopwatch function that can be used to time the Macan's 0-100 km/h acceleration. In terms of the powertrain, the Porsche Macan is equipped with a 2.0T, 3.0T V6, or 3.6T V6 engine. The 2.0-liter turbocharged engine delivers a maximum output of 235 horsepower, the 3.0-liter V6 twin-turbo engine produces 340 horsepower, and the 3.6-liter V6 twin-turbo engine generates 395 horsepower, all paired with a 7-speed dual-clutch transmission. It is reported that the latter two engines may be featured in the Macan S and Macan Turbo models in the future. The Porsche Macan comes with three Michelin tire options: the newly released Michelin Latitude Sport 3 summer tires, Michelin Latitude Alpin 2 winter tires, and Michelin Latitude Tour HP all-season tires. The introduction of the Macan fills the gap in Porsche's lineup for the mid-size SUV market.

2

4

Share

What is the matching speed for second gear?

The matching speed for second gear is generally around 20km/h. Below is relevant information about gear matching speeds: 1. Timely gear shifting: Normally, start in first gear, then shift to second gear after traveling a few meters; shift to third gear when the speed reaches above 20 mph but below 35 mph; shift to fourth gear when the speed reaches above 35 mph but below 45 mph; shift to fifth gear when the speed exceeds 45 mph. The above applies to ordinary five-speed transmission vehicles. For vehicles with six or more gears, you can upshift one gear for every approximately 15 mph increase in speed. Additionally, when shifting gears, pay attention to the engine speed and shift promptly when it reaches around 2500 rpm. 2. Gears and speed: Sometimes while driving, you may notice the vehicle shaking slightly, indicating the engine is operating under low speed and high load. Immediately downshift one or two gears based on the actual situation. 3. Coordination between clutch and throttle: When shifting gears, the clutch and throttle must be coordinated. Depress the clutch fully while simultaneously releasing the throttle pedal, then quickly shift to the corresponding gear. Release your hand immediately after shifting; do not keep it on the gear lever for too long, as this can easily damage the lever. 4. Correct gear shifting hand position: Many drivers often neglect the proper hand position for gear shifting, sometimes casually using two or three fingers to shift, which is neither standardized nor safe. The correct hand position is to cover the gear lever head with your palm facing downward, grip the lever firmly with all five fingers, and then perform the shift.

9

5

Share

What are the tire specifications and sizes for the Volkswagen Sagitar?

The Volkswagen Sagitar comes with two tire specifications: 205/55R17 and 225/45R18. In 205/55R17, the first number 205 represents the tire width of 205MM, 55 indicates the aspect ratio of the tire section is 55%, meaning the section height is 55% of the width, and 17 denotes the rim diameter of 17 inches. The letter "R" in the middle stands for radial tire. In 225/45R18, the first number 225 represents the tire width of 225MM, 45 indicates the aspect ratio of the tire section is 45%, meaning the section height is 45% of the width, and 18 denotes the rim diameter of 18 inches. The letter "R" in the middle stands for radial tire. For the entire Sagitar lineup, except for the top-tier Excellence version which features 18-inch alloy wheels, the Fly version and Beyond version come with 17-inch wheels, all in a silver-black dual-tone, faceted double five-spoke design. The Fly and Beyond versions are equipped with Dunlop ENASVE-EC300+ series tires, while the Excellence version comes with Kumho ECSTA-HS81 series tires. If you wish to replace the tires yourself, follow these steps: Retrieve the spare tire and jack, place the jack under the car frame near the tire to be replaced, ensuring the jack contacts the metal part of the frame. Raise the jack until it supports the car, making sure the jack is positioned under the vehicle and at a right angle to the ground. Remove the hub cover, loosen the nuts counterclockwise, but do not fully unscrew them—just enough to eliminate resistance. Keeping the tire on the ground when first loosening the nuts ensures that the nuts turn, not the tire. Turn the nuts counterclockwise until they are loose, repeat this step for all lug nuts, and then fully remove the nuts. Place the new tire on the rim, carefully aligning the tire rim with the wheel bolts. Install the lug nuts and hand-tighten them until all nuts are snug. The tire replacement is now complete. In addition to the model, tires are marked with the following common data: Tire cord material: Indicated by Chinese pinyin, such as M for cotton cord, R for rayon cord, N for nylon cord, G for steel cord, and ZG for steel radial cord tires. Speed rating: Indicates the maximum speed at which the tire can carry a specified load under defined conditions. Letters A to Z represent certified speed ratings from 4.8km/h to 300km/h. Common speed ratings include: Q: 160km/h; H: 210km/h; V: 240km/h; W: 270km/h; Y: 300km/h. Rim specification: Indicates the rim size compatible with the tire for practical use, such as "Standard Rim 5.00F".

8

4

Share

What engine is used in the Changan Eado DT?

How to Check Fuel Consumption on the 10th Generation Accord?

How to Turn Off the Rear Wiper on Volkswagen Tayron?

Why Do Traffic Police Require a B2 Driver's License to Operate a Forklift?

What is the Chinese name for the Porsche Macan?

What is the matching speed for second gear?

What are the tire specifications and sizes for the Volkswagen Sagitar?

How to Calculate Motorcycle Fuel Consumption?

What to Do If a Traffic Violation Is Wrongly Attributed to Me?

Does ETC need to be kept on all the time?

Which is more prone to carbon buildup, multi-point fuel injection or direct injection?