What engine does the Toyota Vellfire use?

1 Answers
FrankAnn
07/28/25 5:03pm
Toyota Vellfire is equipped with a 2.5L engine with a maximum power of 117 horsepower, and also comes with an electric motor that delivers a maximum power of 211 horsepower. The Toyota Vellfire is a luxury MPV imported from Japan by FAW Toyota, serving as the twin model of the Alphard Hybrid, introduced to the domestic market by FAW Toyota. The two models differ mainly in the design of the front face and rear styling. The exterior design of the Toyota Vellfire is highly consistent with the Japanese domestic Vellfire, featuring a split-type dual headlight design paired with large-area chrome accents, exuding both high-end quality and a bold presence.
Was this review help?
18
1
Share
More Forum Discussions

Where is the turn signal fuse of Vios located?

Vios turn signal fuse is located in the fuse box in the front engine compartment. The turn signal is an important indicator light that is turned on when the vehicle is turning to alert vehicles and pedestrians around. The turn signal bulb uses a xenon tube, and the microcontroller controls the circuit to make it flash alternately left and right without interruption. Here is more information about car lights: 1. Headlights: The combination headlights are located at the front of the car, mainly serving the purpose of illumination and signaling. The light emitted by the headlights can illuminate the road ahead, allowing the driver to drive safely at night. 2. Taillights: The combination taillights are located at the rear of the car, mainly serving the purpose of illumination and signaling. 3. Turn signals: Used to indicate left or right turns to other road users. Regulations require them to be amber in color. 4. License plate light: The license plate light mainly illuminates the license plate, making it easier for people to identify the vehicle's license plate at night.
15
3
Share

Does a Cracked Steering Ball Joint Rubber Have an Impact?

Steering ball joint rubber cracking has an impact because the steering ball joint contains grease inside. Once the rubber cracks, the grease will leak out. Without lubrication, the steering ball joint will be damaged, leading to steering failure. Symptoms of a damaged steering ball joint in a car include: The car will produce a rattling noise when driving on bumpy roads; noticeable wheel vibrations can be felt at low speeds; the car will become unstable during driving, swaying left and right or pulling to one side. In severe cases, it may even cause brake failure; and if the clearance of the ball joint is too large, it is prone to breakage under impact loads. Replacement cycle for steering ball joints: There is no fixed replacement cycle for car ball joints—they only need to be replaced when damaged. The lifespan of a ball joint is generally determined by road conditions. It is usually inspected every 80,000 kilometers and replaced every 100,000 kilometers under normal conditions. However, if the car frequently drives on rough roads, the lifespan of the ball joint will be relatively shorter, and damage may occur within 30,000 to 40,000 kilometers.
17
2
Share

How Long is BMW's Warranty Period?

BMW offers a warranty period of 2 years or 50,000 kilometers with a valid three-guarantee certificate. The vehicle repair warranty period is 3 years or 100,000 kilometers. Here is more information about the warranty: 1. Calculation of the warranty period: The warranty period starts from the date when the BMW authorized sales service center issues the vehicle purchase invoice to the first user and ends on the day the warranty period expires. 2. High-voltage battery: From the sales date (based on the vehicle sales invoice date), BMW provides an 8-year or 120,000-kilometer warranty for the high-voltage battery. 3. Plug-in hybrid vehicles enjoy an 8-year or 120,000-kilometer warranty for the high-voltage battery.
8
4
Share

What is the M gear?

M gear refers to a gear position in modern cars equipped with a manual-automatic transmission. The following are specific explanations about the uses of M gear: 1. Downshifting for overtaking. When overtaking in D gear, the vehicle speed does not increase rapidly by pressing the accelerator hard, and you can only upshift sequentially to overtake. However, switching to M gear is different. At this time, pressing the accelerator allows the vehicle to utilize the high torque of a lower gear to accelerate instantly, completing the overtaking action more quickly. 2. Descending slopes. When going down a long slope in automatic mode, the vehicle speed will uncontrollably increase, and you can only brake appropriately while coasting. But if you engage the manual mode while descending and pull the gear lever backward to downshift to a lower gear, you can fully utilize engine braking to reduce speed. When reaching the bottom of the slope, you can quickly upshift or switch back to automatic mode, resuming normal driving promptly. 3. Ascending slopes. When climbing a steep slope, the car may get stuck on the slope, moving and stopping frequently. In this situation, you should use the manual mode of the manual-automatic transmission to limit the gear to 1st gear, making it easier to handle frequent hill starts. This operation also protects the transmission.
16
4
Share

What is the fuel tank capacity of the T-Roc?

The Volkswagen T-Roc currently has 8 models on sale. The four-wheel-drive version has a fuel tank capacity of 56L, the two-wheel-drive R-Line version has a capacity of 50L, and other two-wheel-drive versions have a capacity of 51L. These figures are officially released data, and owners who have purchased the Volkswagen T-Roc can also check them on the vehicle's configuration sheet. The recommended fuel grade for the Volkswagen T-Roc is 95 octane. The four-wheel-drive version has a fuel consumption of 7L per 100 kilometers, allowing a range of 800KM on a full tank. The two-wheel-drive R-Line version consumes 5.9L per 100 kilometers, with a range of 847KM on a full tank. Other two-wheel-drive versions also consume 5.9L per 100 kilometers, providing a range of 864KM on a full tank. During daily driving, it's important to monitor the remaining fuel level. This is typically done by observing the fuel gauge inside the vehicle. If there are no other issues, the fuel level will be accurately reflected on the gauge. The fuel gauge usually has 5 to 6 segments, and it's advisable to refuel when only 2 segments remain to avoid running out of fuel mid-journey. During actual refueling, the amount of fuel may exceed the marked capacity. This is because the manufacturer's specified fuel tank capacity is measured from the bottom of the tank to the safe fill level, with additional space from the safe fill level to the tank opening. This extra space allows for fuel expansion when temperatures rise, preventing overflow. If fuel is filled up to the tank opening during refueling, the actual amount of fuel added may exceed the marked capacity.
7
5
Share

What are the contents of the four subjects for obtaining a driver's license?

1. Subject 1: Theoretical test. The test content includes traffic rules knowledge, road sign recognition, safe driving guidelines, etc. 2. Subject 2: Field test. The test items include right-angle turns, S-curves, parallel parking, hill starts, and reverse parking. 3. Subject 3: Simulated actual road driving test. The main items include light usage, gear shifting, correct responses to various road conditions, lane changes, etc., ending with pulling over to park. 4. Subject 4: Theoretical test. Mainly focuses on traffic rules during driving.
2
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.