What engine does the Soueast V3 Lingyue use?

1 Answers
RafaelLee
07/29/25 8:32pm
The Soueast V3 Lingyue is equipped with a 1.5-liter naturally aspirated engine, with a maximum power output of 88kW and a maximum torque of 143N·m. The engine's performance is average, but it is sufficient for urban commuting. Below are the relevant details about the Soueast V3 Lingyue: 1. In terms of body dimensions, the V3 Lingyue measures 4420*1700*1415mm in length, width, and height. For tire size, the V3 Lingyue uses 185/60-R15 tires. 2. The V3 Lingyue comes standard with a 1.5-liter naturally aspirated engine, delivering a maximum horsepower of 120. Transmission options include a 5-speed manual and a 6-speed AMT. The front suspension is a MacPherson strut independent suspension, while the rear suspension is a multi-link independent suspension.
Was this review help?
3
5
Share
More Forum Discussions

What are the functions of the Passat GTE buttons?

Passat GTE mode is the sport mode switch key for plug-in hybrid vehicles. In this mode, the car has stronger power while maintaining certain fuel efficiency. GTE is a suffix set by Volkswagen for its plug-in hybrid vehicle models. Most GTE models under Volkswagen are plug-in hybrid vehicles. Precautions for using Passat GTE vehicles: 1. Proper operation: The key to driving a Passat dual-clutch automatic transmission is the driver's proper operation. Adjust to a proper sitting posture before driving. 2. Faster start: When the vehicle needs to start, to achieve a faster start, appropriately add some throttle after releasing the brake. If the vehicle requires low-speed high torque, the gear can be switched to manual mode. 3. In case of failure: If the vehicle needs to be towed due to a malfunction, the power should be cut off.
4
0
Share

How Often Should Clutch Fluid Be Replaced?

Clutch fluid should be replaced every 40,000 to 60,000 kilometers. For most vehicles, the clutch fluid is the same as the brake fluid, and both are stored in the same reservoir. Therefore, replacing the clutch fluid is essentially the same as replacing the brake fluid. It is recommended to change it every two to three years or every 40,000 to 60,000 kilometers, whichever comes first. The clutch is located within the flywheel housing between the engine and the transmission. The clutch assembly is secured to the rear plane of the flywheel with screws, and the output shaft of the clutch is the input shaft of the transmission. During driving, the driver can press or release the clutch pedal as needed to temporarily disconnect or gradually engage the engine and transmission, thereby cutting off or transmitting the power from the engine to the transmission.
5
4
Share

What content does the Bora instrument panel switch display?

The Bora instrument panel switch displays content such as the outside temperature gauge, cruise control digits, and passenger seat display. Below are specific details about the Bora:1. Exterior: The design was inspired by the traditional Chinese lion dance. Viewed from a 45-degree angle at the front, the 2011 Bora model differs slightly from the Bora Classic, appearing more grand and imposing.2. Powertrain: It is equipped with the EA111 series 1.4TSI turbocharged engine produced by FAW-Volkswagen's Dalian Engine Plant. The Volkswagen 1.4TSI engine delivers a maximum power of 96 kW at 5000 rpm and sustains a peak torque of 220 Nm between 1750-3500 rpm, with an output power that even surpasses that of a conventional 2.0L naturally aspirated engine.
9
5
Share

Are Steering Wheel Covers Universally Compatible for Sedans?

Steering wheel covers for sedans are not universally compatible due to the following reasons: 1. The size and thickness of steering wheels vary across different car models; 2. Steering wheels can have four, three, or two spokes. The functions of a steering wheel cover include: 1. Decorating the vehicle and reducing wear on the steering wheel; 2. Enhancing grip and friction to prevent slipping due to sweaty hands, thereby improving responsiveness and safety while driving; 3. Reducing and absorbing vibrations. The installation method for a steering wheel cover is as follows: 1. Place the top end of the steering wheel cover at the top of the steering wheel, press down on the upper part of the steering wheel, and gradually pull it tight towards either side of the lower part of the steering wheel with both hands; 2. Once the bottom part of the steering wheel is securely installed, adjust it to a firm and non-slip position.
16
1
Share

What is the reason why the Sagitar remote control cannot raise and lower the windows with one click?

It is a problem with the window regulator, a fault in the lifting switch and circuit, or damage to the regulator itself. The relevant explanations are as follows: 1. Introduction: If the window is completely inoperable, it may be a switch failure. If it is a switch failure, it can only be replaced. 2. Core component: The core component of the power window is the window regulator. For car window lifting issues, the reason for the power window switch's unsteady operation is often the depletion of oil in the door's internal lifter. The inner cover should be removed and oil added. If the electronic device is not working, checking the fuse is common knowledge, and a thorough inspection of the fuse used for the power window is necessary.
15
2
Share

How to Check China 5 and China 6 Emission Standards?

Methods to check China 5 and China 6 emission standards include: 1. Check the vehicle's environmental protection label; 2. Log in to the website of the Motor Vehicle Exhaust Pollution Supervision and Management Center for inquiry; 3. Check the vehicle's factory certificate; 4. Make a rough judgment based on the year the vehicle was registered; 5. Bring the original or a copy of the motor vehicle registration certificate to the vehicle management office for inquiry. China 5 and China 6 refer to the national standards for vehicle exhaust emissions. The larger the number, the more environmentally friendly the vehicle's exhaust is, the later the standard was issued, and the stricter the requirements for energy conservation and emission reduction in vehicles. Emission standards impose strict limits on nitrogen oxides, hydrocarbons, carbon monoxide, and particulate matter in vehicle emissions, aiming to reduce and prevent environmental pollution caused by vehicle exhaust, protect the ecological environment, and ensure human health.
9
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.