What engine does the Lynk & Co 03 use?

How to Judge Distance When Turning a Car?

There are several methods to judge the distance when turning a car: 1. On roads other than cities and highways, to judge the distance between the right wheel and the roadside, look diagonally from the center line of the car hood. If this center line reaches the roadside line, it means the right wheel is at least 30 centimeters away from the roadside line. Exceeding this range may mean going beyond the roadside line. 2. To judge the distance from obstacles on the right, look out from the right side of the car hood. If you can see a very low position, it means you are still far from the obstacle. If you can only see a high position, it means you are very close to the obstacle and need to be cautious. 3. Pay attention to the rear of the vehicle in front while driving. When you can no longer see the entire rear of the vehicle in front, it means you are very close, so avoid getting too close to the vehicle ahead. Generally, when stopping at a red light, maintain a distance of half a car length from the vehicle in front.

14

4

Share

How High is the Trunk Temperature in Summer?

In summer, the trunk temperature can reach over 60 degrees Celsius. However, generally, the interior temperature of the car is higher than that of the trunk. The following are the reasons for the high temperature inside the car in summer: 1. Transparent Windshield: Relatively speaking, the temperature in the cabin is higher than that in the trunk during summer because the front windshield of the cabin is almost transparent. 2. Easy Radiation Entry: External sunlight and radiation easily enter the car, so the temperature in the cabin rises faster than in the trunk. 3. Prolonged Exposure to Sunlight: If the car is exposed to the scorching sun for a long time, whether it's the cabin or the trunk, the entire interior temperature will become extremely high, and the flow of hot air inside will make the temperature uniform everywhere. It is also closely related to the conditions under which the car is parked.

12

3

Share

What is the following distance when visibility is 200 meters in foggy weather?

When visibility on the highway is less than 200 meters, maintain a distance of more than 100 meters from the vehicle ahead in the same lane. The speed should not exceed 60 kilometers per hour, and fog lights, low beams, position lights, and front and rear position lights should be turned on. Here is some additional information: 1. Less than 100 meters: When visibility is less than 100 meters, turn on fog lights, low beams, position lights, front and rear position lights, and hazard warning flashers. The speed should not exceed 40 kilometers per hour, and maintain a distance of more than 50 meters from the vehicle ahead in the same lane. 2. Less than 50 meters: When visibility is less than 50 meters, turn on fog lights, low beams, position lights, front and rear position lights, and hazard warning flashers. The speed should not exceed 20 kilometers per hour, and exit the highway as soon as possible from the nearest exit.

1

Share

What Causes the Car to Roll Backward When Reversing into a Parking Space?

Here are the specific reasons for the car rolling backward when reversing into a parking space: 1. Stalling on a slope: The car stalls during a hill start, and if the brake is not pressed in time after stalling, the car will roll backward. 2. Poor coordination: Inadequate coordination between the clutch and the brake, releasing the brake before the car has enough starting power is another reason for the car rolling backward. Below are some extended tips to prevent the car from rolling backward when reversing into a parking space: 1. Clutch: The clutch should be pressed quickly and released slowly. Before starting, slowly lift the clutch until it reaches the semi-engaged state, then stop lifting and maintain this state. 2. Brake: When the clutch reaches the semi-engaged state and the car shakes noticeably, gently release the brake. Once the car starts moving, fully release the brake. Whether pressing or releasing the brake, it should be done slowly, as pressing the brake abruptly can easily cause the car to stall.

16

3

Share

How to use the ACC adaptive cruise control in the Tharu?

The method to use the ACC adaptive cruise control in the Tharu is as follows: 1. The cruise control buttons are located on the left side of the multifunction steering wheel, and you can also set a safe distance from the vehicle ahead. 2. Press the cruise control button, and the dashboard indicator will light up, indicating that the cruise control is in standby mode. 3. Adjust the desired speed and press the SET button, then release the accelerator pedal. The vehicle will maintain the set speed. To decrease the speed, press the SET button to reduce the speed by 5 km/h. To increase the speed, press the RES button to raise the speed by 5 km/h. 4. For quick acceleration or deceleration, press the + or - buttons to adjust the speed by 10 km/h. Press the button between the + and - buttons to adjust the distance from the vehicle ahead, with five adjustable levels. 5. To temporarily deactivate the cruise control, step on the brake pedal. Press the RES button to resume cruise control. To completely turn off the cruise control, press the cruise control switch again.

20

0

Share

What Causes Loud Wiper Noise?

When the wiper blades scrape loudly and feel dry, it is usually caused by aging rubber strips, requiring replacement of new wiper blades. Most cases of squeaky wipers with poor cleaning performance result from worn and roughened rubber strips, which generate abnormal noises during operation or fail to completely remove rainwater, making it difficult to see clearly while driving in rainy weather. Below are precautions for daily wiper usage: 1. Maintain proper moisture when using wipers daily: Ensure the rubber wiper strips retain adequate moisture during regular use. Only with sufficient moisture can they maintain excellent flexibility and tight contact with the windshield. Insufficient moisture on the windshield during dry wiping may produce counterproductive results. 2. Wait until more raindrops accumulate before activating wipers: If raindrops accumulate slowly without obstructing visibility, it's best to delay wiper activation until more droplets gather. When using wipers in light rain, always spray windshield washer fluid first to ensure adequate moisture for lubricating the wiper blades.

1

2

Share

What engine does the Lynk & Co 03 use?

How to Judge Distance When Turning a Car?

How High is the Trunk Temperature in Summer?

What is the following distance when visibility is 200 meters in foggy weather?

What Causes the Car to Roll Backward When Reversing into a Parking Space?

How to use the ACC adaptive cruise control in the Tharu?

What Causes Loud Wiper Noise?

How are SN oil grades classified?

What is the method for cleaning car fabric seats?

What is the minimum speed in 3rd gear?

Can You Get the Green Book When Financing a Car Purchase?