What does the wrench indicator light on the car dashboard mean?

1 Answers
Zoey
07/30/25 4:09am
The wrench indicator light on the car dashboard means: The car has reached the maintenance interval and it's time to go to the 4S shop for maintenance. After maintenance, this indicator will disappear. If the "small wrench" still appears after normal vehicle maintenance, you can manually eliminate the "small wrench" indicator by following these steps: 1. Insert the key, but do not turn it. 2. Hold down the operating rod next to the odometer for 5-10 seconds, then turn on the power. 3. After another 5-10 seconds, start the car. Keep holding the operating rod throughout this process without releasing it. Generally, following the above steps will clear the small wrench indicator. If it doesn't clear, repeat the same process a few more times.
Was this review help?
7
5
Share
More Forum Discussions

What to Do When the Car Battery Dies Because the Lights Were Left On?

If the car battery suddenly dies, you should contact a rescue vehicle to connect jumper cables and temporarily charge the battery to start the engine. Connect the positive terminal of the dead battery to the positive terminal of the rescue vehicle's battery, then connect the negative terminal of the rescue vehicle's battery to a metal part of the stalled car. After connecting the jumper cables, start the rescue vehicle's engine and slightly increase the RPM. After about 5 minutes, the dead battery will receive an emergency charge. If no tools are available, the simplest method is to push-start the car. Ensure the battery still has some residual charge.
14
0
Share

How to Remedy Bird Droppings Corrosion and Paint Cracking?

Use a wet wipe or a damp cloth, add a few drops of water to the dried bird droppings, wait for it to soften, and then wipe it off. Cover the bird droppings with a wet wipe or a small damp cloth. After two minutes, gently wipe off the bird droppings with a wet wipe or a small damp cloth. Be careful not to apply too much force. Do not let bird droppings stay on the car for too long, as they have a corrosive effect and can damage the car paint. Do not use a knife to scrape the droppings, as it will not only fail to clean them properly but also easily damage the car's surface, remove the paint, and require repairs, which is both unsightly and costly.
10
1
Share

How to Check the Score of Subject 2 Exam?

To check the Subject 2 exam score, you can enter the homepage of the [Traffic Safety Comprehensive Service Management Platform]; select the province where the candidate is located. Go to the [Personal Login] page - enter the username (usually the ID number) and password (if forgotten, you can reset it via mobile verification) to log in. After entering [My Homepage], the [Student Information] will be displayed below. Find the left menu "My Homepage" and enter; locate "Exam Information" in the student interface. Under the [Exam Information] section of the student information, the scores for each subject exam will be displayed.
10
4
Share

What is the clever trick for siphoning gas from a car?

It's best to use a white soft hose, and the inside of the tube should be clean without any debris. If the tube is dirty, it needs to be cleaned and dried. Insert one end of the tube into the car's fuel tank. Cover the end of the hose inserted into the fuel tank with your hand, place the clean other end in your mouth, and then suck hard. You will see the fuel slowly coming out of the fuel tank. Slowly bend down and place the fuel hose into a prepared fuel container. The fuel will then flow continuously into the container.
18
1
Share

How to reset the maintenance wrench on JMC Kairun?

While turning the key, press the brake pedal and accelerator pedal all the way down, then rotate the ignition key to the second position. Then press and hold the small trip reset button on the right side of the instrument panel for 2-3 seconds, while simultaneously pressing the accelerator pedal and brake pedal, and wait for about 15 seconds. After the maintenance light on the instrument panel starts flashing, release the accelerator pedal and brake pedal, turn off the ignition switch, and the maintenance light reset is complete.
1
3
Share

How to Obtain the 6-Year Inspection Exemption Label for Motorcycles?

First, log in to the "Comprehensive Traffic Safety Service Management Platform," click on "Apply for Inspection Exemption Label," and you can apply online for the inspection exemption label for your registered motorcycle. Read the "Service Instructions," which include the conditions for applying for the inspection exemption label and other important notes, check the box for "Read and Agree," and click "Next." If the compulsory traffic insurance and vehicle and vessel tax are not connected online or verification fails, users need to submit photos of the compulsory traffic insurance certificate and vehicle and vessel tax certificate, then click "Next." Confirm your vehicle information, collection details, and the fees required, click "Get Verification Code," and enter the mobile verification code. The system will generate a service serial number. After payment, the traffic management department will process the application within one working day, and you will receive an SMS notification with the processing result.
16
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.