What Does the Three-Year or 100,000-Kilometer Vehicle Warranty Cover?

1 Answers
McRafael
07/28/25 9:16pm
The three-year or 100,000-kilometer vehicle warranty primarily covers the core components of the vehicle, which include the engine, chassis, transmission, and drivetrain. The vehicle warranty means that the manufacturer will replace faulty parts free of charge if they are confirmed to be defective due to quality issues rather than human damage, provided the replacement occurs within the warranty period or the specified mileage limit. The warranty does not apply under the following circumstances: 1. Failure to follow the manufacturer's requirements for regular maintenance at designated 4S shops or authorized service stations; 2. Unauthorized modifications to the vehicle or changes to its intended use; 3. Damage caused by improper use or traffic accidents.
Was this review help?
4
0
Share
More Forum Discussions

What grade of gasoline should the Jetta VS5 use?

Jetta VS5 uses 95-octane gasoline. More information about 95-octane gasoline and car refueling is as follows: 1. 95-octane gasoline consists of 95% isooctane and 5% n-heptane. When the engine compression ratio is high, high-octane gasoline should be used. If low-octane gasoline is used in a high-compression ratio engine, it may cause abnormal phenomena. Nowadays, high-compression ratio engines can also use lower-grade gasoline, but you should not blindly choose gasoline based on the compression ratio. Instead, follow the manufacturer's recommendations for refueling. 2. The fuel tank capacity of the Jetta VS5 is 51 liters. When refueling, it is recommended not to overfill the tank. Additionally, try to choose large, reputable gas stations for refueling and avoid using substandard fuel to save money.
8
5
Share

What causes the engine warning light to sometimes turn on and sometimes off?

When the engine warning light flashes, it indicates a fault in the engine, which is relatively serious and requires immediate inspection. The specific reasons may include the following seven: Sensor malfunction: The sensors referred to here include those for coolant temperature, crankshaft position, air flow, intake temperature, oxygen, etc. When these sensors are damaged, have poor contact, or experience signal interruption, the vehicle's ECU cannot accurately obtain engine data, triggering the engine warning light. Fuel or oil quality issues: If fuel or engine oil is not added according to the manufacturer's requirements, it may cause engine wear, leading to the warning light turning on. Poor combustion of the air-fuel mixture: Poor combustion can cause engine carbon buildup or knocking. When detected by the oxygen sensor and reported to the ECU, the warning light will illuminate as a warning. Issues such as spark plug failure, ignition coil failure, fuel pump failure, or fuel line blockage can all lead to poor combustion of the air-fuel mixture. Turbocharger issues: The intake boost pipe or turbocharger can also cause the engine warning light to turn on. The most common issue is turbocharger damage, accompanied by symptoms like oil leaks, high oil consumption, reduced power, metallic noises, or blue/black smoke from the exhaust. Intake problems: If there is an issue with the vehicle's intake, it may lead to engine pipe blockage, which in severe cases can trigger the engine warning light. A dirty air filter that hasn't been cleaned regularly can cause intake problems. Exhaust problems: Exhaust faults can also cause the engine warning light to turn on. Common causes include faults in the rear oxygen sensor, catalytic converter, exhaust camshaft, or bearings, with the catalytic converter being the most frequent issue. Using leaded gasoline, lead- or silicon-based lubricant additives, physical damage to the catalytic converter, or fuel system faults can easily lead to catalytic converter failure. Anti-theft system malfunction: If the vehicle's electronic anti-theft system fails or if the anti-theft controller does not match the engine electronic controller, the anti-theft system can prevent the engine from operating normally, while also triggering the engine warning light. Generally, the engine warning light can display four scenarios: steady yellow light, flashing yellow light, steady red light, or flashing red light. The severity of the fault increases from steady to flashing and from yellow to red. In order of severity: flashing red > flashing yellow/red > steady red > steady yellow/red. If the engine warning light turns on, follow these steps: First, check whether the engine is running normally, such as if there is shaking or black smoke. If so, avoid restarting the engine. Note: Do not restart the engine if the red light is on. If the engine can be started, turn it off for 5-10 minutes, then without pressing the brake, press the start button once or turn the key halfway to the 'ON' position without pressing the clutch. The vehicle will perform a self-check after powering on. Wait 5-10 seconds to see if the warning light turns off. If the warning light remains on, visit a service station as soon as possible. The service station can use a portable diagnostic tool to read the fault code, identify the issue, and perform targeted repairs.
11
3
Share

How to use the air conditioning in Roewe 750?

The usage method of the Roewe 750 air conditioning is as follows: 1. After starting the vehicle engine, click the OFF button on the central control panel to turn on the air conditioning. 2. After turning on the air conditioning, click the AC button on the air conditioning to enter the cooling mode, then adjust the appropriate temperature and air volume to start cooling. 3. If you want to turn on the heating mode, there is no need to press the AC button; simply increase the temperature and adjust the air volume to start heating. Additionally, when using the air conditioning in summer, be careful not to immediately activate the internal circulation after entering the car. Because the temperature inside the car is higher than the outside temperature, this would actually reduce the cooling effect. When you first enter the car, you should open the windows for ventilation and turn on the external circulation to expel the hot air. After the temperature inside the car has dropped, you can then switch to internal circulation.
1
3
Share

What is the procedure for resetting the maintenance reminder light on the Changan CS75?

The steps to reset the maintenance reminder light on the Changan CS75 are as follows: 1. Turn the ignition switch to the "ON" position to power up the entire vehicle; 2. Press the "Select" button on the left side of the steering wheel; 3. Then press and hold the "Reset" button for approximately 5 seconds; 4. While continuing to hold the "Reset" button, turn off the vehicle's power and then turn it back on; 5. This will clear the maintenance reminder light. Significance of resetting the maintenance light: Although the maintenance light is not directly related to the vehicle's performance, it is essential to reset it after maintenance. Otherwise, the owner won't be able to accurately track the usage time of new parts during the next replacement.
15
5
Share

How often should the Kuga's tires be replaced?

The replacement interval for Kuga tires is approximately 40,000-60,000 kilometers or 3-5 years. Since tire wear is influenced by driving habits and road conditions, the actual replacement time may vary from these mileage or time benchmarks. Replacement should be based on the actual condition of the tires. Additionally, tires should be replaced immediately regardless of mileage or warranty status if they show signs of aging such as small cracks, wear beyond the tread wear indicators (when tread depth is less than 1.6mm), tread cracks, tread bulges, missing rubber sections, uneven wear, chemical corrosion, or if the tire has been punctured by foreign objects multiple times.
1
4
Share

What Causes the Battery to Heat Up During Charging?

The reasons for the battery heating up during charging include issues with the battery itself, battery aging, and increased internal resistance leading to heat generation. Reasons for heating up: As the battery is used more frequently, water molecules within the battery gradually deplete, resulting in battery gassing and water loss, which causes the battery to heat up during electrochemical reactions. Additionally, during the charging and discharging process, the battery solution forms sulfuric acid crystals and deposits that stick to the lead plates, increasing the battery's resistance and generating heat. Charging in high-temperature environments, such as under direct sunlight, where the ambient temperature is already high, can cause the battery and charger to heat up further due to solar exposure. Combined with the heat generated during charging itself, this leads to the battery becoming hot. Replacing the battery: Issues like battery aging and increased internal resistance can be addressed through technical measures such as adding water, desulfation, and depolarization. However, if the battery heats up due to short circuits or broken plates, it is best to replace it with a new one. Batteries used for more than two years should be checked regularly. Generally, the lifespan of a car battery is 2 to 3 years, while the original battery in a new car can last more than 3 years.
4
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.