What does the small wrench on the car screen mean?

Can Used Engine Oil Prevent Rust When Applied to Iron?

Yes, it can. Engine oil inherently possesses lubricating, anti-friction, and corrosion-resistant properties. However, the effect is not long-lasting as the oil will eventually evaporate. Below is additional information: 1. Introduction to Engine Oil: Engine oil, also known as motor oil or engine lubricant, is a substance enhanced with additives in base oil, primarily containing anti-wear additives, detergents, dispersants, and multi-grade viscosity index improvers. Engine oil is used for lubricating internal combustion engines. 2. Main Functions: The primary functions of engine oil are to reduce friction and wear on moving parts, and to remove sludge (one of the functions of dispersants) and varnish (detergents) from the engine. It also neutralizes acids produced from fuel and lubricant oxidation (detergents), improves piston ring sealing, and cools the engine by carrying away heat from moving components.

2

Share

Wheel Size of Volkswagen Santana?

Santana's original wheel sizes are 175/65 R14 and 185/60 R15. It can be modified to 16 or 17-inch wheels. Installing larger wheels increases the contact area with the ground, which raises fuel consumption but enhances driving stability. The differences between steel wheels and alloy wheels are as follows: 1. Manufacturing Process: The main advantage of steel wheels is their simple manufacturing process, typically using casting techniques. For example, alloy wheels are usually produced using low-pressure casting, which is relatively low-cost and offers strong resistance to metal fatigue. 2. Weight: Steel wheels are significantly heavier than alloy wheels of the same size, resulting in greater inertial resistance, poorer heat dissipation, and a tendency to rust. Alloy wheels are lighter, have lower inertial resistance, higher manufacturing precision, and less deformation at high speeds, which improves straight-line driving performance, reduces tire rolling resistance, and thereby decreases fuel consumption. 3. Thermal Conductivity: Alloy materials have about three times the thermal conductivity of steel, providing better heat dissipation. This benefits the vehicle's braking system and reduces heat degradation in both tires and the braking system.

4

Share

What Causes the Yellow ABS Light to Illuminate?

ABS light illumination can occur in various states, each with different fault causes and corresponding solutions, as detailed below: State 1: ABS warning light remains constantly lit (most common). Cause 1: The ABS wheel speed sensor's sensing area is covered by mud, sludge, or other contaminants, affecting its ability to detect the corresponding wheel speed signal. This prevents the ABS control module from determining the vehicle speed or wheel slip rate, thus failing to issue appropriate commands to regulate braking. Solution: Clean the dirt from the wheel speed sensor and adjust the gap between the sensor and the tone ring to restore normal operation. Cause 2: Poor signal transmission due to loose system wiring connections or faulty ABS relay contacts, leading to system malfunction. Solution: Inspect wiring connections and reconnect any loose terminals. State 2: ABS warning light intermittently illuminates but turns off during acceleration. Cause: When multiple vehicle electrical devices are in use, the battery voltage drops below 10.5V. As engine speed increases, voltage rises, causing the ABS light to extinguish. This may also indicate insufficient power supply voltage to the ABS system, such as poor terminal contact or grounding issues. Solution: Check battery specific gravity; inspect charging system; examine power supply components (e.g., voltage relay or poor power contact). State 3: ABS warning light remains illuminated after engine start until engine IGFF (ignition off). Cause: Poor grounding connection of ABS hydraulic valve body; faulty wiring connector of ABS hydraulic valve body; ABS control module failure. Solution: Loosen and retighten the hydraulic valve body ground screw, cleaning contact surfaces if necessary; check for enlarged connector gaps; replace ABS or ABS/ASR control module. State 4: ABS warning light illuminates during high-speed driving. Cause: During high-speed operation, the ABS control module detects excessive difference between rear and front wheel speed signals; incorrect tire or wheel rim specifications. Solution: Refer to vehicle's tire and wheel rim specifications as indicated on the fuel filler cap label. State 5: ABS warning light intermittently illuminates. Cause: Improper brake light switch adjustment; internal contact failure in brake lights. Solution: With engine running, depress brake pedal and manually push the brake switch linkage downward to its limit, then release pedal to complete self-positioning; replace brake light switch if necessary. When the ABS warning light is illuminated, continued driving is not recommended. An active ABS light indicates malfunction in the anti-lock braking system. During emergency braking, wheel lock-up may occur, causing loss of vehicle control and skidding. This significantly compromises the driver's ability to decelerate or adjust vehicle trajectory, posing substantial safety risks.

13

0

Share

What does the serv warning light mean?

"serv" is the abbreviation of the English word "service", meaning service. The "service" reminder is set by the manufacturer to remind car owners to perform maintenance at specified mileage intervals as needed. After maintenance is completed, the maintenance reminder light needs to be reset following a certain procedure before it can be turned off. Below is relevant information about car maintenance: 1. Purpose of maintenance: To keep the vehicle clean and in normal technical condition, eliminate potential hazards, prevent faults, slow down the deterioration process, and extend the service life. 2. Maintenance scope: Engine system, transmission system, air conditioning system, cooling system, fuel system, power steering system. Different vehicles have different maintenance cycles, generally ranging from 5,000 kilometers to 10,000 kilometers. 3. Precautions: Tire pressure should not be too high or too low, as it affects driving safety. Check for tire cracks and replace them in time if safety hazards exist. If fuel supply is found to be insufficient, check whether the fuel filter is clogged. Regularly clean the crankcase to keep the engine interior clean.

5

4

Share

Which Vehicle Has the Right of Way When Meeting on a Narrow Slope?

On a narrow slope, the vehicle going uphill has the right of way. Relevant legal provisions: Article 48 of the "Regulations for the Implementation of the Road Traffic Safety Law": On a narrow slope, the vehicle going uphill has the right of way; however, if the vehicle going downhill has already reached the middle of the slope while the vehicle going uphill has not yet started the ascent, the vehicle going downhill has the right of way. Reasons for uphill vehicles having the right of way: Because the uphill vehicle must overcome the resistance of the slope, it needs to increase the throttle to make the engine produce more power and traction. Generally, it must complete the climbing process in one go. If it slows down or stops midway, it will increase the difficulty and may even cause the vehicle to roll backward, leading to an accident.

9

0

Share

Is it okay to leave the air conditioning on all night in a new energy vehicle?

It is not recommended to leave the air conditioning on all night in a new energy vehicle, as it may cause damage to the engine. Causes carbon buildup in the engine: Leaving the air conditioning on all night can lead to carbon buildup in the engine because the fuel does not burn completely when the engine is idling. Causes carbon monoxide accumulation in the vehicle: At the same time, since the vehicle is not moving, it will produce a large amount of carbon monoxide. The generated carbon monoxide gradually accumulates around the bottom of the vehicle, increasing in concentration. Eventually, a certain amount will enter the vehicle through the air circulation system. Carbon monoxide is highly toxic, and even a small amount can be fatal. Therefore, even if you are outdoors and using the internal air circulation (in fact, even with the internal circulation on all night, some air exchange with the outside will still occur), the risk of poisoning is very high.

9

0

Share

What does the small wrench on the car screen mean?

Can Used Engine Oil Prevent Rust When Applied to Iron?

Wheel Size of Volkswagen Santana?

What Causes the Yellow ABS Light to Illuminate?

What does the serv warning light mean?

Which Vehicle Has the Right of Way When Meeting on a Narrow Slope?

Is it okay to leave the air conditioning on all night in a new energy vehicle?

Why Does the Dashboard Fog Up Inside?

Is it better to apply window film in winter or summer?

Will Running a Red Light at Road Construction Intersections Be Captured?

What does it mean when the VC light on the dashboard is on?