What does the MODE button on the Emgrand mean?

1 Answers
DelRebecca
07/29/25 5:36pm
Mode switching button, mainly used to toggle between the infotainment system's music and radio modes. Functions vary by location: When the MODE button is positioned on the center console panel, it controls the switching of air conditioning vent modes. When located on the steering wheel, it cycles through multimedia modes, typically alternating between FM/AM/online radio/USB/local storage/Bluetooth music modes. Emgrand maintenance light reset procedure: 1. Turn off the ignition switch 2. Simultaneously press both arrow buttons 3. Turn on the ignition switch while keeping the arrow buttons pressed 4. After approximately 3 seconds, release both arrow buttons 5. The maintenance menu will appear prompting for reset confirmation 6. Press and hold the SET (reset) button for over 3 seconds 7. Press the MODE button 8. Turn off the ignition switch to complete the reset
Was this review help?
10
2
Share
More Forum Discussions

How to adjust the ambient lighting in Mercedes-Benz E300?

The ambient lighting button for the Mercedes-Benz E300 is located on the central LCD display. Press the vehicle's one-touch start button to power on the vehicle; otherwise, the ambient lighting cannot be adjusted. Then, press the screen touch button on the right side of the steering wheel to activate the ambient lighting adjustment function on the central LCD display.
6
2
Share

How to Fully Open the Sunroof on a BMW 530?

Open the driver's side door of the BMW 5 Series. Press the brake pedal to prepare for starting the engine. Press the one-touch start button. All dashboard lights will illuminate, indicating the engine has started. Press the sunroof opening button located next to the gear lever again. The sunroof will then fully open.
1
0
Share

How to Remove Oil Film from Glass?

First, prepare some automotive oil film remover cleaner. Next, clean small stone particles from the car glass to prevent scratching. Then, according to the cleaner's instructions, wet the glass with a small amount of water and shake the cleaner well. Pour a small amount of the cleaner onto the glass, and finally, use a sponge or damp towel to repeatedly wipe the glass.
4
1
Share

How to Reset the Maintenance Light on a Suzuki Vehicle?

First, turn on the ignition switch of the Suzuki vehicle, then press and hold the indicator selection button on the right side for more than 5 seconds. The instrument display will flash "OIL" once and then continue to display. Release the indicator selection button, then quickly press the button 5 times within 2 seconds. Finally, "OIL" will flash 3 times and then turn off, completing the reset operation.
6
3
Share

How to Remember the Steps for Independent Lane Changing in Subject Three?

"One light" refers to the turn signal. Don't forget the turn signal when changing lanes. "Two looks" refer to observing the road conditions. Make sure to observe thoroughly before changing lanes. "Three quick" refers to turning the steering wheel promptly. The lane-changing action should be swift. "Four no" refers to not changing lanes continuously. Change one lane at a time.
4
2
Share

How to Adjust the Ignition Timing Angle?

When the engine speed changes, the phase relationship between the breaker cam and the distributor shaft is automatically altered to adjust the ignition timing angle. By utilizing the centrifugal force generated by weights that increases with speed to overcome the spring force and swing outward, the linkage mechanism causes the cam to advance an angle on the shaft, thereby increasing the ignition timing angle.
17
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.