What does the inspection validity date of August 2017 on the vehicle license mean?

2 Answers
MacTeagan
07/29/25 6:06am
The inspection validity date of August 2017 on the vehicle license means that the annual inspection can be done within the three months before August 31st, i.e., on any day from June 1st to August 31st. Relevant information about vehicle annual inspection is as follows: 1. Introduction: Vehicle annual inspection refers to a mandatory test for every vehicle that has obtained an official license plate and vehicle license, equivalent to an annual physical examination for the vehicle according to the "Technical Conditions for Motor Vehicle Operation Safety." 2. Purpose: Vehicle annual inspection can promptly eliminate potential safety hazards, urge the strengthening of vehicle maintenance, and reduce the occurrence of traffic accidents.
Was this review help?
5
4
Share
DelTeagan
08/12/25 9:35am
I've been driving for a long time and know this well. The inspection validity date on the vehicle license says August 2017, meaning your car must pass the annual inspection before August 2017. If you miss the deadline, the car won't be legally allowed on the road. Over the years, I've seen many friends procrastinate, only to get fined by the police or even have their cars impounded. Especially for older models, issues like lights and brakes can easily arise—delaying inspection is risky. I suggest you check your records; if you haven't done it yet, act now. Head to the DMV or a testing station to get it sorted. Don’t underestimate this—it’s about driving safety and daily convenience. Passing inspection saves you unnecessary trouble. Remember to bring your vehicle license and ID card. The process is usually straightforward and can be done in half a day. Don’t let a small issue turn into a big problem.
Was this review help?
9
2
Share
Expand All
More Forum Discussions

Principle of Three Wires in Automotive Electric Fan?

Automotive electric fan three-wire principle is controlled by a thermostat. When the water temperature rises to the upper limit, the thermostat turns on the power, and the fan operates. When the water temperature drops to the lower limit, the thermostat turns off the power, and the fan stops working. Below is a specific introduction to the reasons why an automotive electric fan may not rotate: 1. Poor motor lubrication: This causes the motor to be unable to drive the fan blades after installation. 2. Motor overheating: Overheating can also reduce the motor's load-bearing capacity, decrease its effective power, and result in the inability to drive the load. 3. Prolonged motor usage: Extended use of the motor, such as in an electric fan, can lead to motor wear. If the motor's shaft sleeve wears out, it can easily burn out. Long-term use of the motor can also increase its internal resistance, reduce its load-bearing capacity, and result in the inability to rotate the fan blades.
2
4
Share

How to Insert the Key in F3 with One-Button Start

The BYD F3 equipped with a one-button start function does not have a keyhole inside the car, so you cannot insert a key. When you need to start the car, simply press the one-button start while holding the brake pedal to start the engine, which is very convenient. Just ensure you have the key fob with you. Here are some important points to note about the one-button start: 1. When using the one-button start to ignite the car, you must press the brake pedal and ensure the gear is in neutral or P (park) position. 2. Never press the one-button start while the vehicle is in motion to avoid potential safety hazards. 3. Some cars' one-button start buttons can be removed, revealing a mechanical keyhole underneath. If the one-button start malfunctions, you can use the mechanical key to start the car. However, some models have fixed one-button start buttons without a mechanical keyhole. In such cases, if the one-button start fails, the car must be towed to a repair shop or 4S store for servicing.
7
4
Share

How to Renew an Expired Temporary License Plate

It is not possible to renew a temporary license plate, but you can reapply for one. According to the relevant provisions of the "Regulations on the Application and Use of Motor Vehicle Driving Licenses": After purchasing a motor vehicle but before registration, the owner of the motor vehicle can apply for temporary license plates up to three times, with each validity period not exceeding 15 days. However, temporary license plates that have already been issued cannot be extended. Additional Information: Article 45 of the "Regulations on Motor Vehicle Registration" stipulates that motor vehicle owners must apply to the vehicle management office for temporary license plates under the following circumstances when the vehicle needs to be driven on the road temporarily: 1. The vehicle has not been sold. 2. The vehicle has been acquired through purchase, transfer, or donation but has not yet been registered. 3. The vehicle is used for scientific research or prototype testing. 4. Special vehicles that cannot be registered due to exceeding national standards for axle load, total mass, or overall dimensions.
10
2
Share

Does C1 demerit points affect upgrading to B2 license?

C1 demerit points below 12 have no impact on upgrading to a B2 license. However, if the annual demerit points reach 12, upgrading to a B2 license is not permitted. Below are the relevant requirements for applying for different vehicle-type licenses: 1. Medium-sized bus driving category: To apply for upgrading to a medium-sized bus driving category, the applicant must have held a city bus, large truck, small car, small automatic transmission car, low-speed truck, or three-wheeled vehicle driving license for at least three years, with no record of accumulating 12 demerit points in the last three consecutive scoring cycles before application; 2. Tractor driving category: To apply for upgrading to a tractor driving category, the applicant must have held a medium-sized bus or large truck driving license for at least three years, or a large bus driving license for at least one year, with no record of accumulating 12 demerit points in the last three consecutive scoring cycles before application.
17
2
Share

Where is the air filter located in the older Teana model?

The air filter of the older Teana model is located behind the glove box on the passenger side. Here is some relevant information about the Teana car: 1. Exterior Design: The 2021 Teana model newly introduced red-black and white-black dual-color exteriors. Except for the entry-level 2.0L model, all variants are equipped with 17-inch or larger wheels, LED headlights, and LED daytime running lights. Additionally, the model also offers a Shadow Edition package, which includes blackened rear emblems, chrome front grille trims, wheels, rear spoilers, and Midnight personalized rear emblems for a unique exterior look. 2. Interior Design: The 2021 Teana upgrade features piano black lacquer door panels, wood grain trims on the center console and gear shift box, and exquisite soft material upholstery to enhance the cabin's luxurious feel. Moreover, the Shadow Edition package also comes with premium LED welcome sills and exclusive floor mats.
11
0
Share

What is the fuel consumption of the Chevrolet Cavalier?

The actual measured fuel consumption of the Chevrolet Cavalier is 7.0L/100km. Here are the relevant details: 1. The Cavalier's fuel consumption is relatively economical: Although the Cavalier does not offer an actively selectable eco-driving mode, it provides prompts through an ECO energy-saving index. Lightly pressing the accelerator will show one or two bars on the progress indicator, representing energy-saving (with a leaf symbol). Through testing, the Cavalier is positioned among compact cars, yet its fuel consumption is close to that of subcompact cars, demonstrating excellent performance and making it a great choice for budget-conscious families. 2. Advantages of the Cavalier: The 7.0L/100km fuel consumption figure is largely due to the 1.5L naturally aspirated engine and the 6-speed automatic transmission. The engine auto start-stop function also contributes to fuel efficiency. 3. Methods to reduce fuel consumption: The simplest and most direct way is to remove unnecessary items from the car to reduce unnecessary load, which is more effective than reducing fuel tank capacity.
3
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.