What does the exclamation mark on the Magotan cruise control display mean?

2 Answers
JackRose
08/26/25 5:46am
There are five possible scenarios when an exclamation mark appears on the car dashboard: general faults, automatic transmission faults, brake system faults, abnormal tire pressure, and lighting faults. Below is a detailed analysis of these five situations: General Faults: An exclamation mark inside a triangle indicates a malfunction in the car's general performance, components, or functions. Common issues include parking sensor failure, fuel cutoff system intervention or malfunction, external light failure, or engine oil pressure sensor failure. It is necessary to visit a 4S shop for inspection to identify the source of the fault. Automatic Transmission Fault: A yellow gear with an exclamation mark inside is the automatic transmission fault warning light, indicating a transmission malfunction or transmission lubricant level below the normal range. The transmission fluid should be replaced promptly. Brake System Fault: An exclamation mark inside a circle with parentheses represents a brake system warning, typically indicating a brake system malfunction or low brake fluid level. Immediate inspection of the brake system is required to avoid accidents. Abnormal Tire Pressure: An exclamation mark with a horizontal line below parentheses is the tire pressure monitoring warning light. It illuminates when the tire pressure is too low. Check the tire pressure and restore it to the normal range. Lighting Fault: A yellow bulb with an exclamation mark is the lighting fault indicator, signaling a malfunction in one of the car lights. Solution: Visit a 4S shop for inspection as soon as possible, or conduct a self-check focusing on commonly used bulbs such as turn signals, fog lights, and interior lighting to identify the issue.
Was this review help?
15
0
Share
QuinnFitz
09/08/25 8:12am
I noticed that the exclamation mark displayed on the Magotan's cruise control is mostly due to a system malfunction. It could be that the radar sensor is blocked by dust or mud, affecting the detection of vehicles ahead; or a loose circuit connection causing signal interruption; a brake switch not resetting can also trigger the alarm; errors are more likely to occur in humid weather. I usually clean the sensors at the front grille regularly, gently wiping them with a soft cloth to avoid dirt accumulation. If the light comes on, first stop the car and turn off the engine for a few minutes before restarting to see if it disappears; if not, then it's necessary to go to a repair shop to diagnose the specific fault code with a computer. Remember not to force the use of cruise control to avoid affecting driving safety. Simple maintenance can save a lot of trouble, as details determine the driving experience.
Was this review help?
11
4
Share
Expand All
More Forum Discussions

What does the lock symbol on the Baojun 730 dashboard mean?

Baojun 730 dashboard displaying a lock indicates a security lock status, which is likely the engine immobilizer indicator, signifying that the engine has entered an anti-theft mode. Introduction to Baojun 730: 1. Exterior: The design of Baojun 730, such as the chrome accents on the front grille and LED daytime running lights, exudes a modern feel. However, the slightly elongated front section of the hood makes the overall body proportions appear less balanced. 2. Interior: Baojun 730 features a 2+2+3 seating arrangement. The new Baojun 730 boasts a more sophisticated exterior design, refined interior upgrades, spacious dimensions, and excellent storage capacity, appealing to a broader audience. 3. Powertrain: In terms of performance, it is equipped with 1.8L and 1.5T engines, both delivering ample low-end torque. Once the engine speed exceeds 1000 rpm, the power feels robust, and the throttle response is notably quick.
3
3
Share

What Are the Restrictions on Car Modifications?

The criteria for identifying assembled vehicles include unauthorized use of imported key components, among others. Below are the specific identification criteria: Not listed in the national motor vehicle production catalog: Enterprises not listed in the national motor vehicle production catalog use imported key components to assemble or produce cars and motorcycles. Unauthorized: Enterprises listed in the national catalog use imported key components to assemble or produce cars and motorcycles without approval. Unable to provide proof: Enterprises that have been approved for the project but cannot provide the import quota certificate issued by the economic and trade department, the mechanical and electrical product import certificate, the import license issued by the licensing authority, the customs duty payment certificate, and the goods import certificate issued by the customs. Motor vehicle manufacturers that use nationally approved imported key assemblies to produce cars and motorcycles, where the total value of the assemblies and non-key components exceeds 60% of the original imported model, and lack the whole vehicle import certificate or the whole vehicle duty-paid certificate.
15
1
Share

What are the symptoms of belt slippage?

Symptoms of belt slippage: 1. If you hear a sharp squeaking sound, it may indicate wear or that the timing belt is slipping when turning the steering wheel while stationary or when the air conditioning is on. 2. The first method to check is by listening for sounds. During normal operation, the timing belt runs smoothly and should not produce any abnormal noises. Causes of belt slippage: After prolonged operation, the timing belt undergoes millions of twists and deformations, so severe wear is a normal occurrence. To extend the vehicle's lifespan, the timing belt should be replaced regularly according to the intervals specified in the vehicle manual. Structural defects in the timing belt can also shorten its lifespan, such as fine cracks, fractures, or cuts. If the timing belt is damaged due to normal wear, it should be replaced promptly to avoid affecting driving performance. Additionally, inflexible idler pulleys and guide pulleys can affect the condition of the timing belt. You can use a V-belt tool to measure the belt. When pressing down by hand, if the belt can be depressed within a range of about 10-20mm, it is considered normal and can continue to be used. However, this method is the simplest and can serve as a reference but should not be the sole basis for judgment.
11
0
Share

Will points be deducted if the rear door of a pickup truck is left down when carrying cargo?

Leaving the rear door of a pickup truck down is not considered illegal, but it becomes illegal if it obstructs the license plate. If you must open the tailgate when carrying cargo, you can make an enlarged license plate number using cardboard or wood and hang it up, ensuring the characters are clearly written. Small trucks like pickups are subject to weight checks on highways, and overloading will prevent them from entering the highway. According to Article 54 of the "Regulations for the Implementation of the Road Traffic Safety Law": "The load carried by a motor vehicle must not exceed the approved load capacity specified in the vehicle's registration certificate, and the length and width of the load must not exceed the dimensions of the cargo compartment." According to the "Interim Regulations on Highway Transportation Management" issued in 1986, highway transportation is divided into two types: commercial and non-commercial. 1. Commercial transportation refers to highway transportation that provides services to society and involves various forms of fee settlement (i.e., you transport goods for others and earn money from it). 2. Non-commercial transportation refers to highway transportation that serves the production and daily life of one's own unit and does not involve fee settlement (i.e., you transport your own goods and do not earn money from it; generally, company vehicles are non-commercial). If your vehicle has all the necessary documents and is legal, you cannot transport goods for others for profit—you can only transport your own goods.
8
2
Share

Which Vehicle is the King of Pickup Trucks?

Toyota Hilux is undoubtedly the best representative model, bar none. 1. The Toyota Hilux was born in 1968, and it has been 52 years since then, making it a model that is over half a century old, having undergone 8 generational changes. As a midsize pickup truck, the Toyota Hilux has dimensions of 5330/1855/1815mm and a wheelbase of 3085mm, which makes it an 'overdeveloped' model among most midsize pickup trucks. Interestingly, the Toyota Hilux withdrew from the Japanese market in 2004 and returned to its home market 13 years later. Due to its oversized body dimensions, it was subjected to higher purchase taxes. However, in the first month of sales, initial orders for this vehicle exceeded 2,000, which is truly astonishing in a small country dominated by K-cars. 2. The Toyota Hilux boasts a 31° approach angle, 25° breakover angle, 26° departure angle, and 700mm wading depth, paired with part-time four-wheel drive, a rear differential lock, front double-wishbone independent suspension, rear leaf spring non-independent suspension, and other high-intensity off-road equipment. Because of this, the Toyota Hilux can meet the demands of vehicles needed in extremely complex terrains or by radical organizations in conflict zones.
17
2
Share

What does vehicle relocation registration mean?

It refers to the transfer of vehicle ownership records, where the vehicle's management file is moved from the original vehicle management office to another city's vehicle management office for supervision. The process involves transferring both the owner's information and vehicle documentation to the new vehicle management office. It is recommended to consult with the local vehicle management office before proceeding with the relocation registration. The specific steps for vehicle relocation registration are as follows: 1. Submit a vehicle relocation application at the local vehicle management office. 2. Obtain a tracing card at the transfer hall for vehicle tracing, specifying that the vehicle is being relocated. 3. Select the relocation option at the hall entrance based on the vehicle number. 4. Submit the required documents, similar to local transfers, with additional tracing and a copy of the vehicle license. 5. Submit the relocation authorization letter, vehicle license, etc., at the designated window and pay the relevant fees. 6. Collect the main file from the original processing location three working days after submitting the license plates. 7. A temporary license plate will be issued after completing the relocation registration. 8. The new owner can then use the file to complete the transfer-in procedures at the relevant unit.
18
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.