···
Log in / Register

What does the bulb exclamation mark on the car dashboard indicate?

4 Answers
VanEmilia
07/29/25 6:10pm

Yellow bulb with an exclamation mark is the light fault indicator, indicating that there is a fault with the car lights. Solution: Go to a 4S shop for inspection and treatment as soon as possible. You can also check it yourself, focusing on commonly used bulbs such as turn signals, fog lights, and interior lighting to see where the problem is. The exclamation mark is a common fault prompt in cars. In addition to the yellow bulb with an exclamation mark, there are four other forms of exclamation marks: an exclamation mark inside a triangle, an exclamation mark inside a yellow gear, an exclamation mark in the middle of a bracket and circle, and an exclamation mark in the middle of a bracket with a line below. The following is a detailed analysis: General fault: An exclamation mark inside a triangle. If this symbol lights up, it means that the car's general performance or components and functions have failed. Mainly includes parking sensor failure, fuel cut-off system intervention or failure, external light failure, engine oil pressure sensor failure, etc. You need to go to a 4S shop for inspection to find out the source of the fault. Automatic transmission fault: An exclamation mark inside a yellow gear. This is the automatic transmission fault warning light, indicating that there is a fault with the transmission or the transmission lubricating oil is below the normal range. The transmission oil needs to be replaced in time. Brake system fault: An exclamation mark in the middle of a bracket and circle. This represents a warning of the brake system, mainly including brake system failure and low brake fluid level. The brake system needs to be repaired immediately to avoid accidents. Tire pressure abnormality: An exclamation mark in the middle of a bracket with a line below. This represents the tire pressure monitoring warning light. When the car's tire pressure is too low, this warning light will light up. You need to check the car's tire pressure and restore it to the normal range.

Was this review help?
9
4
Share
AlexisRose
08/14/25 10:31am

That day when I saw the bulb with an exclamation mark light up on the dashboard, I knew there was a problem with the exterior lights. Common issues include burnt-out headlights, taillights, or brake lights, or poor circuit contact. After parking in the lot, I checked all the lights, and sure enough, the brake light was out—it needed replacement for safety. The last time something similar happened, I almost got rear-ended on a night drive. It's advisable to regularly maintain the lighting system, taking time to check fuses and bulbs to prevent major issues. Don’t delay when this light comes on; address it promptly to avoid accidents, as visibility and safety are top priorities while driving.

Was this review help?
10
0
Share
Expand All
McTessa
10/14/25 4:32am

Once the bulb exclamation mark warning appears on the dashboard, I immediately get nervous because it indicates an external lighting malfunction. Driving with non-functional lights is extremely dangerous – for example, others can't see your turn signals, which could easily lead to accidents. I once experienced a taillight failure that nearly caused a rear-end collision. I strongly recommend pulling over safely immediately, using a flashlight to check bulb conditions. If unresolved, call for roadside assistance or drive to a professional repair shop. Never ignore this warning, especially at night or in bad weather when lighting protection is crucial. Developing a habit of regularly conducting comprehensive light checks is even better.

Was this review help?
2
0
Share
Expand All
StMelanie
11/27/25 5:28am

The bulb exclamation mark light indicates an issue with the exterior lights, such as a burnt-out bulb or a short circuit. I usually troubleshoot it myself by first checking if the headlights, turn signals, and brake lights are functioning. If any are out, I inspect the fuse box and replace any blown fuses—quick and easy. Using a multimeter to test circuit continuity often saves a trip to the shop. Replacing a bulb myself is cost-effective and takes just minutes. However, for more complex issues, it's best to consult a mechanic rather than risking safety hazards.

Was this review help?
7
2
Share
Expand All
More Forum Discussions

What is the difference between 15w40 and 5w40 engine oil?

The difference between 5W-40 and 15W-40 engine oils lies in their low-temperature fluidity. 5W-40: The 5W can withstand external low temperatures down to -30°C. 15W-40: The 15W can withstand external low temperatures down to -20°C. Additional information: 1. Engine oil: Engine oil, also known as motor oil, is a lubricant used for the moving components in the engine crankcase. Engine oil also serves to cool and clean the engine. Engine oil consists of base oil and additives. The base oil is primarily refined mineral oil, synthetic oil, or a blend of refined mineral oil and synthetic oil. Additives include antioxidants, viscosity index improvers, pour point depressants, anti-corrosion and anti-rust agents, detergents and dispersants, friction modifiers, and anti-wear agents. 2. The meaning of "W": The "W" stands for winter, and the smaller the number before it, the better the oil's low-temperature fluidity, indicating a lower usable environmental temperature and better protection for the engine during cold starts. The number after the "W" (after the dash) is an indicator of the oil's high-temperature resistance, with higher values indicating better protection at high temperatures.
14
3
Share

What causes car shaking when releasing the accelerator pedal?

Shaking when releasing the accelerator pedal may occur due to insufficient RPM during gear shifting, which is a driving technique issue that can be resolved by the driver. It could also indicate problems with the engine mounts, where engine RPM and vehicle speed resonate at the same frequency. Below are relevant explanations: 1. Causes of shaking: Another possible reason is severe uneven wear on the four tires. Avoid mixing spare tires for high-speed driving - spare tires should only be used temporarily and replaced immediately afterward. You can also check wheel balance and four-wheel alignment, as long-term misalignment may lead to uneven wear. Even with balanced braking force distribution across all four wheels, significant differences in braking effectiveness may still occur, causing shaking. This is usually not noticeable at low speeds but becomes apparent during high-speed braking when greater braking force is required. 2. Solutions: 1) Engine shaking in neutral while stationary; replace engine mounts. 2) Steering wheel shaking when braking at high speeds; replace front brake discs. 3) Body shaking during low-speed rapid acceleration; replace spark plugs. 4) Body shaking when pressing the accelerator that disappears upon release; replace the drive shaft.
9
3
Share

Can a Typhoon Blow a Car Away?

A typhoon with wind force of 12 can blow a car away. Here are the basic principles of pure electric vehicles: 1. Working principle of electric vehicles: Battery—Current—Power regulator—Motor—Power transmission system—Driving the car. 2. Technical principle: Pure electric vehicles use motors instead of fuel engines, similar to automatic transmissions. Traditional internal combustion engines can limit the speed at which torque is efficiently generated to a narrow range, which is why traditional internal combustion engine cars require large and complex transmission mechanisms; during the operation of pure electric vehicles, no gear shifting device is needed, making them easy to operate. Compared with hybrid vehicles, pure electric vehicles use a single power source, and the electronic control system greatly reduces the internal mechanical transmission system of the car, also reducing energy loss and noise caused by friction of mechanical parts, saving space and weight inside the car.
9
5
Share

Tesla 1500km Supercharging Validity Period?

Tesla's 1500km supercharging validity period is six months. Below are the relevant introductions: Dry electrode and pre-lithiation: What Musk values are Maxwell's two globally unique technologies - dry electrode and pre-lithiation. First, let's talk about this "dry electrode" technology. Dry electrode can also be called dry process electrode technology. As the name suggests, "dry process" must correspond to "wet process". Currently, the electrode manufacturing technologies in the market are mainly "wet process", which makes this "dry process" stand out. First, let's explain what wet process electrode technology is. Wet process electrode technology is a process where the binder, active material, conductive agent, dispersant and solvent are pre-mixed into a slurry, then the slurry is coated onto the current collector and dried to remove the solvent, and finally rolled into an electrode. In simple terms, the wet process requires liquid mixing, then coating, and finally rolling - a method of electrode production. The dry process, on the other hand, does not require making slurry, but directly rolls the electrode materials.
7
5
Share

Why Does the Car Get Foggy on Rainy Days?

On rainy days, even during summer, a temperature difference develops between the inside and outside of the car. The outside temperature is lower, while the inside temperature is higher. Consequently, the temperature of the car windows also drops. When the humid air inside the car encounters the cold windows, it condenses into fog. Additionally, the air is more humid on rainy days, and when opening and closing the car doors, water from wet shoes can be brought inside, increasing the humidity in the car and making it more prone to fogging. Here’s a quick solution: Immediately turn on the car’s air conditioning, set the defrost function to maximum, and direct the cold air towards the windows. The fog will typically clear within three seconds.
17
5
Share

Can You Drive with 120 kPa Tire Pressure?

Tire pressure of 120 kPa is drivable, but the vehicle can only sustain it for 30-50 km. You should replace the tire or refill the air as soon as possible. Hazards of low tire pressure: Increased friction coefficient with the road surface, leading to higher fuel consumption; Causes heavy steering and easy deviation, which are factors detrimental to driving safety; Increases movement in various parts of the tire, causing abnormal heating due to excessive rolling; Reduces the function of the cord and rubber, leading to delamination or cord breakage and excessive friction between the tire and rim, resulting in damage to the bead area and abnormal wear; Multiplies the friction between the tire and the ground, causing a sharp rise in tire temperature, softening the tire, and drastically reducing its strength. High-speed driving may lead to a blowout; Increases tire body deformation, making the tire side prone to cracking, while generating flexing motion, leading to excessive heating, accelerating rubber aging, cord fatigue, and breakage, and increasing the tire's contact area, accelerating shoulder wear. Methods to address insufficient tire pressure: If no damage is visible, simply inflate to normal tire pressure and reset the tire pressure system; If the tire is found to be punctured during inspection, drive to a tire shop promptly for repair and then reinflate; If the tire pressure warning reappears after some time of inflation but there is no puncture, it may be due to air leakage caused by rim deformation. It is recommended to check the rim and replace it.
6
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.