What does the adaptive rotating floating pad mean?

What Constitutes Vehicle Pulling?

When driving with the steering wheel held steady, the vehicle should generally maintain a straight trajectory under normal circumstances. Any deviation to the left or right is referred to as vehicle pulling. Below is an introduction to this phenomenon: 1. Symptoms: The vehicle may exhibit either irregular left-right directional deviations or consistent directional pulling during operation. The car body may sway with a noticeable dragging sensation. 2. Causes: Inconsistent braking force between wheels (particularly on the steering axle), uncoordinated movement of suspension guide rods and steering linkage during braking, improper loading distribution on either side of the vehicle, or differing road surface traction coefficients between left and right wheels.

11

2

Share

What are the correct steps for starting and parking an automatic transmission car?

Correct steps for starting an automatic transmission car are: 1. Turn the ignition key to the power position; 2. Press the foot brake and shift the gear from P to N; 3. Release the foot brake to start the engine; 4. Warm up the car while stationary; 5. Press the foot brake, shift the gear from N to D, and release the handbrake; 6. Gradually release the foot brake and smoothly press the accelerator to start moving. Correct steps for parking an automatic transmission car are: 1. Press the foot brake to stop the car; 2. Shift the gear from D to N; 3. Engage the handbrake and turn off the engine; 4. Press the foot brake and shift the gear from N to P; 5. Release the foot brake; 6. Turn back the key, turn off the power, and pull out the key.

15

0

Share

How to Make Daytime Running Lights Flash in a Wave Pattern?

Daytime running lights cannot flash in a wave pattern. Daytime running lights are designed to indicate the presence of a vehicle to oncoming traffic during daylight hours. They are installed on both sides of the front end and serve the following purposes: 1. To enhance the vehicle's visibility; 2. To reduce the likelihood of accidents and lower the probability of fatal crashes. The method to turn on daytime running lights is as follows: 1. Push the light lever upward and hold it; 2. Pull the lever toward you and hold it, while simultaneously pressing the start button with your right hand; 3. Keep the dashboard illuminated for about 3 to 5 seconds until you hear a beep, then release your hand—the daytime running lights will be successfully activated. Precautions for installing daytime running lights include: 1. Choose an installation location that avoids high-temperature areas and places prone to water accumulation; 2. During wiring installation, ensure that the harness connector and the daytime running light connector are correctly aligned to avoid incorrect connections.

6

1

Share

What is the Chinese equivalent of Euro III standard?

Euro III emission standard is equivalent to China's National III emission standard. Here is an extended introduction: 1. Introduction to National III: Most private cars manufactured between 2005-2010 were set with Euro III or National III emission standards for tailpipe emissions. The National III standard mainly applies to light gasoline and diesel vehicles under 3.5 tons, equivalent to the Euro III standard. Its nationwide implementation date was July 1, 2007. 2. Introduction to Euro III: The EU's emission standards are implemented through the emission regulations of the European Economic Commission (ECE) and the emission directives of the European Economic Community (EEC), where EEC is now the EU (European Union). ECE emission regulations are voluntarily recognized by participating countries, while EEC/EU emission directives are mandatory for member states.

6

0

Share

What do the manufacturer's suggested retail price and the on-the-road price mean when buying a car?

Here is the introduction to the manufacturer's suggested retail price and the on-the-road price when buying a car: 1. On-the-road price: The on-the-road price refers to the total cost required to purchase a car. On-the-road price = ex-factory price + purchase tax (generally ex-factory price x 8.55%) + car insurance cost + vehicle and vessel usage tax (approximately 400 RMB, a tax levied since 2007) + inspection and license plate fee. Simplified, it is ex-factory price + ex-factory price x 8.55% + 4200. 2. Manufacturer's suggested retail price: The current vehicle sales model involves many steps. Generally, cars are sold through 4S stores or agents rather than directly from the manufacturer to consumers. However, the manufacturer provides a suggested retail price for the car, which is derived from a comprehensive analysis of the car's cost, positioning, etc. This is the manufacturer's suggested retail price often seen, which is the price announced by the manufacturer when a new car is launched.

8

2

Share

Where to install the ETC?

The installation position for small car ETC is generally in the upper middle part of the front windshield, while for large vehicles such as trucks and buses, it is installed in the lower middle part. The suitable installation position should be no lower than 1.2 meters and no higher than 2.5 meters, with an installation angle between 30 to 90 degrees. For vehicles with factory-installed or aftermarket explosion-proof film, which may affect microwave communication signal transmission, the ETC should be installed in the microwave window strip. ETC stands for Electronic-Toll-Collection, meaning electronic toll collection system. To apply for ETC, you need to provide the original and photocopies of the vehicle owner's valid ID and vehicle registration certificate. If the application is not processed by the owner, the agent's valid ID is also required. The photocopy of the vehicle registration certificate should include the page with the most recent annual inspection stamp. A bank card for deducting highway tolls is also required, and the vehicle must be registered under the name of an individual aged between 18 and 60. Here are some precautions for installing ETC: Do not block the driver's view; it is best to install it behind the rearview mirror: Many car models have a steeply inclined windshield, which can reduce the driver's field of vision. If ETC is installed without considering this, it may increase the driver's blind spots. Installing it behind the rearview mirror on the right side can help avoid obstructing the view. Do not interfere with charging: The ETC electronic tag consumes power but generally does not require charging or battery replacement because it has a solar panel on the back for self-charging. Therefore, during installation, avoid the black areas on the windshield and positions that may block the solar panel. Do not remove it arbitrarily once installed: The button in the middle of the adhesive is an anti-removal lever connected to a switch. After installation, the windshield will press the anti-removal lever in. If the tag is removed arbitrarily, the lever will pop out and trigger the switch, locking the electronic tag and rendering it unusable. In such cases, you will need to visit an ETC service point to unlock it. This mechanism is designed to prevent multiple vehicles from sharing one device. When using ETC, note the following: The ETC transaction sensing range is 8 meters. To avoid paying for the vehicle in front due to its faulty ETC device, maintain a distance of more than 10 meters from the vehicle ahead. The ETC lane recognition speed is 20 kilometers per hour; driving too fast may result in failure to read the vehicle's device information and cause payment failure. If using a debit card linked to ETC, insufficient balance will also lead to payment failure.

15

3

Share

What does the adaptive rotating floating pad mean?

What Constitutes Vehicle Pulling?

What are the correct steps for starting and parking an automatic transmission car?

How to Make Daytime Running Lights Flash in a Wave Pattern?

What is the Chinese equivalent of Euro III standard?

What do the manufacturer's suggested retail price and the on-the-road price mean when buying a car?

Where to install the ETC?

Where is the fog light fuse of the Qashqai?

What is the purpose of a roof rack?

How to Deal with the Illuminated Triangle Exclamation Mark in a Car?

What does the ECO display in a car mean?