What Does Rear Wheel Mean?

1 Answers
MacEmmett
07/25/25 3:19am
Rear wheel refers to the two wheels at the back of a vehicle, which are divided into the left rear wheel and the right rear wheel. Regularly check tire pressure: Tire pressure is an important factor affecting tire lifespan. It should neither be too high nor too low; inflate according to the vehicle's indicated tire pressure. In summer, try to keep the tire pressure slightly lower. In winter, ensure the tire pressure is slightly higher than in summer due to thermal expansion and contraction. Check for wear: Some vehicles may experience uneven tire wear. Regularly inspect the inner side of the tires for abnormal wear, focusing on whether the tread depth is consistent on both sides. Regular wheel alignment: If the vehicle pulls to one side or exhibits abnormal steering, perform a wheel alignment promptly to prevent further issues. Four-wheel alignment ensures even force distribution across all four tires, avoiding excessive wear.
Was this review help?
4
0
Share
More Forum Discussions

Can You Wash a Car After It Has Been Exposed to the Sun?

You should not wash a car after it has been exposed to the sun. Precautions for car washing: 1. Do not wash the car when the engine has not completely cooled down, as it may cause premature aging of the engine; 2. Do not wash the car under direct sunlight, as it may leave dried water spot marks on the car body; 3. Do not wash the car in very cold weather, as water freezing may cause the paint film to crack; 4. Do not use water other than soft water for washing, as it may damage the paint. Hazards of not washing the car for a long time: 1. Affects driving: A dirty car surface can affect the driver's vision, especially when driving at night, as refraction makes the vision more blurred, affecting driving safety; 2. Sealing strip aging: If the car's sealing strips are not cared for in time, they will age, leading to reduced sealing performance and decreased comfort during rides.
3
5
Share

Can a Car Be Modified with a Sunroof?

Can a car be modified with a sunroof? The functions of a sunroof: 1. Change the traditional ventilation method; 2. Prevent exhaust fumes from entering the car; 3. Reduce wind noise; 4. Quickly lower the temperature inside the car; 5. Quickly remove fog inside the car; 6. Broaden the field of vision. Maintenance methods for the sunroof: 1. Regularly clean the mechanical parts of the sunroof with oil or lubricant; 2. Regularly clean around the sliding rails to prevent sand accumulation and extend the service life of the sunroof sealing ring; 3. Before opening the sunroof, check for obstacles on the roof that may hinder the movement of the glass panel. Precautions for using the sunroof: 1. During car washing, avoid directing high-pressure water jets at the sealing ring; 2. Do not open the sunroof on bumpy roads to avoid deformation of parts or damage to the motor caused by excessive vibration between the sunroof and the sliding rails; 3. It is strictly forbidden to open the sunroof during rain or when cleaning the vehicle.
8
5
Share

Who Invented the Rotary Engine?

Invented by Felix Wankel from Germany, the rotary engine operates by directly converting the combustion expansion force of flammable gas into driving torque. Common engine malfunctions include: 1. The muffler emits rhythmic abnormal sounds or black smoke at various speeds; 2. The engine cannot reach high speeds, with noticeably insufficient power during driving; 3. Difficulty in starting the engine, sluggish acceleration after starting, weak vehicle performance, occasional backfire in the carburetor or engine stalling during rapid acceleration, and high engine temperature; 4. High RPM or unstable idle speed, even stalling, after releasing the accelerator pedal; 5. Steering wheel vibration at high speeds. Causes of engine malfunctions: 1. Engine washing leading to moisture in the distributor, ignition module, spark plugs, or high-voltage wires; 2. Damaged spark plugs; 3. Insufficient battery voltage; 4. Loose idle cutoff valve; 5. Clogged oil-gas separator.
2
3
Share

What Type of Oil is Best for a Chevrolet Cruze?

For a Chevrolet Cruze, 0w40 oil is recommended. The method for adding oil is as follows: 1. Lift the car, remove the underguard, and place a container of about 10 liters under the oil drain screw; 2. Unscrew the oil drain screw, use an air gun to blow at the oil filler port for two minutes, then tighten the oil drain screw after draining and wipe it with a tissue to check for leaks; 3. Reinstall the underguard and lower the car, then use a funnel to add oil through the filler port. Taking the 2018 Chevrolet Cruze as an example, it is a compact car with body dimensions of: length 4666mm, width 1807mm, height 1460mm, and a wheelbase of 2700mm.
6
4
Share

Is a tire pressure of 2.2 safe for highway driving?

A tire pressure of 2.2 is acceptable for highway driving, but low tire pressure can cause the following hazards: 1. Reduced tire lifespan; 2. Increased tire wear; 3. Low tire pressure can lead to elevated tire temperature after driving, potentially causing a blowout, and the tire sidewall is prone to deformation during driving; 4. Decreased tire grip while driving, resulting in abnormal bumpiness. Highway driving precautions include: 1. Both the driver and front-seat passenger must fasten their seat belts, and the driver should not use a mobile phone while driving; 2. Avoid sudden steering wheel movements when driving at high speeds; 3. Do not change lanes arbitrarily while driving—always use turn signals in advance when changing lanes or overtaking; 4. Only use adjacent lanes for overtaking and return to the driving lane immediately afterward—do not straddle or drive on lane dividers; 5. Do not reverse, drive against traffic, make U-turns or turns across the central divider, conduct test drives, or drive a training vehicle—also avoid overtaking or parking on ramps; 6. Maintain a following distance of at least 100 meters. When driving below 100 km/h, the distance can be appropriately shortened but should not be less than 50 meters.
7
0
Share

What is the MIIT comprehensive fuel consumption of the 10th-generation Accord?

The MIIT comprehensive fuel consumption of the 10th-generation Accord ranges from 4.2 to 6.4 liters per 100 kilometers. Taking the 2021 10th-generation Accord as an example, it is a mid-size sedan with the following dimensions: length 4893mm, width 1862mm, height 1449mm, wheelbase 2830mm, minimum ground clearance 150mm, and curb weight 1495kg. The 2021 10th-generation Accord features a MacPherson strut front suspension and a multi-link rear suspension. It is equipped with a 1.5T inline 4-cylinder turbocharged engine, delivering a maximum horsepower of 194PS, maximum torque of 260Nm, and maximum power of 143kW, paired with a continuously variable transmission (CVT).
19
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.