What Does Mild Hybrid Mean?

1 Answers
LeZane
07/24/25 1:04am
Mild hybrid refers to mild hybrid power or light hybrid vehicles. The following is an introduction and advantages of mild hybrid vehicles: Introduction to Mild Hybrid Vehicles: Mild hybrid power changes the original power output method of vehicles. Mild hybrid vehicles generally use pure electric power to start, so there is no significant vibration or noise when starting the car. Mild hybrid vehicles have a power recovery system that recovers wasted energy when braking, charging the vehicle's battery to achieve energy-saving and emission-reduction effects. Advantages of Mild Hybrid Vehicles: The application of the 48V mild hybrid system allows the vehicle to support higher-power onboard systems, drive higher-power start-stop motors, more easily rotate the engine crankshaft to wake up the engine, reduce system operation delays and jerks, and achieve more functions. Some 48V systems can even briefly take over the air conditioning when the engine is off, powering the air conditioning compressor to prevent the air conditioning from shutting down.
Was this review help?
10
3
Share
More Forum Discussions

What to Do If Car Glass Cracks?

Solutions for cracked car glass: If the glass only has a small scratch, you can use glass repair agents, also known as polishing compounds, along with some sandpaper, a disc, and a polishing wheel to fix it. However, remember that this process requires patience—do not rush to avoid creating deeper marks that could make the glass irreparable. Car glass is manufactured by heating the glass in a furnace to near its softening temperature, then quickly transferring it into air grids with varying cooling intensities for uneven cooling. This process creates different stresses between the main viewing area and the peripheral areas of the glass. There are mainly three types of car glass: laminated glass, tempered glass, and zone-tempered glass.
8
1
Share

Where is the cabin air filter of Dongfeng AX7 located?

Dongfeng AX7's cabin air filter is located inside the glove compartment on the passenger side. Maintenance methods for the cabin air filter: 1. If the filter is dirty, clean it by blowing compressed air from the opposite side; 2. Hold the air gun about 5cm away from the filter and blow at a pressure of 500kPa for approximately 2 minutes; 3. The cabin air filter tends to accumulate a lot of dust; simply blow away the loose dust with compressed air, and never wash it with water. The dimensions of Dongfeng AX7 are 4645mm in length, 1880mm in width, and 1690mm in height, with a wheelbase of 2715mm. The interior features a 12.3-inch intelligent full LCD dynamic instrument panel and a 1.17㎡ large panoramic sunroof with specially tempered gray glass.
5
5
Share

What are the reasons for failing the Subject 2 review?

Subject 2 review failure may be due to issues with study hours and mileage, unqualified photos, or system data errors. If the study hours are not approved, promptly contact the driving school. If unresolved, the driving school will report the issue to the vehicle management office. For unqualified photos, you should visit the driving school to retake some photos. Subject 2 is part of the motor vehicle driver's license assessment, abbreviated as the field driving skills test. For small cars C1 and C2, the test items include five mandatory components: reversing into a garage, parallel parking, stopping and starting on a slope, turning at a right angle, and driving through curves. Subject 2 aims to master basic driving operation essentials and develop fundamental vehicle control abilities.
19
5
Share

What Are the Symptoms of a Faulty Transmission?

The symptoms of a faulty transmission are: 1. Difficulty or inability to shift gears smoothly; 2. The automatic transmission remains stuck in 1st gear and cannot shift to 2nd or higher gears while driving; 3. A burning smell from the transmission fluid; 4. The engine stalls when shifting the gear lever from P or N to other positions (P or R) after starting the car, or the engine stalls when braking to a stop while driving. The functions of the transmission are: 1. To change the gear ratio and expand the range of torque and speed variation of the driving wheels; 2. To enable the car to reverse without changing the engine's rotation direction; 3. To interrupt power transmission by using neutral gear, allowing the engine to start, idle, and facilitating gear shifting or power output.
14
5
Share

Can You Keep Driving with Engine Shaking?

You should not continue driving with engine shaking and must stop to inspect it. The reasons for persistent engine shaking include: 1. No spark in the cylinder due to faulty spark plug wires, deteriorated engine stabilizer angles, poor distributor contact, or incorrect cylinder pressure; 2. After driving a certain distance, the throttle becomes too dirty, causing it not to close properly or the idle speed stepper motor to stick; 3. Carbon buildup generated during engine operation. The car engine is the device that provides power to the vehicle, determining its power, fuel efficiency, stability, and environmental performance. Depending on the power source, car engines can be categorized into diesel engines, gasoline engines, electric vehicle motors, and hybrid engines.
20
5
Share

Where is the engine model number?

The engine number is usually found on the outer surface of the engine block, or on the vehicle's nameplate or the nameplate inside the engine compartment. You can also check the engine number on the car purchase invoice; the factory certificate includes the engine number; for commercial vehicles, the operation permit can be used to query the engine number; the vehicle purchase tax payment certificate contains the engine number; the public security authority's registration records have the engine number; the vehicle insurance card includes the engine number; it can also be found below the windshield in front of the driver's seat. The simplest and most direct method is to check the vehicle's administrative green book or the vehicle's driving license. The engine number is like a person's ID number, representing each vehicle. It stores very important information about the vehicle. The engine model number is an identification code assigned by the engine manufacturer in accordance with relevant regulations, corporate or industry practices, and the attributes of the engine, for a batch of identical products. It indicates information such as the manufacturer, specifications, performance, characteristics, technology, purpose, and batch of the engine, including fuel type, number of cylinders, displacement, and static brake power. Engines installed in cars or multi-purpose passenger vehicles are marked with the professional manufacturer's name, model, and production number as required. It's important to note that the engine number is not the same as the engine model number. The engine model refers to the specification and size of the engine within the manufacturer's range, and engine models can be the same. The engine number refers to the production number of the engine, where each engine can only have one unique number, and no two engines share the same number. Composition of the vehicle engine number: Front part: Includes product series code, generation symbol, and regional or corporate code, selected by the manufacturer as needed with corresponding letters, but must be approved and filed by the industry standard's regulatory body. Middle part: Consists of cylinder count symbol, cylinder arrangement symbol, stroke symbol, and cylinder diameter symbol. Rear part: Comprises structural feature symbols and usage feature symbols. Tail part: Differentiation symbol. When differentiation is needed within the same product series due to improvements or other reasons, the manufacturer selects appropriate symbols to indicate, with the rear and tail parts possibly separated by a hyphen (-).
18
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.