What does 'left two right three' mean for the Navigator?

1 Answers
LilahFitz
07/29/25 10:10pm
The 'left two right three' in the Navigator refers to the second lane from the left and the third lane from the right. Below are the specific details about the Lincoln Navigator: 1. Vehicle Positioning: The Lincoln Navigator is a luxury full-size SUV produced by Ford Motor Company, with dimensions of 5350mm*2073mm*1937mm. 2. Power Specifications: It is equipped with a 5.4-liter V8 engine, delivering a maximum output power of 224 kW and a maximum torque of 490 N·m, providing robust performance. It comes with a 6-speed 2F automatic transmission and offers either two-wheel or four-wheel drive.
Was this review help?
6
1
Share
More Forum Discussions

What does 4llc mean?

4llc stands for low-speed four-wheel drive with a central differential system, which is a measure of a vehicle's performance. Below is an introduction to vehicle drive and differential systems: Four-wheel drive: Also known as all-wheel drive, it means that both the front and rear wheels of the vehicle have power. The engine's output torque can be distributed in different proportions to all wheels based on the road conditions to improve the vehicle's driving capability. Central differential: A central differential is installed between the drive axles. In multi-axle drive vehicles, the drive axles are connected by drive shafts. To allow each drive axle to have different input angular speeds and eliminate wheel slippage, a central differential is used.
4
3
Share

The Function of Speed Limiting Cruise Control

The function of speed limiting cruise control is to achieve speed limitation by setting the maximum output throttle signal value through the controller. When the throttle output signal cannot exceed the set maximum value, the speed is restricted. The method to use speed limiting cruise control is to press the speed limiting cruise button and then pull down the RES button. Precautions for using speed limiting cruise control: 1. Do not use the speed control system on roads with heavy traffic or poor road conditions; 2. If the set cruising speed is too high compared to the current traffic conditions, do not immediately resume the set speed; 3. Do not shift the gear lever into neutral after the system is turned on.
7
0
Share

What is the difference between 4S genuine parts and original car parts?

The difference between 4S genuine parts and original car parts is mainly reflected in their different meanings. The following is a specific introduction to the differences between 4S genuine parts and original car parts: Genuine parts: Parts produced by the main factory's regular suppliers, not the car's original factory, but by the same production supplier as the original car, and also sold in the market, including brand parts and imitations. Original car parts: The parts that come with the car, genuine parts from the car's original factory, exactly the same as the original car parts. In fact, these are the real genuine parts. Note: In addition to the original factory parts used when the car leaves the factory, the spare parts at 4S stores are also genuine parts, ordered directly from the factory.
13
3
Share

What is the orientation of the air conditioning filter?

Air filter products usually indicate the inlet and outlet. On the side of the filter, there is a small arrow indicating the direction of airflow. During installation, the top is generally the inlet, and the bottom is the outlet. More details are as follows: 1. Most air conditioning filters available on the market today have arrows on the side indicating direction. The most common indicators are 'air-flow' with an arrow, while another method uses 'UP' with an arrow. 2. These two indicators convey different meanings. 'Air-flow' with an arrow represents the direction of airflow, whereas 'UP' with an arrow indicates the installation direction is upward. In fact, the installation directions for these two types of air conditioning filters are opposite.
10
1
Share

What are the regulations for using hazard warning lights?

The hazard warning flasher, commonly known as "double flasher," is designed to alert other vehicles and pedestrians that the vehicle is experiencing a special situation. It is a type of signal light on the vehicle. Below is information regarding the use of hazard warning flashers: 1. According to the Road Traffic Law: When a motor vehicle is driving at night without streetlights, under poor lighting conditions, or encountering low visibility situations such as fog, snow, rain, dust, or hail, it should turn on the headlights, clearance lights, and rear position lights. When a following vehicle is driving close to the vehicle in front in the same direction, it should not use high beams. Motor vehicles driving in foggy conditions should turn on fog lights and hazard warning flashers. 2. When a motor vehicle is driving on a highway and encounters low visibility weather conditions such as fog, rain, snow, dust, or hail with visibility less than 100 meters, it should turn on fog lights, low beams, clearance lights, front and rear position lights, and hazard warning flashers. The speed should not exceed 40 kilometers per hour, and a distance of more than 50 meters should be maintained from the vehicle in front in the same lane. 3. When a motor vehicle is driving on a highway and encounters low visibility weather conditions such as fog, rain, snow, dust, or hail with visibility less than 50 meters, it should turn on fog lights, low beams, clearance lights, front and rear position lights, and hazard warning flashers. The speed should not exceed 20 kilometers per hour, and the vehicle should exit the highway at the nearest exit as soon as possible.
13
0
Share

Can the Sidewall of a Car Tire Be Repaired by Vulcanization?

Car tire sidewalls can be repaired by vulcanization, but under normal circumstances, passenger car tires do not require vulcanization repair; a cold patch method is usually sufficient. Vulcanization repair is only necessary when the tire damage is extensive or severe. Notes on tire repair: 1. Not all 4S shops offer tire repair services, so it's best to visit a professional tire shop for repairs. 2. There are various methods for tire repair, but they are not a cure-all. If the tire sidewall has a gash larger than 6 cm or if the tread is punctured by objects like rebar, creating a large hole, it is advisable to replace the tire with a new one.
18
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.