What Does Kunpeng Power Mean?

1 Answers
BeckettRose
07/30/25 12:21am
Kunpeng Power refers to the fuel and hybrid dual power solutions under "Chery 4.0 Era Global Power Architecture." These two solutions are primarily embodied in the Kunpeng 2.0TGDI engine and the full-function hybrid configuration Kunpeng DHT drive module. The relevant introductions are as follows: 1. Kunpeng 2.0TGDI engine: It has a maximum power of 187kW, a peak torque of 390Nm, and a thermal efficiency reaching 38.2%. 2. Full-function hybrid configuration Kunpeng DHT drive module: It is equipped with two sets of drive motors, providing an output mode primarily based on electric drive. Within this hybrid system, the motor undertakes the main driving tasks, while the engine can supply energy to the power battery under low-load conditions. Therefore, even in a depleted state, it ensures fuel economy and offers better driving quality.
Was this review help?
4
0
Share
More Forum Discussions

What needs to be replaced for a 40,000 km maintenance?

Car maintenance items at 40,000 kilometers are as follows: 1. Replace engine oil (lubricating oil) and oil filter: Must be replaced every 5,000 kilometers or six months. If using full synthetic oil, it can be replaced up to every 8,000 kilometers. 2. Replace air filter and cabin air filter: The air filter and cabin air filter should be replaced every 20,000 kilometers or two years. 3. Replace fuel filter, full vehicle brake fluid, and transmission oil: For automatic transmission models, transmission oil also needs to be replaced; for rear-wheel drive vehicles, differential oil also needs to be replaced. Additional notes: Tires over four years old may be considered for replacement. Brake discs can be replaced if the brake pads have been changed three times. Battery: The car battery should normally be replaced every two years. Even if the car hasn't driven 40,000 kilometers in two years, the battery should still be checked for power loss.
20
5
Share

Can You Continue Driving Without Replacing a Faulty Thermostat?

It is not recommended to drive without replacing a faulty thermostat. Potential Risks: Generally, it is inadvisable to drive with a malfunctioning thermostat, as unexpected issues may arise. If possible, it is best to visit a nearby repair shop to fix the issue and ensure the vehicle is in good condition before driving again. However, short-distance driving may be acceptable—just keep a close eye on the temperature gauge! If the engine does not overheat, you can drive to the nearest repair shop to remove and reinstall the thermostat cover. Function of the Thermostat: The thermostat automatically regulates the flow of coolant into the radiator based on the coolant temperature, adjusting the cooling system's efficiency to maintain the engine within an optimal temperature range. The thermostat must remain in good working condition; otherwise, it can severely affect engine performance. For example, if the main valve opens too late, it may cause engine overheating. Conversely, if it opens too early, the engine's warm-up time will be prolonged, leading to excessively low operating temperatures.
6
2
Share

Why can't the rear door of the Baojun 510 be opened from the inside?

The reasons why the rear door of the Baojun 510 cannot be opened from the inside are: 1. The child lock may be engaged; 2. The central locking system of the door is activated; 3. The door lock cable is malfunctioning; 4. The door hinge or lock pillar is deformed; 5. The door limiter is not working. The body dimensions of the Baojun 510 are: length 4220mm, width 1740mm, height 1615mm, with a wheelbase of 2550mm and a fuel tank capacity of 45 liters. The Baojun 510 is equipped with a 1.5L naturally aspirated engine, delivering a maximum power of 73 kW and a maximum torque of 135 Nm, paired with a 6-speed manual transmission. It features a front McPherson independent suspension and a rear torsion beam non-independent suspension.
19
1
Share

Can a China 5 vehicle be upgraded to China 6 emission standards?

Individuals cannot upgrade their China 5 vehicles to China 6 standards on their own. Differences in emission standards: China 6 is much stricter than China 5. According to the "2017 Air Pollution Prevention and Control Work Plan" by the Ministry of Environmental Protection, China 6 standards are 40% stricter than China 5 in terms of carbon monoxide, PM fine particulate matter, and benzene content in gasoline. Targeted groups differ: China 6 mainly targets automobile manufacturers, focusing on production consistency checks, new vehicle inspections, and in-use vehicle compliance checks. This increases scrutiny on manufacturers to ensure they produce vehicles that meet national emission standards. Cost differences: Manufacturing vehicles that comply with China 6 standards increases costs for automobile manufacturers. For example, adding PDF (Particulate Diesel Filter) and particulate traps to engines ultimately leads to higher costs for consumers.
17
3
Share

Does transferring a motorcycle twice have any impact?

Transferring a motorcycle twice does have an impact. Relationship between the number of transfers and turnover rate: The number of transfers a motorcycle has undergone is related to its turnover rate. Generally, each time a motorcycle changes hands, there will be a transfer record. When a motorcycle has been transferred too many times, it indicates that the vehicle has passed through many owners. Relationship between the number of transfers and vehicle type: The number of transfers a vehicle has undergone is generally related to its type. For example, sports bikes typically have a higher turnover rate, while vehicles with high resale value and long holding periods tend to have a lower turnover rate. Many owners drive such vehicles for tens of thousands of kilometers before selling them, which shows that the turnover rate is indeed related to the type of vehicle.
5
1
Share

How many liters of engine oil should be added to the Kawasaki Ninja?

Kawasaki Ninja requires 2 liters of engine oil. Precautions for changing engine oil: Oil change only: 2.0L, with filter replacement: 2.2L, completely dry: 2.4L. Oil viscosity: 10W40, drain plug torque: 19.6N, oil filter torque: 17.5N. It is recommended to replace the oil filter when changing the oil. Drain all the old oil from the engine before installing a new filter and adding new oil. This prevents the poor filtration effect of the old filter from affecting the performance of the new oil, which could further harm the engine. Functions of engine oil: These include: lubrication and wear reduction, cleaning and dispersion, cooling, sealing and leak prevention, corrosion protection, and shock absorption. Engine oil helps clean and disperse contaminants while also dissipating heat. After absorbing heat from the engine, the oil temperature rises. Excessive oil temperature can reduce the oil's viscosity, making it difficult to form a stable oil film that is prone to breaking.
6
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.