What does it mean when the photo for Subject 1 is not collected?

What Causes Engine Shaking and Stalling During Cold Start?

There are two main reasons for engine shaking and stalling during cold start. Below are the relevant explanations: 1. Dirty throttle body: This can cause the throttle valve to not close properly or the idle speed control motor to get stuck, both of which can lead to excessively high engine idle speed. Therefore, when the vehicle experiences shaking, the first step is to inspect the throttle body and fuel injectors. If excessive dirt is found on the throttle body or excessive carbon buildup on the fuel injectors, they should be cleaned promptly. 2. Worn engine mounts: Engine mounts serve as the vibration damping system for the engine. If there are issues with the engine mounts, it can cause shaking during idle. The engine load increases when electrical systems are turned on, leading to a drop in idle speed. To compensate for the shaking caused by this drop, the engine automatically raises the RPM slightly. When turning on the vehicle's electrical systems, especially when starting the car air conditioning in summer, the engine often exhibits shaking.

15

1

Share

What does the yellow exclamation mark on the Volkswagen dashboard mean?

When a yellow exclamation mark appears on the car dashboard, there are four possible scenarios: general faults, automatic transmission faults, abnormal tire pressure, and lighting faults. Below is a detailed analysis of these four situations: General Faults: A triangle with an exclamation mark inside indicates that the car's general performance, components, or functions have malfunctioned. Common issues include parking sensor failure, fuel cut-off system intervention or malfunction, external light failure, or engine oil pressure sensor failure. It is necessary to visit a 4S shop for inspection to identify the source of the fault. Automatic Transmission Fault: A yellow gear with an exclamation mark inside is the automatic transmission fault warning light, indicating a transmission malfunction or transmission lubricant level below the normal range. Transmission fluid should be replaced promptly. Abnormal Tire Pressure: A horizontal line under a bracket with an exclamation mark in the middle represents the tire pressure monitoring warning light. This light turns on when the car's tire pressure is too low. Check the tire pressure and restore it to the normal range. Lighting Fault: A yellow bulb with an exclamation mark is the lighting fault indicator, signaling a malfunction in one of the car's lights. Solution: Visit a 4S shop for inspection as soon as possible, or conduct a self-check focusing on commonly used bulbs such as turn signals, fog lights, and interior lighting to identify the issue. There is also a red exclamation mark inside a circled bracket, which represents a brake system warning, mainly indicating brake system failure or low brake fluid level. The brake system should be inspected immediately to avoid accidents.

8

1

Share

What are the reasons for the fuel injector not spraying fuel?

There are several reasons why a fuel injector may not spray fuel: 1. Insufficient fuel: Generally, when the fuel warning light comes on, a car can still travel about 40-50 kilometers. Therefore, many car owners may not refuel immediately when the warning light appears. However, if not handled properly, this can lead to a severe shortage of fuel in the tank, causing the fuel injector to stop spraying fuel. 2. Fuel pump damage: The fuel pump relies on fuel for cooling and lubrication. If the fuel level in the tank becomes critically low, the fuel pump is highly susceptible to damage. 3. High-pressure fuel pump failure: To increase the fuel injection pressure and improve fuel atomization, fuel is pressurized a second time by the high-pressure fuel pump before being sprayed by the injector. If the high-pressure fuel pump fails, causing a sudden drop in fuel supply pressure, the fuel injector's operation will be affected. 4. Fuel injector clogging: Unsaturated olefins and gums in fuel can form a coking-like substance under high temperatures, commonly known as carbon deposits. If carbon deposits accumulate severely on the fuel injector, it is highly likely to become clogged, thereby affecting its ability to spray fuel.

6

5

Share

How to Resolve Engine Anti-Theft Authentication Failure?

Engine authentication failure can be resolved as follows: 1. Open the door and sit in the driver's seat, take out the car remote key, and hold it against the one-touch start button for more than 30 seconds. 2. While keeping the key pressed against the one-touch start button, press the unlock button on the remote key. 3. Press the lock button and trunk button a few more times. 4. If the engine system authentication failure alarm persists after several attempts, take the vehicle to a repair shop for inspection. The reasons for engine authentication failure include the following situations: 1. The internal chip of the key is not matched/locked. 2. Faulty anti-theft read coil. 3. Communication failure between the anti-theft coil and the anti-theft control unit. 4. Internal failure of the anti-theft control unit/communication failure with the engine control unit/lack of matching. 5. Electromagnetic wave interference, etc.

16

5

Share

Is it necessary to press the brake for one-button start and stop?

One-button start and stop require pressing the brake. The one-button start system in cars is part of the keyless entry system, replacing the traditional mechanical ignition with a button. The one-button start device is a component of smart cars, simplifying the ignition process with a single button that can also turn off the engine. This device is typically installed by modifying the original key slot or as a separate panel. It can be installed in vehicles of all configurations. Steps for one-button stop and parking: 1. Press the brake; 2. Engage the handbrake; 3. Shift the gear lever to "P" position; 4. Press the ignition button to turn off the engine. Correct steps for one-button start: 1. Fasten the seatbelt; 2. Press the brake; 3. Press the ignition button to the first position; 4. Shift to D (or R) gear; 5. Release the handbrake; 6. Release the foot brake; 7. Press the accelerator; 8. Start the engine and begin driving.

12

2

Share

What does it mean to initialize the driver's window?

The meaning of initializing the driver's window is to reset the one-touch up/down function of the window. The inability of the car window to perform one-touch up/down is usually due to the battery being disconnected, the power or ground wire of the window control module being disconnected during maintenance of other systems, or severe battery depletion, which causes the initialization data of the window to be lost. In such cases, simply performing an initialization setup on the system will resolve the issue. One-touch up/down for car windows refers to a system where the window glass can be fully raised or lowered with a single press of a button. Generally, mid-to-high-end car models are equipped with this feature, primarily for the convenience of the driver and passengers, avoiding the distraction caused by manually operating the windows and thereby improving safety. To initialize the driver's window, you can hold the window-up button until the glass fully rises to the top or hold the window-down button until it completely lowers. The window regulator is the mechanism that raises and lowers the car window glass, mainly divided into two types: electric and manual. Nowadays, many cars use button-operated electric regulators for window operation. The electric window regulators used in cars typically consist of a motor, reducer, guide rope, guide plate, and glass mounting bracket. The master switch, controlled by the driver, manages the opening and closing of all windows, while individual switches on each door handle allow passengers to control their respective windows, making operation very convenient.

17

4

Share

What does it mean when the photo for Subject 1 is not collected?

What Causes Engine Shaking and Stalling During Cold Start?

What does the yellow exclamation mark on the Volkswagen dashboard mean?

What are the reasons for the fuel injector not spraying fuel?

How to Resolve Engine Anti-Theft Authentication Failure?

Is it necessary to press the brake for one-button start and stop?

What does it mean to initialize the driver's window?

Where is the air conditioning filter for Audi A5 located?

What is the working principle of the engine starting system?

Which lights should be turned on for vehicles at night?

Is the Recirculation Light On or Off?