What does it mean when the dashboard warning light comes on in a Foton truck?

1 Answers
DiSophia
07/25/25 1:07am
Check if there is a lack of power steering fluid or brake fluid. Below is some relevant information about the dashboard: 1. Introduction: Commonly seen and frequently used icons include: door warning, handbrake warning, seatbelt warning, engine self-check, lubricant condition check, ABS system check, airbag check, battery warning, and fuel level warning. 2. Precautions: If you see a light on the dashboard indicating that it is on, the corresponding light may not actually be illuminated. Therefore, it is necessary to frequently check whether the lights are functioning properly during use, especially when driving at night. The absence of lights or even improper use of lights can pose a risk of traffic accidents.
Was this review help?
1
2
Share
More Forum Discussions

How to Use the One-Button Start in Audi Q3?

Audi Q3's one-button start is located at the lower left corner of the central control screen. Below are the methods for one-button start: 1. Start/Turn off the engine: (1) Start: Press the brake pedal firmly and press the ignition button. When starting the engine, high-power-consuming electrical appliances will be temporarily turned off. (2) Turn off: After parking the vehicle, press the start button again to turn it off. 2. Turn on/Turn off the power: (1) Turn on: Press the ignition switch directly without stepping on the brake pedal. (2) Turn off: Press the button once more, and the engine tachometer pointer will return to the OFF position. 3. Correct gear shifting sequence when turning off the engine: ① Park → ② Step on the brake → ③ Shift to N gear → ④ Release the brake → ⑤ Pull the handbrake → ⑥ Turn off the engine → ⑦ Shift to P gear (Note: For parking on a slope, swap the order of ④ and ⑤).
19
0
Share

How to Activate the Windshield Washer Function

The steps to activate the windshield washer mode are as follows: 1. It cannot be operated from outside the vehicle; first, open the car door. 2. After opening the door, sit in the driver's seat. 3. On the right side of the steering wheel, you will find a lever-like control, which is the windshield wiper control lever. 4. On the right side of the multifunction steering wheel, you can see the wiper switch. Pull the lever inward, and the wiper will spray windshield washer fluid. Common mistakes when using wipers: 1. A major no-no is dry wiping or using the wipers to remove dust from the windshield on sunny days without spraying washer fluid. Always spray washer fluid before wiping away dust or insects from the windshield. 2. For stubborn or hard stains on the glass, manually clean them first to avoid damaging the rubber blade, which could lead to ineffective wiping or damage to the wiper. 3. If there is a lot of sand on the glass, use a cloth to remove it if possible, as sand particles act like sandpaper on the wiper rubber, causing severe damage to the wiper and potentially scratching the glass.
13
1
Share

What are the effects of a dirty air filter on a scooter?

A dirty air filter on a scooter can lead to severe clogging of the filter pores, obstructed engine air intake, insufficient air supply, and incomplete combustion of gasoline. This results in increased fuel consumption, black smoke from the exhaust pipe, and insufficient engine power. Regular cleaning or replacement of the air filter is necessary. The function of an air filter is to purify the air supplied to the engine before it enters the combustion chamber, removing impurities such as dust and sand particles to ensure clean air enters the cylinder block combustion chamber while maintaining smooth airflow. Using a high-quality air filter effectively ensures vehicle performance, maintains power, saves fuel consumption, controls dust entry, and allows smooth airflow into the engine combustion chamber, thereby extending the service life of components like the cylinder block, piston, and piston rings. Under low-dust road conditions, clean the filter every 2,000 km and replace it every 12,000 km. In high-dust conditions, shorten the cleaning/replacement cycle. New viscous or oil-containing filters cannot be cleaned and must be replaced directly.
6
1
Share

What does 88H on a car tire represent?

88H on a car tire indicates that the maximum load capacity of this tire is 560kg. Below are three classifications of car tires: 1. Light truck tires: Typically refer to tires with a rim diameter of 16 inches or less and a section width of 9 inches or more, mainly used on highways with speeds generally ranging from 80 to 100 km/h. 2. Truck and bus tires: Usually refer to tires with a rim diameter of 18 to 24 inches and a section width of 7 inches or more, used on trucks, dump trucks, various specialized vehicles, and trailers. These tires operate on more complex road surfaces, including good asphalt roads, poor gravel roads, dirt roads, muddy roads, icy roads, and even roadless conditions, with speeds generally not exceeding 80 km/h. 3. Construction machinery tires: These are mounted on specialized construction vehicles such as loaders, bulldozers, excavators, land levelers, road rollers, and rock drilling machines. Although their speeds are not high, the road conditions and load performance requirements are demanding, and these tires mainly use a bias-ply structure.
4
2
Share

What engine does the Kosai use?

Kosai generally uses two engines, which are: 1. A 1.5-liter turbocharged engine. The 1.5-liter turbocharged engine has a maximum power of 178 horsepower and a maximum torque of 265 Nm. This engine can output maximum power at 5500 rpm and maximum torque at 4500 rpm. This engine is equipped with direct injection technology and uses an aluminum alloy cylinder head and block. It is paired with a 6-speed manual transmission or a 6-speed automatic manual transmission. 2. A 2.0-liter turbocharged engine. The 2.0-liter turbocharged engine has a maximum power of 233 horsepower and a maximum torque of 360 Nm. This engine can output maximum power at 5500 rpm. This engine is equipped with direct injection technology and uses an aluminum alloy cylinder head and a cast iron cylinder block. It is paired with an 8-speed automatic transmission. Below is some additional information about the Kosai: The Changan Oushang Kosai is a mid-size SUV, with a very attractive exterior design and a spacious interior.
17
1
Share

Where is the child lock located on the BMW X3?

The child lock on the BMW X3 is located on the side of the rear doors. Here is some relevant information about the child lock: 1. The child lock is a lever-type mechanism. To use it, the owner simply needs to adjust the lever to the open position to activate the child lock. In this state, the door can only be opened from the outside, preventing children seated in the rear from opening the door due to mischief or other reasons, thus avoiding potential hazards. 2. The BMW X3 also features a passive child lock function. When the vehicle starts moving, the doors automatically lock and cannot be opened, preventing rear passengers from opening the doors while the vehicle is in motion. This secondary safety feature also prevents the door locking mechanism from failing, which could cause the doors to open passively due to wind pressure. When the active child lock is engaged, the owner can open the door either by deactivating the child lock and opening it from the inside or by opening it directly from the outside. If the passive child lock is activated, the owner only needs to bring the vehicle to a complete stop to release the door locking mechanism.
12
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.