What does it mean when Skoda detects a pressure loss?

2 Answers
AlexanderDella
07/28/25 10:19pm
Detecting tire pressure loss means that a certain tire is underinflated. Here are the relevant explanations: 1. Underinflation: Tires are a very important component of a car. If the tire pressure is insufficient, it should be inflated immediately. When the tire pressure is too low, the increased contact area between the tire tread and the ground leads to higher rolling resistance, resulting in increased fuel consumption. Additionally, the wear on the tire tread will abnormally concentrate on both sides. 2. Extended information: The vehicle can still be driven when pressure loss is detected. The tire pressure monitoring system will only alert the driver when the tire pressure drops to the minimum pressure limit.
Was this review help?
20
2
Share
VonMalachi
08/12/25 2:51am
Last time when I was driving my Skoda, a warning popped up on the dashboard indicating pressure loss. At first, I was puzzled and wondered if there was something wrong. It turned out that the tire pressure was too low, likely because the tire pressure monitoring system detected a leak or insufficient pressure in one of the tires. This is quite common—for example, if a tire gets punctured by a nail or when the temperature drops, the tire pressure naturally decreases. The system monitors this in real-time via sensors. If not addressed promptly, it can lead to tire deformation, accelerated wear, and even increase the risk of a blowout, especially at high speeds where the steering wheel may feel unstable. That time, I immediately pulled over, used a tire pressure gauge to check, and found the right front tire was down to just 15 psi when the standard should be around 30 psi. I had no choice but to inflate it at a nearby gas station and then went to an auto repair shop for a thorough check, where they discovered a small crack causing a slow leak. In short, don’t ignore this warning—pull over immediately to inspect or visit a professional shop to avoid bigger troubles.
Was this review help?
12
0
Share
Expand All
More Forum Discussions

Where is the Trax's Cabin Air Filter Located?

Trax's cabin air filter is located inside the glove compartment in front of the front passenger seat. The cabin air filter is a filter installed in the vehicle's air conditioning system. During air conditioning operation, it captures dust particles, purifies incoming air, reduces respiratory irritation, ensuring both passenger health and protection of the vehicle's AC system. The Trax is a Chevrolet MPV equipped with a 1.4T engine, suitable for family travel. Its body dimensions are 4255mm (length) x 1776mm (width) x 1675mm/1687mm (height) with a 2555mm wheelbase.
12
2
Share

What does the SS on the car dashboard mean?

SS on the car dashboard is the auto start-stop indicator light. This light turns on when the start-stop function is activated and turns off when it's deactivated. The engine auto start-stop system automatically shuts off the engine when the vehicle comes to a temporary stop (e.g., at a red light) during driving. This is achieved by equipping a traditional engine with an enhanced motor that has idle start-stop functionality, allowing the engine to completely shut down when idle stop conditions are met. When the vehicle needs to move again, the idle start-stop motor system quickly responds to the driver's start command, rapidly restarting the engine for seamless transition, thereby significantly reducing fuel consumption and exhaust emissions.
4
1
Share

What are the symptoms of a faulty car air conditioning pressure switch?

The symptoms of a faulty car air conditioning pressure switch include: poor contact of the contacts or abnormal operation of the pressure switch, leading to the compressor not working or failing to provide normal pressure protection. Car air conditioning pressure switches are categorized into low-pressure switches, high-pressure switches, dual-temperature switches, and three-stage pressure switches. The inspection methods for car air conditioning pressure switches are as follows: 1. Check the continuity of the pressure switch. Use an ohmmeter to measure the resistance between terminals 4M1 and 4M2 of the pressure switch. The resistance should be 0. If the resistance is not 0, it indicates poor contact of the normally closed contacts in the pressure switch, and the pressure switch needs to be replaced. If the resistance is 0, proceed to the performance test of the pressure switch. 2. Perform a performance check on the pressure switch. Test the operation of the pressure switch under specified pressure conditions. If the test results are abnormal, replace the pressure switch.
13
2
Share

Does the Envision have projector headlights?

Envision has projector headlights. All models of the Envision come equipped with projector headlights. The 28T variant features xenon headlights, while the 20T variant uses halogen headlights. The Buick Envision is positioned as a midsize SUV with a relatively large body size and ample interior space. Relevant information about projector headlights is as follows: 1. A projector is an optical component made of transparent material with a spherical surface. The lens consists of several projector elements, which can be either plastic or glass. Glass projectors are more expensive than plastic ones. 2. A projector is a refractive lens with two spherical surfaces (or part of a spherical surface) or one spherical surface (or part of a spherical surface) and one flat surface. It can form both real and virtual images.
5
3
Share

Can the car be exposed to the sun immediately after window tinting?

It is not advisable to expose the car to the sun immediately after window tinting. Direct sunlight can affect the shrinking of the film, causing the edges to bubble. If this happens, promptly return to the installation shop for treatment, as dirt can easily accumulate under the film, affecting its appearance. Try to address the issue within 3 days. To minimize the risk of bubbling, ensure the windshield is thoroughly clean before tinting. Typically, use a lint-free cloth to wipe from dry to wet, top to bottom, and then dry the edges of the glass. Considerations when purchasing window film: Clarity of the film: High-quality films usually have a transparency of up to 90%, allowing clear visibility of objects beyond 6 meters at night, regardless of the shade. Feel of the film: Genuine automotive films have a thick, smooth texture. Color of the film: High-quality films have pigments evenly fused into the film, making them durable and resistant to fading. In contrast, low-quality films have color mixed in the adhesive, which can peel off when scratched with a fingernail after removing the inner lining. Odor of the film: Low-quality films often have a strong odor due to high benzene content in the residual solvents of the adhesive layer, which can severely harm the driver's health. Bubbles: When the plastic inner lining of a low-quality film is removed and reattached, bubbles may form, whereas high-quality films remain intact. Warranty period of the film: Films produced by reputable manufacturers usually come with a longer warranty, typically 5 years.
10
5
Share

Can Mineral Water Be Used as a Substitute for Windshield Washer Fluid?

Mineral water cannot be used as a substitute for windshield washer fluid. Windshield washer fluid is designed to clean the windshield, resist static electricity, prevent fogging, provide lubrication, and offer antifreeze protection. Using mineral water would dilute the washer fluid, potentially causing various adverse effects on the vehicle and even shortening the lifespan of the wiper blades. Mineral water lacks lubricating properties, and prolonged use can lead to severe scratching of the windshield. Additionally, it increases friction on the wiper blades, resulting in skipping and unusual noises during operation. Mineral water contains various impurities that can form deposits over time, leading to clogged pipes and ultimately reducing the service life of the washer fluid reservoir.
12
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.