What does it mean to shift into P gear and leave the vehicle for inspection at a service station?

How often should the gear oil be changed for UY125?

UY125 maintenance manual states that the first gear oil change should be done at 1,000 kilometers, and subsequently every 4,000 kilometers. Gear oil (Gear-oil) is a type of lubricating oil primarily made from petroleum-based lubricating oil or synthetic lubricating oil, blended with extreme pressure anti-wear agents and oiliness agents. The method for changing gear oil is as follows: 1. Wash the motorcycle (this helps clean the area where the gear oil will be changed). 2. Remove the gear oil drain screw, then remove the gear oil fill screw. Tilting the motorcycle can help drain the oil more thoroughly. 3. After the oil is completely drained, reinstall the drain screw (tighten it slightly). 4. Pour in the new gear oil and immediately tighten the fill screw.

10

2

Share

How to Determine Liability When Changing Lanes and Being Sideswiped by a Rear Vehicle?

Determining liability when changing lanes and being sideswiped by a rear vehicle: 1. If the lane-changing vehicle fails to yield to vehicles traveling normally in the lane during the lane change, even if the vehicle has mostly completed the lane change, the lane-changing vehicle will bear full responsibility for any rear-end collision that occurs; 2. If the lane change is performed normally and the collision is caused by the excessive speed of the rear vehicle, the rear vehicle will bear the primary responsibility. When changing lanes, the lane-changing vehicle must yield to vehicles already traveling in the lane. If a traffic collision occurs due to failure to yield, the lane-changing vehicle will be fully responsible; if a rear-end collision is caused by the lane change of the front vehicle, the rear vehicle can hold the lane-changing vehicle fully responsible. Before changing lanes, always activate the turn signal to alert rear vehicles of the intended lane change, observe the speed, distance, and reaction of the rear vehicles, and only proceed with the lane change when there is an appropriate gap and speed between your vehicle and the rear vehicles.

17

1

Share

How often should the Teana be serviced?

Teana generally requires maintenance every 5,000 kilometers or six months. Below is relevant information: 1. Vehicle maintenance: Vehicle maintenance refers to the preventive work of regularly inspecting, cleaning, supplying, lubricating, adjusting, or replacing certain parts of the car. Its purpose is to maintain the vehicle's appearance, ensure normal technical conditions, eliminate hidden dangers, prevent faults, slow down the deterioration process of components, and extend the service life. 2. Inspection items: These include checking and tightening the bolts and nuts on the exposed parts of the vehicle; applying lubricant to designated lubrication points; checking the oil levels in various assemblies and adding lubricating oil; changing the engine oil; cleaning air filters, etc. The goal is to maintain the vehicle's optimal technical condition and ensure smooth operation.

2

5

Share

What are the differences between the base and mid-range versions of the Wuling Hongguang Plus?

The differences between the base and mid-range versions of the Wuling Hongguang Plus are as follows: 1. Exterior: The mid-range version cancels the high-end version's black-based headlights with lenses, adopting a very ordinary halogen plus reflector bowl design. 2. Interior: The mid-range version removes the central control display screen found in the high-end version, and the steering wheel loses its multifunction buttons. Additionally, the steering wheel shows an airbag logo, and the passenger side has an airbag cover but no airbag logo. In terms of configuration, the main differences between the mid-range and high-end versions lie in the car's airbags, parking sensors, fog lights, rear power windows, and other features.

6

4

Share

Can I Wear Colored Contact Lenses for Driver's License Iris Recognition?

Driver's license iris recognition can be performed while wearing contact lenses. Contact lenses only alter the angle of light refraction and perspective, but the central area remains transparent and does not affect iris recognition. Below is relevant information about the iris: Introduction: The iris is a flat, circular ring-shaped membrane in the middle layer of the eye wall. Located between the cornea and the lens, it is visible through the cornea and commonly referred to as the "black part of the eye." There is a small round hole in the center called the pupil, through which light enters the eye. The iris is mainly composed of connective tissue, containing pigments, blood vessels, and smooth muscle. The color of the iris varies depending on the amount and distribution of pigments, generally appearing in shades such as black, blue, gray, and brown. Precautions: During iris registration and examination verification, bare-eye collection is required, and wearing contact lenses, colored lenses, or eyeglasses is prohibited. During registration and verification, please keep your eyes close to the distance measurement device, open them wide, and align them with the center of the device's bright spot. When the registration process begins, try to keep your eyes open as wide as possible to collect high-quality iris identity information.

3

1

Share

Why is the Honda Vezel's exhaust pipe spraying water so much?

There are two situations when the Honda Vezel's exhaust pipe sprays a lot of water: one indicates that the gasoline is burning fully, achieving a very high utilization rate. The other suggests that the fuel being used is of poor quality with excessive water content. The details are as follows: 1. Exhaust system: The exhaust pipe is part of the engine's exhaust system, which mainly includes the exhaust manifold, exhaust pipe, and muffler. Generally, the three-way catalytic converter, which controls engine pollutant emissions, is also installed in the exhaust system. The exhaust pipe usually consists of the front exhaust pipe and the rear exhaust pipe. 2. Principle: A back-pressure exhaust pipe will sound better than the original factory one. Most original factory vehicles use this type of pipe, which mainly relies on the baffle muffler inside the pipe or the volume change of the pipe to generate a pressure that returns to the cylinder. When the engine ignites, the piston begins the power stroke, and the exhaust valve opens before the piston reaches the bottom dead center. At this time, the back pressure in the pipe will block the exhaust gas from rushing out, allowing the air-fuel mixture to achieve complete combustion. However, if the back pressure is too strong, it will prevent the exhaust gas from being completely discharged from the cylinder, causing the exhaust gas to burn together with the air-fuel mixture, reducing combustion efficiency. Of course, the most direct impact is on horsepower output.

12

4

Share

What does it mean to shift into P gear and leave the vehicle for inspection at a service station?

How often should the gear oil be changed for UY125?

How to Determine Liability When Changing Lanes and Being Sideswiped by a Rear Vehicle?

How often should the Teana be serviced?

What are the differences between the base and mid-range versions of the Wuling Hongguang Plus?

Can I Wear Colored Contact Lenses for Driver's License Iris Recognition?

Why is the Honda Vezel's exhaust pipe spraying water so much?

Does Canceling a Driving Test Appointment Affect the Number of Attempts?

How is the Corolla Hybrid?

Is a Motorcycle License the D Class?

Will motorcycles be photographed on elevated roads?