What does it mean for a driver to fail to use seat belts as required?

1 Answers
LeBryce
07/29/25 4:21pm
The meaning of a driver failing to use seat belts as required is that while driving on highways or urban expressways, the driver incorrectly uses the seat belt. Below is expanded knowledge on seat belt usage: 1. Incorrect methods: (1) Not fastening the seat belt before starting the car, but doing so while driving; improper positioning of the seat belt (not buckled tightly) or too loose. (2) Only fastening the seat belt when entering the highway and not wearing it during urban driving; draping the seat belt diagonally across the chest to pass inspections, then removing it afterward. 2. Correct methods: (1) The lap belt should be fastened snugly across the hips, just touching the thigh bones. (2) The shoulder belt should cross over the shoulder and chest.
Was this review help?
18
3
Share
More Forum Discussions

What Causes the Sudden Heavy Feeling in the Accelerator Pedal of a New Car?

New car accelerator suddenly feeling heavy may be due to the following reasons: Power assist component damage: The power assist component is damaged. Transmission obstruction: There is an obstruction or increased friction in the transmission part. Dirty throttle body: The throttle body is dirty, leading to insufficient air intake. Methods to address a heavy accelerator pedal are as follows: Clean the fuel injectors: Clean the throttle body, wash the fuel injectors, and lubricate the accelerator cable. Install an accelerator: Install an electronic throttle accelerator. Precautions when pressing the accelerator pedal are as follows: Press gently and release slowly: Press and release the accelerator pedal gently and smoothly. Close coordination: Releasing the clutch should be closely coordinated with pressing the accelerator, with agile movements. Select the appropriate gear: Keep the engine running at medium speed and larger throttle opening most of the time to save fuel.
4
1
Share

What Causes High Fuel Consumption in the Leiling?

This model's fuel consumption varies depending on the engine displacement and configuration. Many factors influence actual fuel consumption, and each driver's experience differs based on road conditions and time of day. Here are some key factors affecting fuel efficiency: 1. Use of air conditioning 2. Driving conditions - most fuel-efficient at steady speeds and optimal RPM 3. Vehicle weight - lighter vehicles consume less fuel 4. Electrical load - higher electrical usage increases alternator resistance 5. Driving habits - frequent braking reduces fuel efficiency 6. Engine temperature - optimal at around 70°C (too low increases oil viscosity, too high reduces lubrication) 7. Engine oil quality 8. Tire resistance - wider tires and underinflation increase resistance 9. Vehicle aerodynamics 10. Vehicle age Actual comprehensive fuel consumption depends on multiple factors including load, road conditions, driving habits, weather, wind speed, and tire pressure. Your actual driving conditions will determine the true fuel consumption.
4
5
Share

What to Do When You Hit a Nearby Car While Opening the Door?

If you hit another car's door while opening your own, you will be fully responsible for the incident. If only the paint is scratched, you can negotiate a settlement with the other party or file an insurance claim. However, note that if you file more than two claims within a year, your insurance premium may increase the following year. Below are methods to prevent hitting a nearby car when opening the door: 1. Avoid illegal parking: Do not park in restricted areas, and only open the door after the vehicle is fully parked. Otherwise, you will be fully responsible for any damage caused to people or other vehicles. 2. Check the mirrors: Before exiting, the driver should check the rearview mirrors to ensure no pedestrians or vehicles are passing before opening the door. If there are obstacles or the space is too narrow, avoid opening the door. 3. Dutch Reach method: When opening the door, first open it slightly by using the hand farthest from the door to push it gently while holding the door with the other hand. This technique, known as the "Dutch Reach," helps prevent the door from opening too wide. Check the surroundings again before stepping out. 4. Close the door immediately: After exiting, close and lock the door to prevent accidental opening due to sudden incidents.
7
1
Share

What Causes a Large Vehicle to Suddenly Emit Black Smoke?

Large vehicles suddenly emitting black smoke can be attributed to the following reasons: Uneven Fuel Supply: This occurs when the high-pressure fuel pump delivers uneven or excessive fuel to each cylinder. Uneven fuel supply can lead to unstable engine speed and intermittent black smoke emissions. The solution is to adjust the fuel supply to ensure it is balanced or within the specified range. Exhaust Pipe Blockage: High exhaust backpressure or a blocked exhaust pipe can result in insufficient air intake, affecting the air-fuel mixture ratio and causing excessive fuel consumption. To resolve this, minimize excessive bends in the exhaust pipe and clean the muffler if it is clogged with excessive soot. Diesel Fuel Issues: Using the wrong type of diesel fuel, excessively high viscosity, or poor-quality diesel can make ignition difficult, leading to black smoke emissions. Additionally, this can cause carbon buildup in the combustion chamber and exhaust muffler. The solution is to use the appropriate, high-quality diesel fuel.
11
5
Share

Do I need to go in person to apply for a motorcycle license?

Motorcycle license applications can be processed by an authorized agent, but the applicant must provide a medical examination certificate issued by a hospital at or above the county level. Documents required for license application: Original ID card, photocopy, photos and photo receipt, completion of the "Motor Vehicle Driver's Physical Condition Certificate" at the epidemic prevention station, enrollment in a driving school, completion of the "Motor Vehicle Training Institution Training Form", filling out the "Motor Vehicle Driver's License Application Form" at the vehicle management office, participation in subjects one, two, three, and four exams, collection of the driver's license at the vehicle management office (within 10 working days after all exams are completed), and for additional licenses, at least one year must have passed since the previous license was obtained. Introduction to the license: The motor vehicle license is the legal document that permits a motor vehicle to be driven on roads within China. The license consists of three parts: the license holder, the main page, and the supplementary page. The front of the main page contains the endorsed core, while the back features a photo of the motor vehicle, sealed in plastic. The supplementary page is the endorsed core.
10
2
Share

Which car brand features the Flying Lady emblem?

The Flying Lady emblem represents Rolls-Royce. Founded in 1906 and headquartered in the UK, Rolls-Royce's vehicle lineup includes models such as the Phantom, Dawn, Wraith, Ghost, and Cullinan. Taking the Cullinan as an example: it is a large luxury SUV under the Rolls-Royce brand, with body dimensions of 5341mm in length, 2000mm in width, and 1837mm in height, and a wheelbase of 3295mm. The Cullinan is equipped with a 6.7-liter twin-turbocharged V12 engine across all variants, featuring direct fuel injection technology and an aluminum alloy cylinder block and heads. Both the front and rear suspensions utilize double-wishbone independent suspension, which enhances wheel traction, reduces body roll, and minimizes brake dive. All Cullinan models come with a full-time four-wheel-drive system to improve mechanical grip.
12
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.