What does ETC mean at highway toll booths?

1 Answers
DelIsabelle
07/30/25 6:43am
Highway ETC (Electronic Toll Collection) translates to electronic toll collection, which is a non-stop toll collection system. Highways are equipped with one or more ETC lanes. The ETC payment method involves: specialized short-range microwave communication between the vehicle-mounted RFID tag installed on the windshield and the microwave antenna on the ETC lane at the toll station. This is connected to the bank's backend settlement system via software networking technology, allowing vehicles to pass through bridge and highway toll stations without stopping to pay tolls. Banks that install this type of ETC express card operate on a post-payment system. ETC application requirements are as follows: Provide the original and photocopies of the vehicle owner's valid ID card and vehicle registration certificate. The photocopy of the driver's license should include the page with the most recent annual inspection stamp. Complete a postal credit card application form, which will be used to bind the ETC card. After receiving the credit card, swipe it twice and present the POS receipt to a designated postal outlet to receive and install the ETC onboard device for free, with no additional charges. Applicants must be between 18 and 60 years old. The vehicle must be registered under the applicant's name. Here are some considerations for installing ETC: Do not obstruct the driver's view. It is best to install it behind the rearview mirror. Many car models have steeply angled windshields, which can reduce the driver's field of vision. Installing the ETC device without considering this may increase blind spots. Install it on the right side behind the rearview mirror to avoid blocking the view. Avoid interfering with charging. The ETC electronic tag consumes power but generally does not require charging or battery replacement, as it has a built-in solar panel on the back for self-charging. Therefore, during installation, avoid the blackened areas on the windshield and positions that may block the solar panel. Do not remove the device once installed. The adhesive in the middle has an anti-tamper switch. Once installed, the windshield will press this switch in. If the device is removed, the switch will pop out and lock the electronic tag, rendering it unusable. You will then need to visit an ETC service point to unlock it. This mechanism prevents multiple vehicles from sharing one device. When using ETC, note the following: The ETC transaction sensing range is 8 meters. To avoid paying for the vehicle in front due to a faulty ETC device, maintain a distance of at least 10 meters from the vehicle ahead. The ETC lane recognition speed is 20 km/h. Driving too fast may prevent the system from reading the vehicle's information, leading to payment failure. If using a debit card linked to ETC, insufficient balance may also cause payment failure.
Was this review help?
16
2
Share
More Forum Discussions

Is highway reversing manually captured?

Highway reversing can be manually captured. The cameras for highway reversing are divided into two types: electronic cameras and manual cameras. Electronic cameras are usually installed at key sections, such as the entry and exit ramps of highways. These cameras take two photos for comparison to determine if a vehicle is reversing. Some sections also deploy manual cameras to capture highway reversing. Manual capture typically involves monitoring the surveillance footage. If a vehicle is observed reversing on the highway, the operator will control the camera to capture the violation. Reversing on highways often occurs when drivers make wrong directional choices or miss exits. This behavior poses significant safety risks to vehicles traveling normally behind. It is difficult for these vehicles to judge the intentions of the reversing vehicle or realize it is moving backward. By the time they notice, the high speed and opposing direction of travel may lead to delayed braking, resulting in rear-end collisions or even multi-vehicle pileups and other severe accidents.
13
2
Share

How Long Does It Take to Repair a Flood-Damaged Car?

Flood-damaged cars generally take about a month to repair. Below are the specific details regarding this issue: Introduction to Flood-Damaged Cars: A flood-damaged car refers to a vehicle that has been submerged in water, typically meaning the engine and transmission have been soaked, with the water level exceeding the wheels and seats, and the underbody components being in prolonged contact with water. Such vehicles pose significant risks, as their electrical systems are prone to short circuits and even fires. Classification of Flood-Damaged Cars: If the water level exceeds the chassis, it is considered a soaked vehicle; if it surpasses the oil dipstick, it is a semi-soaked vehicle; and if it goes above the hood or dashboard, it is a fully soaked vehicle. Vehicles where the water level exceeds the center console or even submerges the roof entirely remain a ticking time bomb even after repairs.
3
1
Share

How Many Kilometers Before Replacing the Battery?

Automotive batteries typically last between 3 to 5 years. Below is relevant information about car batteries: 1. Battery: Also known as a storage battery, it is a device that converts chemical energy into electrical energy. Car batteries generally refer to lead-acid batteries, which are primarily made of lead and its oxides with sulfuric acid solution as the electrolyte. The normal service life of a car battery ranges from 1 to 8 years, largely depending on vehicle usage conditions. 2. Battery Replacement: If the battery is dead, it's recommended to first measure the battery voltage. When using a multimeter for inspection, measure the battery voltage during engine cranking. You can initially use a high-frequency discharge tester or battery tester for measurement. Under a load current not less than 110 amps, the minimum voltage should not fall below 9.6 volts and must remain stable for 5 seconds. If the voltage is below 9.6 volts but can remain stable for 5 seconds, this indicates over-discharge and requires immediate recharging. If the voltage drops below 9.6 volts and cannot maintain stability within 5 seconds, rapidly declining to 0 volts or near 0 volts, this suggests battery failure and likely requires replacement.
11
2
Share

What is the penalty standard for speeding in highway sections?

Exceeding 10-20% of the speed limit results in 3 penalty points and a fine; exceeding 20-50% leads to 6 penalty points and a fine; exceeding 50% or more results in 12 penalty points and a fine. Principle of section speed measurement: Section speed measurement involves setting up two adjacent monitoring points on the same road section. The principle is based on calculating the average speed of a vehicle over that section by measuring the time it takes to pass between the two monitoring points. The vehicle is then judged for speeding violations according to the speed limit standard for that section. Speed limit: When you see a "section speed measurement" sign on the roadside, reduce your speed to within the limit. If you are accidentally caught speeding at the first point, be sure to reduce your speed below the limit. As long as the calculated average speed after passing the second monitoring point does not exceed the limit, you will be fine.
3
4
Share

What are the effects of driving a flood-damaged car?

The hazards of flood-damaged cars are significant. After a vehicle has been submerged in water, its electrical circuits can suffer severe damage. Below is a detailed introduction to the related issues: Introduction: When a vehicle is submerged in water for an extended period, its body components can suffer severe corrosion, and the electrical circuits and equipment can be extensively damaged. Even after repairs, it remains a ticking time bomb, leaving many potential safety hazards. In later use, the vehicle is prone to frequent minor issues. Effects: Vulnerable components such as circuits, electrical devices, precision instruments, insulation and soundproofing materials, and oils are easily damaged. High-value components like the engine, transmission, computer systems, audio equipment, wiring, airbags, and steering systems can incur extremely expensive repair costs.
19
5
Share

What are the differences when driving a flood-damaged car?

Malfunctions in the instrument panel and other electronic components, as well as water ingress in the engine, can cause jerky movements when driving. Below are specific details on related aspects: Identifying a flood-damaged car: First, check the headlights and taillights for water stains and yellowing in the reflectors due to water immersion. Next, assess the condition of the headlights and taillights—if they appear too new compared to the vehicle's production date, they might have been replaced, which warrants caution. Key areas to inspect: wiring harnesses, fuse boxes, alternators, radiators, and fenders. These parts have relatively narrow gaps, and unless the car has been deeply submerged for an extended period, it's unlikely for sediment to penetrate these tight spaces. Thus, the presence of sediment accumulation is a strong indicator of a flood-damaged vehicle.
10
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.