What does engine large and small circulation mean?

What does 400cc mean for a motorcycle?

Motorcycle 400cc refers to the displacement of the motorcycle engine being 400 milliliters. 400cc represents the displacement, which is the cylinder volume of the engine, measured in milliliters. Displacement is a key parameter of an engine; the larger the displacement, the stronger the power, but the fuel consumption is also relatively higher. Additional information: 1. Chinese national standards and traffic regulations: Fuel-powered bicycles have a displacement below 30cc, 30-50cc are classified as light motorcycles, and above 50cc are considered motorcycles. 2. A motorcycle consists of five main parts: the engine, transmission system, running gear, steering and braking systems, and electrical instrumentation equipment. 3. The spark plug is a critical component of a motorcycle engine. The normal combustion of the air-fuel mixture is essential for the engine's proper operation. Firstly, each type of engine uses a different spark plug model, mainly differing in heat value and thread size, so it is crucial to use the specified spark plug type.

7

1

Share

What is the wading depth of the CHR?

Wading depth is 700mm. The maximum wading depth refers to the maximum depth that can be safely traversed under safe driving conditions, also known as the safe depth. It is also an important indicator for evaluating a vehicle's off-road capability. The greater the maximum wading depth, the stronger the vehicle's wading ability. Wading depth: Under full load, the Prado has a minimum ground clearance of around 190mm. The Prado's maximum wading depth of 700mm is a relatively theoretical figure. It is recommended to wade in water up to around 600mm. Exceeding 700mm may cause water to reach connectors, sensors, and other electronic components, posing a risk to your property. Height of the air intake: The height of the air intake determines the vehicle's wading depth. The primary factor is the height of the engine's air intake, which is typically located slightly above the center of the side of the grille. If the air intake is below the water level during wading, water may be sucked into the engine's cylinders. Unlike air, water cannot be compressed.

1

2

Share

What Does Comfort Access Mean?

Comfort Access is a feature that comes with a smart electronic chip key. It allows you to unlock the car doors without using the key and open the trunk automatically with a kick motion, eliminating the need for manual operation. When the key is on your person and you enter the sensing area, simply touching the door handle will unlock the car, making it very convenient without having to take out the key. Additional features: 1. Power Windows. Power windows are one of the standard features in modern cars. When you operate the power window switch, the window regulator automatically opens or closes the window glass. If an obstruction is detected while the window is closing, the glass will automatically lower a certain distance. 2. Power Sunroof. To enhance comfort and convenience, many modern cars are equipped with a power sunroof. The sunroof effectively improves air circulation inside the car, allowing fresh air to enter the cabin without the wind noise associated with opening the windows. Additionally, the sunroof provides a broader view, quickly removes interior fog, helps regulate temperature, reduces air conditioning usage, saves energy, and brings you closer to nature.

13

4

Share

How to reset the tire pressure monitoring light on Volkswagen Lavida?

Methods to reset the tire pressure monitoring light on Volkswagen Lavida are as follows: 1. For Lavida Plus, with the ignition switch on, briefly press the OK button repeatedly to select the tire pressure display and 'Tire Pressure' function. Hold for about 3 seconds until a beep is heard, and the tire pressure monitoring light will be deactivated. 2. After changing tire inflation pressure or replacing wheels, a reset is required to clear the warning light. Turn on the ignition switch, press and hold the SET button of the tire pressure control system (the black button located on the front panel near the gearshift lever) until the indicator light on the dashboard illuminates. Confirm that the new parameters are stored and the light goes off, indicating the tire pressure light reset is complete. 3. Press the black stalk on the dashboard and turn the ignition key three times from off to position 2 (without starting the vehicle) to reset. If it's near the service time, try not to delay the maintenance. When the ignition is in the ON position, the 'SERVICE' indicator on the display will flash and disappear after starting the engine, indicating that maintenance is required. After maintenance, the service light should be reset.

4

3

Share

Where is the drainage outlet of the car door?

Location of the door drainage outlet: The door drainage outlet is located at the lower part of the door panel, and generally, there are at least two drainage outlets per door. If water accumulates inside the door, it can cause damage to equipment such as the window regulator and audio system. Additional information: 1. Location of the trunk drainage hole: The trunk drainage hole is located below the spare tire. Since the trunk is generally not prone to leakage, the drainage hole is not frequently used. Usually, manufacturers seal the drainage hole, which can be unscrewed or poked open when needed. 2. Location of the sunroof drainage hole: The sunroof drainage holes are located at the four corners of the sunroof and can be seen after opening the sunroof. Each drainage hole is connected to a hose that directs water to the bottom of the car and drains it out. 3. Location of the engine compartment drainage hole: It is located at the air intake of the air conditioning system under the front windshield.

9

0

Share

What does 'how many oils does a car use' mean?

"How many oils does a car use" refers to the fuel consumption per 100 kilometers, which means the amount of fuel (in liters) required for a car to travel 100 kilometers. Below is some information about car fuel consumption: 1. Calculation method: (Amount spent on fuel ÷ Fuel price) ÷ Kilometers driven × 100 = Fuel consumption (liters). The number of liters of fuel consumed for a car to travel 100 kilometers is referred to as 'how many oils'. For example: If a car consumes a total of 19 liters of fuel to travel 200 kilometers, it can be said that the car's fuel consumption per 100 kilometers is 9.5 liters. 2. Practical significance: Fuel consumption per 100 kilometers refers to the fuel consumption of a vehicle traveling a certain speed on the road for 100 kilometers. It is a theoretical indicator of the vehicle. The fuel consumption per 100 kilometers is a value measured by the manufacturer in an objective environment using a dynamometer installed on the vehicle's chassis, converted into speed parameters, and then the theoretical experimental fuel consumption data per 100 kilometers of the vehicle model is calculated by driving at a specified speed.

11

4

Share

What does engine large and small circulation mean?

What does 400cc mean for a motorcycle?

What is the wading depth of the CHR?

What Does Comfort Access Mean?

How to reset the tire pressure monitoring light on Volkswagen Lavida?

Where is the drainage outlet of the car door?

What does 'how many oils does a car use' mean?

Does Wheel Repair Affect the Wheel?

What kind of adhesive is used to attach the windshield rearview mirror?

How to Use the Cruise Control in Mitsubishi Outlander?

What does the blue light on a car mean?