What does constant speed of a car mean?

1 Answers
OReagan
07/29/25 6:31pm
Constant speed of a car refers to the vehicle moving at a steady speed. By maintaining a consistent driving speed during operation, constant speed can be achieved after using cruise control. Driving at an economical speed can improve the car's fuel efficiency, extend its range, and reduce operating costs. Methods for maintaining constant speed: 1. Place the ball of your foot on the clutch pedal with your heel touching the ground. When the clutch is fully depressed, keep your knee slightly bent; 2. Do not release the clutch too quickly or deliberately raise the engine RPM too high when driving. Always depress the clutch fully before shifting gears; 4. Engage the clutch pedal appropriately in lower gears to achieve smooth driving and enhance ride comfort.
Was this review help?
5
2
Share
More Forum Discussions

How to adjust the date on the Teana?

After turning on the car, press and hold the 'clk' button for about 5 seconds until the time display on the screen starts flashing. Use the clock minute selection button to adjust the time—turn left to decrease and right to increase. After adjusting the date, press 'clk' again to confirm. The adjustment mode will exit automatically after a few seconds of inactivity. Below is a detailed introduction to the Teana: 1. The Teana measures 4901mm in length, 1850mm in width, and 1447mm in height, with a wheelbase of 2825mm. The differences between the 2.0L and 2.0T models in terms of appearance are minimal, mainly limited to wheel design and specifications, as well as distinct rear badges, with no other significant variations. 2. The interior design remains consistent with the current model, featuring ample leather for enhanced comfort and a luxurious feel. The dashboard is clean and visually appealing, with clearly organized functional zones. It comes equipped with an 8-inch multimedia system, 360-degree panoramic camera, electronic parking brake, GPS navigation, dual sunroofs, front seat heating, automatic braking, blind-spot monitoring, and more. 3. In terms of power, the Teana is equipped with a 2.0L naturally aspirated engine and a 2.0T turbocharged engine, delivering maximum power outputs of 117kW (159PS) and 185kW (252PS) respectively, paired with a CVT transmission.
7
3
Share

What is the speed limit for the far-right lane on the highway?

The far-right lane typically has a speed limit of 60-90 km/h. Highway speed limit introduction: Highways should indicate the driving speed for each lane. The maximum speed must not exceed 120 km/h, and the minimum speed must not be lower than 60 km/h. On highways, the maximum speed for small passenger vehicles must not exceed 120 km/h, while other motor vehicles must not exceed 100 km/h, and motorcycles must not exceed 80 km/h. For roads with two lanes in the same direction, the minimum speed for the left lane is 100 km/h; for roads with three or more lanes in the same direction, the minimum speed for the far-left lane is 110 km/h, and the minimum speed for the middle lane is 90 km/h. If the speed indicated by road speed limit signs conflicts with the above lane speed regulations, drivers should follow the speed indicated by the road speed limit signs. Highway penalty standards: The maximum driving speed on highways should not exceed 120 km/h. When there are speed limit traffic signs or surface markings, drivers must strictly adhere to the indicated speed limits. Exceeding the designated speed limit for a particular section constitutes speeding. According to traffic authorities: Based on the speeding fine and penalty point standards, small vehicles exceeding the speed limit by more than 50% but less than 100% will incur 6 penalty points plus a fine, and may also face license suspension. Exceeding the speed limit by more than 100% will result in additional fines and may also lead to license suspension.
1
4
Share

What Causes the Turn Signal to Flash Too Fast?

The reasons for a turn signal flashing too fast are as follows: 1. Damaged flasher relay. First, check whether the flasher relay is functioning properly by using a multimeter to measure the output line of the flasher relay to see if there is a 12v output. If there is intermittent output variation, it indicates normal operation. If there is no output or a constant 12v output, it means the flasher relay is damaged and needs to be replaced with a new one. 2. Poor bulb contact. If you are skilled, you can check the bulb and socket yourself for poor contact. Poor contact will naturally cause the flashing to be too fast, so it needs to be reinstalled firmly. 3. Bulb filament burnout. It may be due to the bulb filament burning out. Aging over time is normal, causing the turn signal to malfunction. In this case, a new bulb should be promptly installed. 4. Bulb power too high. If the turn signal was replaced previously, it might be because the bulb power does not match the vehicle's original flasher relay, leading to abnormal conditions. If the power is too high, it will cause the flashing to be too fast; if too low, the flashing frequency may slow down or even fail to light up. In this case, replace the bulb with one that meets the specifications, and normal operation will resume.
5
5
Share

What does the yellow exclamation mark on the Tiguan dashboard mean?

When a yellow exclamation mark appears on the car dashboard, there are 4 possible scenarios: general fault, automatic transmission fault, abnormal tire pressure, or lighting fault. Below is a detailed analysis of these 4 situations: General Fault: A triangle with an exclamation mark inside indicates a malfunction in the car's general performance, components, or functions. Common issues include parking sensor failure, fuel cut-off system intervention or malfunction, external light failure, or engine oil pressure sensor failure. It is necessary to visit a 4S shop for inspection to identify the source of the fault. Automatic Transmission Fault: A yellow gear with an exclamation mark inside is the automatic transmission fault warning light, indicating a transmission fault or low transmission fluid level. The transmission fluid should be replaced promptly. Abnormal Tire Pressure: A horizontal line under a bracket with an exclamation mark in the middle represents the tire pressure monitoring warning light. This light turns on when the tire pressure is too low. Check the tire pressure and restore it to the normal range. Lighting Fault: A yellow bulb with an exclamation mark is the lighting fault indicator, signaling a malfunction in one of the car lights. Solution: Visit a 4S shop for inspection as soon as possible, or perform a self-check focusing on commonly used bulbs such as turn signals, fog lights, or interior lights to identify the issue. There is also a red exclamation mark inside a circle with a bracket, which represents a brake system warning. This could indicate a brake system failure or low brake fluid level. Immediate inspection of the brake system is required to prevent accidents.
11
3
Share

What Causes Jerking Sensation in Automatic Transmission Cars at Low Speeds?

Possible causes include excessive carbon buildup in the throttle body, fuel injectors, or intake manifold, or faulty spark plugs. Below are relevant explanations: 1. Automatic Transmission: As the name suggests, automatic transmission eliminates the need for manual gear shifting by the driver. The vehicle automatically selects the appropriate gear based on driving speed and traffic conditions. Typical automatic transmission vehicles have six gear positions arranged from top to bottom: P, R, N, D, S, L. 2. Spark Plugs: Spark plugs are crucial components in a gasoline engine's ignition system. They introduce high voltage electricity into the combustion chamber and generate sparks by jumping across the electrode gap, thereby igniting the air-fuel mixture in the cylinder. Main components include the terminal nut, insulator, terminal stud, center electrode, side electrode, and shell.
12
3
Share

How many tickets can be issued at most for a car that remains stationary?

At the same time, in the same location, for the same violation, repeated penalties cannot be imposed. Explanation of no repeated penalties for illegal parking at the same time and place: The traffic police department will not issue two tickets to the same illegally parked vehicle in the same location on the same day. If such a situation occurs, it is likely that during duty, the officer did not notice that the vehicle had already been penalized for illegal parking, hence the issuance of a second ticket. The party involved can bring relevant documents and the ticket to the traffic police brigade to file a complaint. The brigade will investigate based on the actual situation, and if the complaint is verified, one of the tickets will be revoked. Article 93 of the Road Traffic Safety Law: For violations of the laws and regulations on road traffic safety regarding the parking or temporary stopping of motor vehicles, the violation can be pointed out, and an oral warning can be given, ordering the immediate departure of the vehicle. If the motor vehicle driver is not present or, although present, refuses to leave immediately, thereby obstructing the passage of other vehicles or pedestrians, a fine may be imposed, and the motor vehicle may be towed to a location that does not obstruct traffic or to a place designated by the traffic management department of the public security organ. The traffic management department of the public security organ shall not charge the party for towing and shall promptly inform the party of the parking location. If the motor vehicle is damaged due to improper towing methods, compensation shall be legally borne.
5
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.