What does 'bearing seizure' mean?

What does an exclamation mark on the speedometer mean?

An exclamation mark on the speedometer indicates a tire pressure fault, and you should check whether the pressure is too low or too high. Methods to reset the tire pressure warning light include: 1. Reset the fault light; 2. Press and hold the SET button with the tire pressure gauge symbol on the right front of the gear lever for an extended period; 3. Press and hold the tire pressure monitoring button until the light turns off; 4. Adjust through the multifunction steering wheel settings; 5. Use a computer diagnostic tool to reset and clear the warning; 6. With the ignition switch on, press and hold the button in the upper left corner inside the glove compartment until the tire pressure light turns off. Tire pressure refers to the air pressure inside the tires, which affects the comfort and handling stability of the vehicle.

9

2

Share

How many items are there in the C1 driving test subject 3?

According to the "Regulations on the Application and Use of Motor Vehicle Driving Licenses", there are 16 items in the C1 driving test subject 3. The C1 driving license subject 3 test includes: preparation before boarding, starting, driving in a straight line, shifting gears up and down, changing lanes, pulling over, driving straight through intersections, turning left at intersections, turning right at intersections, passing pedestrian crossings, passing school zones, passing bus stops, meeting vehicles, overtaking, making U-turns, and driving at night. According to Appendix 1 of the "Regulations on the Application and Use of Motor Vehicle Driving Licenses", the permitted driving models for C1 are: small and micro passenger vehicles, as well as light and micro cargo vehicles; light, small, and micro special operation vehicles. Precautions for the C1 subject 3 road test: When starting and pulling over, changing lanes, and turning, pay attention to using the turn signal; When passing pedestrian crossings and school intersections, pay attention to slowing down and honking the horn (if not prohibited); Pay attention to the speed and gear shifting (the maximum speed should not exceed 45, and the gear should not exceed 4th gear); During night tests, remember to switch between high and low beams at intersections, and switch from high beam to low beam when there is oncoming traffic; When pulling over at the end of the test, pay attention to the distance between the vehicle body and the roadside (about 20 centimeters is most appropriate). The penalty points for the C1 driving license subject 3 test are as follows: Before stopping, failing to observe the rear and right traffic conditions through the interior and exterior rearview mirrors will result in failure. After the examiner issues the command to pull over, failing to stop within the specified distance will result in failure. After stopping, if the vehicle body exceeds the right edge of the road or the sidewalk edge, it will result in failure. After stopping, if the driver does not turn their head to observe the side rear and left traffic conditions before opening the door, it will result in failure. Failing to use or incorrectly using the turn signal before stopping will deduct 10 points. Turning the steering wheel less than 3 seconds after turning on the turn signal before stopping will deduct 10 points. After stopping, if the vehicle body is more than 30 centimeters away from the right edge of the road or the sidewalk edge, it will deduct 10 points. After stopping, if the parking brake lever is not fully tightened, it will deduct 10 points. Releasing the foot brake pedal before fully tightening the parking brake lever will deduct 10 points. Failing to turn off the engine before getting out of the car will deduct 5 points.

6

4

Share

How to remove the air filter of Audi A6L?

Audi A6L air filter removal method is: 1. Open the engine hood and locate the air filter installed in the engine's intake manifold; 2. Release the fixing pin of the pipe connected to the intake manifold; 3. Rotate the pipe joint counterclockwise, pull out the intake manifold, and the air filter can then be removed. The Audi A6L is a mid-to-large-sized 4-door 5-seater sedan with body dimensions of: length 5050mm, width 1886mm, height 1475mm, wheelbase 3024mm. It is equipped with a 2.0T turbocharged engine and a 7-speed dual-clutch transmission, delivering a maximum power of 140 kilowatts and a maximum torque of 320 Newton meters. Its drive mode is front-wheel drive, and both front and rear suspensions use five-link independent suspension.

8

5

Share

How to Deal with Engine Oil Leakage?

Engine oil leakage can be addressed by: 1. Identifying the cause of the issue before proceeding with repairs; 2. Replacing any damaged components; 3. Tightening loose nuts. Consequences of engine oil leakage include: 1. Oil warning light activation; 2. Insufficient oil leading to engine cylinder scuffing; 3. Wastage of oil and environmental pollution. Causes of engine oil leakage in vehicles are: 1. Damage to oil pan gasket or loose screws causing leakage; 2. Damage, absence, or looseness of the oil pan drain plug gasket leading to leakage; 3. Improper installation, damage, or loose screws of the timing gear cover gasket causing leakage; 4. Deformation of the engine support plate or poor sealing of the gasket resulting in leakage; 5. Poor sealing of the valve cover gasket causing leakage; 6. Damage to the front or rear crankshaft oil seal leading to leakage; 7. Blockage of the crankshaft rear oil return thread by dirt.

14

0

Share

How to Reset the Maintenance Reminder Light on Honda Envix?

The method to reset the maintenance reminder light on the Honda Envix is as follows: 1. Without pressing the brake pedal, press the one-touch start button to turn the power to the ON mode; 2. Press the display information button repeatedly; 3. Press and hold the ENTER button until the maintenance light resets. The Honda Envix is a compact 4-door, 5-seater sedan with the following dimensions: length 4756mm, width 1804mm, height 1509mm, and a wheelbase of 2730mm. It is equipped with a 1.5L naturally aspirated engine and an eCVT continuously variable transmission, delivering a maximum power of 113 kW and a maximum torque of 134 Nm. The drivetrain is front-wheel drive, with a MacPherson strut front suspension and a torsion beam rear suspension.

7

0

Share

How to Reset the Maintenance Light on a 2019 Accord?

The method to reset the maintenance light on a 2019 Accord is: 1. Set the power mode to ON and bring the vehicle to a complete stop; 2. Use the left selector wheel on the steering wheel to switch the instrument display to the warning message; 3. Press the left selector wheel to complete the reset. The Accord is a mid-size 4-door, 5-seater sedan with body dimensions of 4893mm in length, 1862mm in width, 1449mm in height, and a wheelbase of 2830mm. The Accord is equipped with a 1.5T turbocharged engine and a CVT continuously variable transmission, delivering a maximum power of 143 kW and a maximum torque of 260 Nm. It features front-wheel drive, with a front suspension using MacPherson strut independent suspension and a rear suspension using a multi-link independent suspension.

13

0

Share

What does 'bearing seizure' mean?

What does an exclamation mark on the speedometer mean?

How many items are there in the C1 driving test subject 3?

How to remove the air filter of Audi A6L?

How to Deal with Engine Oil Leakage?

How to Reset the Maintenance Reminder Light on Honda Envix?

How to Reset the Maintenance Light on a 2019 Accord?

What does the kx license plate mean?

What is the reason for the lack of sound from the Mondeo panel buttons?

What is the reason for not being able to cancel Subject One one day in advance?

How to Open the Front Hood of the Ford Escort?