What does AVH system failure mean?

1 Answers
Gandalf
07/29/25 9:16pm
AVH stands for Auto Vehicle Hold, which can assist the driver in starting more comfortably on slopes. AVH Auto Vehicle Hold function: When the vehicle is parked on a slope, after releasing the brake pedal, the system continues to maintain braking, giving the driver enough time to press the accelerator pedal to start, thereby reducing the impact of rolling back. With the engine running, close the driver's side door, fasten the driver's seat belt, and press the AVH switch to turn the Auto Vehicle Hold function on or off. Causes of AVH system failure: There is an issue with the electronic system, usually caused by low voltage during startup. You can turn off the engine and restart it once.
Was this review help?
19
5
Share
More Forum Discussions

What are the B2 reverse parking techniques?

The car body is tilted, and it is easy to cross the line during reversing, and it is also easy to press the corner of the garage when exiting. Keeping the car body straight is the key, and the key is to learn to correct by observing the rearview mirror. When starting to reverse, you can first turn the steering wheel half a turn to the right to keep the car body slightly inclined towards the garage direction while reversing. When the rear of the car is about 1 meter away from the garage boundary line (the extension line extending towards line 1), start turning the steering wheel to enter the garage (do not turn the steering wheel too early, which means the car should turn more smoothly). After the rear of the car enters the garage, the steering wheel should still be kept close to the fully turned state. When the extension line of the car's midline swings into the bottom edge of the garage about 50 centimeters, return the steering wheel.
10
0
Share

How to set up the reversing camera for the 2021 Bora?

Connect the power supply line of the dash cam. One end of the step-down cable plugs into the dash cam, and the other end has two wires, one red and one black. The red is the positive pole, and the black is the negative pole. Route it through the fuse. Next to the fuse where the black wire is connected, there is a screw connected to the car body. Note that it must be connected to the car body to serve as the ground. Remove the rear cover of the reversing light in the trunk. Use an iron wire to thread the cable. The cable splits into two paths. First, pass the power signal line out from the reversing light cover. Unplug the connector, insert a needle into the small hole beside the front connector, and remove the reversing power line. Connect the red wire to it, then plug it back in. One section of the camera cable has a connector. Remove it and use an iron wire to thread it up. For the small notch used for fixing, slightly lengthen it with a small file, then secure the camera with instant adhesive.
4
0
Share

How to Turn On the Heated Rearview Mirror in CT5 Luxury?

The heated rearview mirror function is activated simultaneously with the rear windshield defogging function. Press the rear windshield defogging button on the air conditioning panel to start it. The heater behind the mirror quickly warms the mirror surface, gradually removing rain or fog from the mirror, eliminating the need for the driver to frequently wipe the mirror manually. When the owner turns on the defogging function, the electric heating function of the rearview mirror is also activated. The electric heating element rapidly heats up to a fixed temperature within a few minutes, typically between 35-60 degrees Celsius, thereby heating the mirror and achieving defogging and defrosting effects.
15
3
Share

How to Fix Hazard Lights Turning On When Opening the Car Door?

Opening the car door hazard lights turn on may be due to a damaged anti-theft chip on the car key, causing the system to mistakenly perceive the car as being intruded when the door is opened. It could also be a fault in the vehicle's computer system for recognizing the anti-theft chip, leading to incorrect signal identification. Another possibility is a malfunction in some circuits connected to the vehicle's computer. After understanding the potential causes, you can first try replacing the damaged components. However, for issues like a faulty anti-theft chip, it's advisable to visit a professional repair facility for inspection.
4
3
Share

How to Turn Off Both Turn Signals Simultaneously?

There is a turn signal switch below the steering wheel. Pushing it downward activates the left turn signal, while pushing it upward activates the right turn signal. Moving it to the middle position turns it off. On the left side of the steering wheel, there is a light control lever. Pushing it upward turns on the left turn signal, and pushing it downward turns on the right turn signal. However, with the advancement of automotive technology, many cars now feature a "one-touch three-flash" quick function on the hazard light switch. The driver only needs to lightly tap the lever, and the turn signal will flash three times before turning off.
6
3
Share

What is a Lada car?

Lada is a Russian car brand, which is the largest automobile manufacturer in Russia and belongs to the Volga group. Here is some information about Lada cars: Lada cars are not commonly seen in China, but the brand actually has many SUV models and some rugged off-road vehicles. The Russian automobile manufacturing industry is not very developed, so there are relatively few Russian car brands. Lada's status in Russia is similar to that of Hongqi in China. The most successful model of Lada is the VAZ-2101, which is based on the Fiat 124 four-door sedan. In the 1980s and 1990s, Lada cars were exported worldwide, with over 60% of its production being sold abroad.
14
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.