What does aggressive driving with a CVT refer to?

What is the difference between the seizure and suspension of a driver's license?

Seizure of a motor vehicle driver's license refers to an administrative compulsory measure taken by traffic police in the execution of their duties. Suspension of a motor vehicle driver's license refers to a penalty method by which the traffic management department of the public security authority legally suspends the motor vehicle driving qualification of a road traffic law violator for a certain period of time. The differences between the seizure and suspension of a driver's license are as follows: 1. Different measures taken: Seizure of a motor vehicle driver's license refers to an administrative compulsory measure taken by traffic police in the execution of their duties. Suspension of a motor vehicle driver's license refers to a penalty method by which the traffic management department of the public security authority legally suspends the motor vehicle driving qualification of a road traffic law violator for a certain period of time. 2. Purpose of the measures taken: The main purpose of adopting such administrative compulsory measures is to clarify the facts of the road traffic law violation by the party involved, so as to make a correct penalty decision.

11

0

Share

Why Can't the Air Conditioning Be Turned Off?

Here are the reasons why the car air conditioning cannot be turned off and the corresponding solutions: 1. The air conditioning switch button is damaged. Solution: Replace the button. 2. The car air conditioning thermostat is damaged. Solution: Replace the thermostat. 3. The switch contacts are stuck. Solution: Check the switch. 4. The switch circuit is faulty. Solution: Check the circuit. 5. Poor switch contact. Solution: Re-plug and fix it. Below is an introduction to the internal and external circulation of car air conditioning: 1. External circulation: The external circulation mode uses a fan to draw air from outside the car into the interior, allowing airflow between the outside and inside of the car. The air blown by the fan comes from outside the car, and even if the fan is not turned on, airflow is still drawn into the car while driving, replenishing fresh air inside the car. 2. Internal circulation: The internal circulation mode closes the airflow passage between the inside and outside of the car. Without the fan, there is no airflow circulation. When the fan is turned on, the airflow drawn in comes only from inside the car, creating an internal airflow circulation within the vehicle.

16

5

Share

What is the brand and model of the Haval Big Dog vehicle?

Haval Big Dog is a new SUV model from Haval, equipped with features such as electronic handbrake, automatic parking, automatic air conditioning, ACC adaptive cruise control, voice recognition, smart connectivity system, and wireless charging. The Haval Big Dog adopts a retro and square-shaped design, with round headlights that give it a slightly cute appearance. The exceptional qualities of the Haval Big Dog stem from its global and highly intelligent nature. On June 10, 2020, the 'Haval Naming Contest: One Word Worth Ten Thousand Gold' officially concluded, marking the end of the global naming campaign for Haval's new category SUV. After thousands of netizens brainstormed and actively voted for names, the new category SUV, built with the product concept of '3/4 Scale Vehicle,' was officially named 'Haval Big Dog.' On September 3, 2020, four configuration names for the Haval Big Dog stood out: Malinois Edition, Border Collie Edition, Labrador Edition, and Husky Edition. These names interpret the product character of the Haval Big Dog—brave, smart, majestic, and considerate.

6

0

Share

Is it necessary to install car headrests?

It is necessary to install headrests. Car headrests play a protective role for the head in the event of a traffic accident. When a vehicle is moving at high speed and a collision occurs, the resulting inertia concentrates most of the force on the neck. If the neck is not protected, the person's life safety is also at risk. Therefore, it is essential to use car headrests properly while driving. Below is an introduction to car headrests: 1. When using a car headrest, first adjust the angle between your body and the seat, straighten your back, and ensure the angle between your neck and body is gentle. This way, even in the event of a traffic accident, the headrest can provide excellent protection for the neck. 2. The smaller the distance between the passenger's back of the head and the headrest, the better, as this can minimize the damage caused by inertia during a traffic accident, reducing harm to the lowest extent. 3. It is also advisable to install headrests on the rear seats of the car, providing better protection for passengers. Additionally, while driving, the use of headrests should be combined with seat belts to ensure greater safety during the ride.

9

4

Share

What are the steps for replacing a half-shaft oil seal?

First, remove the tire, then take out the fixing screws at one end of the half-shaft, unscrew the triangular fixing screws of the lower control arm, and finally dismantle the transmission end screws of the half-shaft to proceed with the replacement. Below is relevant information about the half-shaft oil seal: 1. The half-shaft oil seal is located at the lower part of the chassis. Its function is to seal and separate the positions between the drive axle and the wheel-side reducer. The half-shaft is used to transmit the output torque from the differential's half-shaft gear to the drive wheel or wheel-side reducer. 2. If the half-shaft oil seal leaks, it will reduce the amount of lubricating oil in the drive axle, affecting normal lubrication and accelerating the wear of components, leading to premature damage. Leakage of the half-shaft oil seal allows lubricating oil to enter the wheel-side reducer, causing the oil level in the wheel-side reducer to rise, which can damage the oil seal. The oil may then flow into the brake drum, resulting in poor braking performance and posing a safety hazard while driving.

20

3

Share

What is the reason for the BMW 740 reporting an invalid rear axle steering angle signal?

After receiving the vehicle, connect to ISID for diagnostic testing as follows: 480154 - IcM: HSR control module reports a fault; 48f)38c - Rear axle lateral deviation adjustment: motor position sensor value is not credible; 480:388 - Rear axle lateral deviation adjustment actuator: a line fault is identified. This 740Li (parameters and pictures) is equipped with integrated active steering control, which includes Active Steering Control (AL) and Rear Axle Lateral Deviation Adjustment (HSR). The HSR control module is installed in the trunk recess. The HSR controls the servo motor in the rear axle lateral deviation adjustment actuator. A temperature sensor in the HSR control module monitors the final stage of the servo motor. A motor position sensor and a steering tie rod position sensor are installed in the actuator. The signals from these sensors are analyzed by the HSR control module. The HSR control module is connected to FlexRay via the Active Steering Control (AL) control module. The following components are installed in the actuator: servo motor, motor position sensor, steering tie rod position sensor. The electromechanical actuator consists of a servo motor, which moves two steering tie rods through a screw drive mechanism, and the steering tie rods are connected to the follower steering arm.

14

0

Share

What does aggressive driving with a CVT refer to?

What is the difference between the seizure and suspension of a driver's license?

Why Can't the Air Conditioning Be Turned Off?

What is the brand and model of the Haval Big Dog vehicle?

Is it necessary to install car headrests?

What are the steps for replacing a half-shaft oil seal?

What is the reason for the BMW 740 reporting an invalid rear axle steering angle signal?

Can an automatic transmission car be pushed in neutral?

What are the characteristics of Giti tires?

What are the models of Castrol engine oil?

What is the D gear position?