What does a tire pressure warning of 2.0 indicate?

What is the problem when all the coolant leaks?

The main issue causing complete coolant leakage is a crack in the engine block. Below are the relevant explanations: 1. Natural loss: Various fluids in a car experience natural loss. Since coolant is responsible for cooling the car engine and is often in a high-temperature state, it is normal for coolant to lose about 10%-36% per year. According to the technical requirements of NB/SH/T0521-2010 "Ethylene Glycol and Propylene Glycol Engine Coolants" issued by the National Energy Administration, the boiling point of a 50% volume fraction of coolant is above 100°C, and the loss is mainly due to natural evaporation. Without replacement, the annual loss ranges between 10%-36%. 2. Coolant entering the cylinder for combustion: For example, cracks in the engine block, cylinder head gasket burning or corrosion deformation, etc. In such cases, pulling out the dipstick to check if the engine oil shows emulsification. The engine block has oil and water channels. Once the cylinder head gasket is damaged, the water channel cannot be sealed, resulting in complete coolant leakage.

4

Share

What are the penalty points for each item in Subject 2 of the driving test?

Here is a detailed introduction to the penalty points for each item in Subject 2: 1. Reverse parking: Not following the prescribed route, deduct 100 points; stopping midway, deduct 5 points for each stop; pressing the solid line during reversing, deduct 100 points; the time limit for reverse parking is 210 seconds, exceeding 210 seconds without completion also deducts 100 points; after entering the parking space, if the vehicle body crosses the line, deduct 100 points; failing to complete the reverse parking also deducts 100 points; front wheels not passing the control line also deduct 100 points. 2. Parallel parking: Must be completed within 90 seconds (timing starts from engaging reverse gear), exceeding the time deducts 100 points; do not stop during the test, deduct 5 points for each stop; do not press the solid line during the test, pressing the solid line directly deducts 100 points; after entering the parking space, the vehicle body must not cross the line, crossing the line deducts 100 points; before exiting the parking space, forgetting to turn on the turn signal or the turn signal not lasting for at least 3 seconds deducts 10 points; when exiting, do not press the left solid line or the right corner of the parking space, otherwise deduct 100 points.

18

4

Share

Is the handbrake of a small car for the front or rear brakes?

The handbrake of a small car is for the rear brakes. Here are the details: 1. Introduction: The professional term for the handbrake is auxiliary brake. Unlike the main braking system, it uses a steel cable connected to the rear brake shoes to apply braking force to the vehicle. In conventional four-wheel household cars, the foot brake acts on all four wheels. If the foot brake only brakes the front wheels, it may cause the vehicle to lose directional control, making it impossible to maintain the vehicle's direction during braking. If only the rear wheels are braked, it may cause the rear wheels to lose traction, potentially leading to phenomena like fishtailing or skidding. 2. Mechanical handbrake: Most are controlled by cables, and since the front wheels are responsible for steering, placing the cables on the front wheels is inconvenient. When starting on a slope, most of the vehicle's weight is on the rear wheels, so braking the rear wheels is more effective. However, not all vehicles brake the rear wheels. For example, in engineering forklifts, since the rear wheels are responsible for steering, the handbrake is installed on the front wheels.

6

1

Share

What are the steps for car waxing?

Car waxing involves the following steps: 1. Wash the car thoroughly, preferably using a dedicated car wash solution to ensure it is completely clean. 2. Dry the car. After washing, use a drying cloth to thoroughly dry the car, as water on the paint surface makes waxing difficult. Then, move the car to a shaded area to prepare for waxing. 3. Apply wax. Use a round sponge specifically designed for solid car wax to apply the wax evenly on the paint surface. Avoid applying too thick a layer; a thin coat is sufficient. During application, use the sponge to make circular motions on the car body, creating a fish-scale effect with the wax on the paint. 4. Let it dry. After application, wait for 5-10 minutes to allow the wax to dry completely. Meanwhile, cover the remaining wax for future use. 5. Polish. Use a microfiber towel to polish the paint surface, similar to shining shoes, to remove excess wax until the car shines like new. This concludes the entire car waxing process.

9

1

Share

Points for Deduction in Reverse Parking?

There are four points for deduction in reverse parking: 1. Not following the prescribed route or sequence, deduct 100 points. 2. The vehicle body crosses the line, deduct 100 points. 3. Failing to enter the parking space, deduct 100 points. 4. Stopping midway, deduct 100 points. Notes for reverse parking: 1. Speed: The vehicle speed during the entire operation should not be too fast; excessive speed may cause missing the reference points, untimely steering wheel turning, leading to crossing the line. 2. Slowly release the clutch: When encountering the full lock point, slowly release the clutch to avoid stopping midway. 3. Steering wheel turning: When turning the steering wheel, remember this principle: 'Better to turn early than late.' 4. Steering wheel turning range: After the vehicle body enters the parking space, the speed should not be too fast, and the steering wheel turning range should not be too large; turn the steering wheel towards the side that is wider. 5. Time: After the new regulation reform, reverse parking must be completed within 210 seconds, and stopping for more than 2 seconds will deduct 5 points.

3

5

Share

What is the general wading depth for sedans?

Sedans generally have a wading depth of 15 centimeters. Below are the specific details: 1. Wading: Ensure the vehicle is driven at a low speed and constantly check the depth of the accumulated water. Manual transmission models should try to use the 1st gear, maintaining steady throttle for smooth passage, while automatic transmission models should also try to engage the forced low gear or snow mode to increase vehicle torque and prevent tire slippage. Avoid sudden driving actions and stalling midway. After exiting the water, apply the brakes several times consecutively to quickly evaporate the moisture on the brake discs and ensure the vehicle's braking performance. 2. Precautions: If the vehicle stalls due to water intake while wading, remain calm and immediately turn off the ignition switch. Do not attempt to restart the engine, as this can cause significant damage to the engine, and insurance companies may deny the claim. Then, quickly disconnect the negative terminal of the battery to prevent short circuits in the vehicle's electrical components due to water ingress. Finally, call for a tow truck and report the incident to the insurance company.

16

2

Share

What does a tire pressure warning of 2.0 indicate?

What is the problem when all the coolant leaks?

What are the penalty points for each item in Subject 2 of the driving test?

Is the handbrake of a small car for the front or rear brakes?

What are the steps for car waxing?

Points for Deduction in Reverse Parking?

What is the general wading depth for sedans?

What Problems Can Occur If Car Battery Terminals Are Connected in Reverse?

How to Set the Horn Sound When Locking a Mazda?

How many points are deducted for making a U-turn on the highway?

Can a Damaged Aluminum Engine Block Be Welded?