···
Log in / Register

What documents are required to drive a car on the road?

4 Answers
Holly
07/30/25 12:16am

Documents required for driving a car on the road: The driver must carry the vehicle license, driver's license, compulsory traffic insurance label, vehicle inspection qualification label, and environmental protection label. The compulsory traffic insurance label, vehicle inspection qualification label, and environmental protection label should be affixed to the upper right side of the front windshield. Below is the relevant content introduction: Obey traffic rules: Not only must the vehicle carry all relevant documents when on the road, but it must also comply with traffic rules and avoid illegal parking. At intersections, do not run red lights. Vehicles should slow down in advance at traffic intersections and must stop outside the stop line when the traffic light signals to stop; if there is no stop line, stop outside the pedestrian crossing. When turning right without traffic lights, yield to pedestrians.

Was this review help?
14
1
Share
MacTessa
08/16/25 4:32am

I've been driving for decades, and you can't be careless about documents. The two most important documents for driving on the road are the driver's license and the vehicle license, which should be carried with you like an ID card. The driver's license must match the vehicle you're driving—you can't use a C2 license to drive a manual transmission car. The vehicle license should be placed in a visible spot in the car. In the past, you also had to display the annual inspection sticker and insurance sticker, but now it's all digitized, which is much more convenient. Still, a word of caution: if you're pulled over by traffic police and can't produce the original documents, you might still be fined even if you have digital copies on your phone. Also, vehicle insurance, especially compulsory traffic insurance, is a must—don't wait until something happens to regret it. For those who frequently drive long distances, it's best to keep the vehicle tax certificate handy to avoid trouble during random checks at provincial borders.

Was this review help?
5
1
Share
Expand All
DiNova
10/19/25 7:02am

I remember when I first got my driver's license, I was totally confused about what to bring when driving on the road. Later, I figured it out: the driver's license proves that you can drive, while the vehicle registration certificate proves that the car is roadworthy. You can't be without either of these. If the traffic police catch you without one of them, you'll get at least one penalty point. Nowadays, many places promote electronic documents, but I still prefer carrying the original paper copies in case my phone runs out of battery. Oh, and it's best to print a copy of the vehicle insurance policy and keep it in the car, especially the compulsory traffic insurance. Although electronic policies are also accepted, some older traffic police officers still prefer paper versions. Also, regarding the annual inspection, new cars are exempt from on-site inspections for the first six years, but by the sixth year, you still need to go to the inspection station to get the sticker. In short, once you start driving, treat your documents like treasures and keep them safe—it's always the right thing to do.

Was this review help?
1
1
Share
Expand All
SilasAnn
12/02/25 7:41am

Carrying documents while driving is a basic requirement. The driver's license must be kept on your person at all times—don't leave it at home. The vehicle registration certificate should stay with the car, and the glove compartment is the safest place for it. Nowadays, the compulsory traffic insurance label no longer needs to be displayed on the windshield, but you must ensure the insurance is valid. Don’t overlook annual inspections either—even new vehicles exempt from inspections for the first six years must obtain an electronic inspection mark every two years. For commercial vehicles, an additional operating permit is required, which many people tend to forget. It’s recommended to keep a small cardholder specifically for vehicle documents to avoid frantic searching during inspections. Remember, having all your documents in order isn’t just about following rules—it also makes handling accidents like scratches or collisions much easier.

Was this review help?
2
1
Share
Expand All
More Forum Discussions

How often should the spark plugs be replaced for the Sagitar 1.6?

The spark plugs for the Sagitar 1.6 should be replaced every 30,000 to 50,000 kilometers. Spark plugs are a crucial component of the gasoline engine's ignition system. They introduce high-voltage electricity into the combustion chamber and generate a spark by jumping the electrode gap, thereby igniting the combustible air-fuel mixture in the cylinder. A spark plug mainly consists of a terminal nut, insulator, terminal post, center electrode, side electrode, and shell, with the side electrode welded to the shell. The Sagitar is a model under FAW-Volkswagen, with body dimensions of 4544mm in length, 1760mm in width, and 1461mm in height, and a wheelbase of 2578mm. The entire lineup has been upgraded with features such as car networking and an 8.0-inch color LCD instrument panel.
10
1
Share

Does a 2017 vehicle require an annual inspection in 2021?

A 2017 vehicle requires the annual inspection procedure in 2021, which is an off-line inspection procedure. It can be processed through the Traffic Management 12123 platform or directly at the vehicle management office or the traffic management department of the public security authority. Both methods effectively handle the vehicle's exemption from physical inspection. Relevant details are as follows: Purpose of vehicle annual inspection: The annual vehicle inspection is a mandatory test for every vehicle that has obtained an official license plate and registration certificate. It is equivalent to an annual physical examination of the vehicle according to the technical conditions for safe operation of motor vehicles, aiming to promptly eliminate potential safety hazards, encourage enhanced vehicle maintenance, and reduce the occurrence of traffic accidents. The inspection includes: checking for the vehicle's user manual and certificate of conformity, verifying the completeness of factory inspection marks on the vehicle body, measuring the vehicle's external and internal dimensions, wheelbase, and axle track. The inspection is conducted item by item according to technical standards. Upon passing, the initial inspection and modification registration form for motor vehicles is completed, and the vehicle's curb weight, load capacity, passenger capacity, and driver's compartment seating capacity are filled in according to the manufacturer's specifications.
18
2
Share

Is it mandatory to install ETC on the windshield?

ETC can be used without being attached to the glass. Installing ETC on the upper part of the windshield is to minimize obstruction of the driver's view while ensuring better recognition by the equipment at highway toll stations. If you prefer not to install it on the glass, place it in an open area where it can be seen through the windshield. For small vehicles, the ETC is generally installed in the upper middle part of the front windshield, while for large vehicles like trucks and buses, it is installed in the lower middle part. The suitable installation height is between 1.2 meters and 2.5 meters, with an installation angle between 30 to 90 degrees. If the vehicle has or will have a blast-resistant film, which may interfere with microwave signal transmission, the ETC should be installed in the microwave window strip. Here are some considerations for ETC installation: Avoid obstructing the view—best installed behind the rearview mirror: Many car models have windshields with a steep incline, which can reduce the driver's field of vision. Installing the ETC without considering this may increase blind spots. Placing it behind the rearview mirror on the right side helps avoid blocking the view. Ensure unobstructed charging: The ETC electronic tag consumes power but generally does not require charging or battery replacement, as it has a built-in solar panel for self-charging. Therefore, avoid installing it on the windshield's blacked-out areas or positions that might block the solar panel. Do not remove it once installed: The adhesive backing has an anti-tamper button connected to a switch. Once installed, the windshield presses this button in. If removed, the button pops out, triggering the switch and locking the tag, rendering it unusable until unlocked at an ETC service point. This mechanism prevents multiple vehicles from sharing one device. ETC usage tips: The ETC transaction sensing range is 8 meters. To avoid paying for the vehicle ahead due to its faulty ETC device, maintain a distance of over 10 meters. The ETC lane recognition speed is 20 km/h—exceeding this may result in failed transactions. If using a debit card-linked ETC, insufficient balance will cause transaction failures.
3
2
Share

What are the tips and rhymes for the B2 Subject 2 driving test?

B2 Subject 2 driving test tips and rhymes are as follows: Reversing and exiting the garage: Reversing and exiting the garage is not difficult, fasten the seatbelt, shift into gear, and flash the left turn signal, press the clutch and release the handbrake, slowly lift the clutch to start gently. Align the right line to adjust the car body, the left mirror's vertical gap follows the right line. Stop when the front horizontal line aligns with your shoulder, shift into reverse and release the clutch. When the left mirror covers the horizontal line corner, turn the steering wheel fully to the right. Watch the left mirror for the garage line, at a 30-degree angle turn back one circle, when the car and the line are parallel, straighten the steering wheel with two full turns, when the left mirror covers the front corner of the garage, press the clutch and brake. Hill start: Hill start should be relaxed, align the right line with the center of the windshield wiper. Align the middle axis with the white line, then adjust the car body by looking at the right mirror. When it's less than thirty centimeters, start slowly while watching the left mirror. When the left mirror covers the line, press the brake, pull the handbrake and don't stall. Press the foot brake and release the handbrake; lift the left hand to turn on the signal; gently lift the clutch; listen for the sound and release the foot brake. The car speed slowly moves forward, completing the hill start.
4
2
Share

What is the model of the rechargeable battery for the BMW X5 car key?

The battery model for the BMW 5 Series key is CR2032. CR2032 is a lithium manganese dioxide battery, named according to the IEC standard. The breakdown is as follows: C - Indicates a chemical battery system with lithium metal as the negative electrode and manganese dioxide as the positive electrode; R - Indicates the battery shape is cylindrical (if square, it is replaced by F); 20 - Indicates the battery diameter is 20mm; 32 - Represents the battery height of 3.2mm. The nominal voltage is 3.0V, the endpoint voltage is 2.0V, and the rated capacity ranges from 200-240mAh, varying by manufacturer quality. The shelf life of CR2032 is typically 5 years. However, if the manufacturer's production level is low or quality control is poor, its lifespan can be significantly shortened. Domestic top-tier brands can generally guarantee this lifespan. Under ideal conditions (sealed, room temperature, no moisture, etc.), the lifespan can extend to 8 or even 10 years. BMW models such as the 3 Series, 5 Series, and 7 Series all use the CR2032 battery for their keys. Replacing the BMW 5 Series key battery involves just three steps: Step 1: Remove the mechanical key. Press the lock button on the side of the smart key to release the mechanical key. Step 2: Open the battery cover. After removing the mechanical key, you will see a deep slot and a shallow slot at the top of the smart key. The deep slot is for the keyhole, while the shallow slot is used to open the battery cover. Insert the mechanical key into the shallow slot and pry it open to reveal the coin battery. Gently remove the battery. Step 3: Replace the battery. Install the new battery, then reattach the battery cover and mechanical key in order to complete the replacement. Two important notes when replacing the BMW 5 Series key battery: 1. The key uses a CR2032 coin battery—ensure you purchase the correct model. 2. Replace the battery quickly, as the key has memory functionality. If power is lost for more than 5 minutes, re-pairing will be required.
3
5
Share

What are the reasons for a car's brake pedal being hard to press down and how to solve it?

Brake pedal being hard to press down is due to a vacuum booster pump air leak or malfunction, or pressing the brake after the engine has stalled. Explanation of reasons: If the car's vacuum booster pump has an air leak or malfunctions, the force applied to the brake pedal is normally amplified by the brake booster pump. If it fails, the brake loses its power assistance, making the pedal hard to press down. Alternatively, pressing the brake after the engine has stalled is not a malfunction. Solutions: If the vacuum booster pump has an air leak or malfunctions, it can cause brake drag, and in severe cases, brake failure, significantly impacting driving safety. It is necessary to promptly repair or replace the vacuum booster pump. Additionally, a vacuum booster pump air leak or malfunction can lead to heavy steering and steering noise, with louder sounds at lower speeds and larger steering angles. If the brake is pressed after the engine has stalled, since the engine is not running, only the remaining vacuum assistance is available. Pressing the brake again will deplete the stored vacuum, making the pedal hard to press down. However, this situation will resolve itself after the vehicle is restarted, requiring no further action.
16
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.