What documents are required for new car annual inspection?

1 Answers
GavinLynn
07/29/25 11:26pm
New car annual inspection requires the following items: 1. The vehicle and its driving license. 2. A valid copy of the compulsory traffic insurance policy (i.e., the duplicate of the compulsory traffic insurance). If the duplicate page is lost, bring the original compulsory traffic insurance and make a photocopy on A4 paper. 3. The vehicle and vessel tax payment receipt. Generally, this tax fee is on the same document as the compulsory traffic insurance. Since 2009, Shenzhen requires that the vehicle and vessel tax must be paid together when purchasing compulsory traffic insurance. 4. ID card and its photocopy. For company vehicles, the company's organization code certificate and the agent's identity proof are required.
Was this review help?
19
5
Share
More Forum Discussions

Does the 2019 Bora have an anti-collision beam?

2019 Bora has an anti-collision beam, which is a device used to absorb collision energy and reduce the impact when the vehicle is involved in a collision. Below are the body dimensions and powertrain specifications of the 2019 Bora: Bora's body dimensions: The body length is 4562mm, width is 1793mm, height is 1468mm, and the wheelbase is 2614mm. The 2019 Bora is a compact 4-door 5-seater sedan produced by FAW-Volkswagen. Bora's powertrain: The 2019 Bora is equipped with a 1.5L engine and a 5-speed manual transmission, with a maximum power output of 82 kW and a maximum torque of 145 N·m. It features front-wheel drive, with a front suspension using MacPherson strut independent suspension and a rear suspension using torsion beam non-independent suspension.
1
4
Share

What is the wading depth of the Q5?

The maximum wading depth of the Q5 is 500mm. The wading depth of the Q5 is determined by the height of the vehicle's chassis, which is the ground clearance listed in the vehicle's parameter configuration table. Generally, the greater the ground clearance, the higher the chassis, and the higher the safety factor when driving through waterlogged roads. Therefore, in terms of safe wading depth, off-road vehicles and SUVs have obvious advantages. However, for most compact and small cars with low chassis, the position of the vehicle's air intake should be used as a benchmark when passing through waterlogged roads. If the air intake of the Q5 is below the water level during wading, water will be sucked into the engine's cylinders. Since water cannot be compressed like air, it will cause severe damage to the engine's mechanical components (such as connecting rods, pistons, crankshafts, etc.). Therefore, the wading depth should not exceed the height of the engine's air intake. The height of the engine's air intake—and thus the maximum wading depth—can also be increased by installing a snorkel. If wading is unavoidable, the following safe and correct operations should be performed: Before driving through water, always turn off the auto start-stop function to prevent the engine from automatically restarting if the vehicle stalls in water, which could lead to severe engine damage due to water ingestion. Assess the underwater road conditions based on the passage of preceding vehicles and choose an appropriate entry point. Follow the path taken by other vehicles and drive at a low speed, avoiding sudden acceleration or deceleration. On roads prone to waterlogging, observe warning water level markers, trees, or reference points like the wheels and doors of other vehicles to estimate the water depth before deciding whether to proceed. Know your vehicle's safe wading depth. If the water depth exceeds half the height of the tires or the engine's air intake, do not proceed and choose an alternative route instead.
9
1
Share

Does the oil dipstick have a front and back when inserting it back?

The oil dipstick does not have a front or back when inserting it back. The plastic plug on the oil dipstick will have a stopper, and as long as it is inserted to the stopper position, it can be securely fixed. Below are the usage method of the oil dipstick and the replacement cycle of the engine oil: Usage method of the oil dipstick: When checking, park the car properly, tighten the handbrake, start the engine, and when it reaches normal operating temperature, turn off the engine. Wait a few minutes to allow the oil to flow back into the oil pan. Then take out the oil dipstick, wipe it dry, insert it back, and take it out again to check the oil level. If the oil level is between the upper and lower limit marks on the lower end of the dipstick, it indicates the oil level is normal. If it is below the lower limit mark, add an appropriate amount of engine oil. Replacement cycle of engine oil: Mineral oil can meet the daily lubrication needs of the engine, with a replacement cycle of 5,000 kilometers or 6 months. Semi-synthetic oil not only provides lubrication but also has certain cleaning and repair functions, with a replacement cycle of 7,500 kilometers or 9 months. Fully synthetic oil not only has lubrication, cleaning, and repair functions but also strong environmental adaptability, with a replacement cycle of 10,000 kilometers or 1 year.
15
4
Share

Can the transmission noise in the Verano be fixed?

Transmission noise in the Verano can be repaired. When encountering transmission noise issues, if the noise occurs during gear shifting, it is mostly caused by improper operation. Here are some points to pay attention to during gear shifting: Driving habits: If the clutch is not fully disengaged or if there is an error in gear selection, the synchronizer will experience significant impact, which will inevitably produce noise. Drivers can try adjusting their driving habits, such as applying more force and holding the clutch pedal down for a longer duration. Technical operation: When driving normally, pay attention to the techniques and correct operation methods for gear shifting.
15
4
Share

What are the advantages of a three-cylinder engine?

Three-cylinder engines are composed of three cylinders. Internally, three identical single cylinders are arranged on one engine block sharing a single crankshaft to output power, primarily converting chemical energy into mechanical energy. The advantages of three-cylinder engines include low fuel consumption, strong power, and compact size with lightweight, detailed as follows: Low fuel consumption: Due to their inherent structural advantages, three-cylinder engines excel in fuel consumption control. The miniaturization of the engine makes it smaller in size with greater power density and higher thermal efficiency. The structural design of three-cylinder engines results in lower pumping losses, and due to the smaller cylinder block, friction losses during operation are reduced, leading to correspondingly lower heat dissipation losses. Strong power: Within the displacement range of 1.0L to 1.5L, because they have fewer cylinders than four-cylinder engines, three-cylinder engines have larger single-cylinder volumes under the same displacement, providing better power at low speeds. Fewer cylinders mean less mechanical friction, and increasing the number of cylinders can reduce single-cylinder efficiency. Compared to four-cylinder engines, three-cylinder engines offer faster power response and stronger power performance. Compact size and lightweight: Three-cylinder engines are compact and lightweight, which can reduce the overall vehicle weight. Their smaller size also saves space in the engine compartment, providing room for electrification components.
15
0
Share

What could be the reason for a Mazda CX-4 being locked and unable to start?

It may be due to severely obstructed oil flow or critically insufficient battery power. Space-wise: In terms of body dimensions, the Mazda CX-4 measures 4633mm in length, 1840mm in width, and 1535mm in height, with a wheelbase of 2700mm, which is only at a medium level among its peers. Power-wise: The Mazda CX-4 is equipped with two Skyactiv-G engines, a 2.0L and a 2.5L, with maximum power outputs of 116kW and 141kW respectively, and peak torques of 202N·m and 252N·m. These are paired with a 6-speed manual or a 6-speed automatic transmission. It also features the G-Vectoring-Control acceleration vectoring control system.
16
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.