What Do You Need to Bring for the Driving Test (Subject Three)?

What to Do If You Drive a Distance Without Fully Releasing the Handbrake?

It is recommended to have the rear brake pads and brake discs inspected at a service station. If severe wear is detected, replacement of the rear brake pads is advised. Below is relevant information about the handbrake: 1. Principle: The handbrake, professionally referred to as an auxiliary brake, operates differently from the main braking system. It uses a steel cable connected to the rear brake shoes to apply braking force to the vehicle. Prolonged use of the handbrake can cause the steel cable to undergo plastic deformation. Since this deformation is irreversible, long-term use may reduce its effectiveness and increase the handbrake's travel distance. 2. Associated Components: The handbrake system also includes a return spring. When the handbrake is engaged, the spring is stretched; when released, the spring returns to its original length. With prolonged use, the spring may also experience corresponding deformation.

11

0

Share

Is the Nissan Teana equipped with a CVT transmission?

The Teana is equipped with a CVT transmission from the JATCO brand. JATCO, also known as Jieteke or Jiakete in Chinese, was originally the transmission division of Nissan Motor. In 1999, it became independent as JATCO Transmission Technology Co., Ltd. and later merged with Mitsubishi's transmission division. Currently, it remains under Nissan's control, so it is generally considered a subsidiary of Nissan. The Teana's transmission model is the XTRONIC CVT. A continuously variable transmission (CVT) does not have fixed gear ratios, operating similarly to an automatic transmission. However, the ratio changes continuously rather than in steps like a traditional automatic transmission, resulting in smooth and uninterrupted power delivery. The CVT paired with the 2.0T engine offers even better smoothness, aligning with the Teana's family-oriented positioning. When using the Teana's transmission in daily driving, pay attention to the following points: Do not delay transmission fluid changes for extended periods. Prolonged use of old transmission fluid can damage internal components such as bearings and the housing. Avoid coasting in neutral for long durations. While some experienced drivers of manual transmissions may coast in neutral, doing so in an automatic transmission can cause overheating and create a jolt when shifting back to Drive (D). Never shift into Drive (D) or Reverse (R) before the vehicle has come to a complete stop. Some drivers shift into the opposite gear prematurely to showcase "smooth" driving, but this can severely damage the transmission gears, potentially leading to gear grinding over time. Avoid frequently climbing steep slopes in Drive (D). Automatic transmission vehicles may overheat under high load or upshift too early, reducing climbing power. In such cases, use manual mode to lock in lower gears or switch to sport mode to protect the transmission. Do not tow the vehicle over long distances. If the automatic transmission vehicle breaks down, use a flatbed tow truck to transport it while in Neutral (N). Do not use tow ropes or drag the vehicle directly, as this can damage the transmission.

7

2

Share

What Causes White Exhaust Smoke in Winter?

It is the water vapor produced after gasoline combustion, which is normally discharged through the exhaust pipe. Due to the low ambient temperature, the water vapor condenses into small water droplets, becoming visible water vapor to the naked eye. Here are the relevant explanations: 1. Principle: This occurs because gasoline, when completely burned, produces water and carbon dioxide. Water at high temperatures is in the form of water vapor, which is colorless and transparent. When the ambient temperature is low, the white smoke from the exhaust pipe is water vapor. If the condensed water droplets accumulate, they turn into water. 2. Phenomenon: The water droplets discharged from the exhaust pipe are the result of water vapor generated by gasoline combustion condensing in the exhaust pipe and muffler. When the ambient temperature is low, the water vapor condenses into water droplets on the exhaust pipe walls and is discharged with the exhaust flow. This phenomenon is common in vehicles with well-functioning engines. If you notice jerky driving along with white smoke and water discharge from the exhaust pipe, and the radiator is low on water with signs of bubbling, it is highly likely that the cylinder head gasket is leaking, in which case it needs to be replaced.

8

2

Share

Is Car Loan Service Fee Legal?

Car loan service fees are neither reasonable nor legal. Here is relevant information about car loan service fees: 1. Regulations: According to Article 3 of the "Notice on Rectifying Irregular Operations of Banking Financial Institutions," "Financial institutions must not require customers to accept unreasonable intermediary services or other financial services, thereby charging fees, under the pretext of issuing loans or providing financing in other ways." 2. Legal Perspective: From a legal standpoint, if an automobile sales company induces consumers to choose car loans and charges them a "financial service fee," this constitutes an illegal act of imposing unreasonable conditions. 3. Compensation Method: If defrauded, consumers can claim triple compensation. Article 55 of the "Consumer Rights Protection Law" states: "If a business operator commits fraud in providing goods or services, it shall, at the consumer's request, increase the compensation for the losses suffered by the consumer. The increased compensation shall be three times the price of the goods purchased or the cost of the services received; if the increased compensation is less than 500 yuan, it shall be 500 yuan. If other laws provide otherwise, those provisions shall apply."

20

1

Share

What are the adjustment techniques for the sliding door of a van?

The adjustment techniques for the sliding door of a van include loosening the hinge screws on the body side to raise the hinge installation position; loosening the hinge screws on the body side and moving the hinge backward, with the lower hinge also moved backward. Here are the related instructions: 1. Inspection: For daily maintenance, check whether the limit pin shaft is severely deformed due to wear, causing radial shaking and noise. If this is the case, replace the pin shaft. Check whether the limit pin shaft retaining ring is in its original fixed position to function properly. If the retaining ring has moved from its original position, causing failure, or if it has fallen off, reinstall a new retaining ring. 2. Lubrication: Open the door to its maximum angle, clean the grease and dirt from the surface of the limit arm, limit pin shaft, and connecting bracket, then apply an appropriate amount of lubricant to the upper and lower surfaces of the arm. Use specialized lubricants such as HOTOLUBE by Tiger Head or Kluber's door hinge and slide rail lubricant. Avoid using engine oil or ordinary grease, as they can freeze in winter and emit harmful odors that may affect health. After applying, repeatedly open and close the door 5-8 times to ensure full lubrication of the working parts.

11

0

Share

What is the normal tire pressure for a Highlander?

The normal tire pressure range for a Highlander is 2.4-2.5 bar. Due to seasonal factors, the tire pressure can be appropriately increased by 0.2 bar in winter and reduced by 0.1 bar in summer. This data is based on the international GBT2978-2008 standard. Most Highlander models are equipped with a tire pressure display function. There is a menu option on the steering wheel. After finding the instant fuel consumption, pressing the down arrow key will display the specific tire pressure value. Generally, a tire pressure above 2.8 bar is considered too high, and a tire pressure below 2.0 bar is considered too low. Hazards of excessive tire pressure: The friction and adhesion of the tire will decrease, affecting braking performance; it can cause steering wheel vibration and deviation, reducing driving comfort; it accelerates localized wear of the tread pattern in the center of the tire, reducing tire lifespan; increases vehicle vibration, indirectly affecting the lifespan of other components; it can cause excessive stretching and deformation of the tire cords, reducing tire elasticity and increasing the load on the vehicle during driving. Hazards of insufficient tire pressure: The friction coefficient with the road surface increases, leading to higher fuel consumption; it makes the steering wheel heavy and prone to deviation, which are factors detrimental to driving safety; it increases the movement of various parts of the tire, causing abnormal heat due to excessive rolling; it reduces the functionality of the cords and rubber, leading to delamination or cord breakage and excessive friction with the rim, causing damage to the bead area and abnormal wear; the friction between the tire and the ground increases exponentially, rapidly raising tire temperature, softening the tire, and drastically reducing its strength. High-speed driving under such conditions may lead to a tire blowout. If the tire pressure monitoring indicator light comes on (a yellow symbol with an irregular circle, no stamp on top, four small spikes below, and an exclamation mark inside), there are generally three possible reasons: Abnormal tire pressure: Usually, it will alert if the pressure is below 1.8 bar or above 3.0 bar. In this case, tire inspection and pressure adjustment are required. Tire pressure monitoring not reset: After inflating the tires, the tire pressure was not reset in time, causing the system to still record the previous data, which triggers the tire pressure monitoring indicator light. Simply reset the tire pressure to resolve this. Damaged tire pressure sensor: The tire pressure sensor is used to monitor tire pressure and is directly installed inside the tire, connected to the tire inflation port. If the sensor is damaged due to impact while driving, it can also cause the tire pressure warning light to come on. For sensor damage issues, only replacement with a new part is possible.

11

2

Share

What Do You Need to Bring for the Driving Test (Subject Three)?

What to Do If You Drive a Distance Without Fully Releasing the Handbrake?

Is the Nissan Teana equipped with a CVT transmission?

What Causes White Exhaust Smoke in Winter?

Is Car Loan Service Fee Legal?

What are the adjustment techniques for the sliding door of a van?

What is the normal tire pressure for a Highlander?

What Causes Low Oil Pressure in Sedans?

How to Solve the Jerking Sensation in Automatic Cars?

Where should the needle of the fire extinguisher pressure gauge point to indicate normal pressure?

How to Check the Mileage on a Car Dashboard?