What details should be paid attention to in Subject 3?
2 Answers
Subject 3 requires attention to the following details: Pre-test preparation: Walk around the vehicle once before getting in, and pause briefly when near the monitoring area. After entering the vehicle, fasten the seatbelt first, then adjust the seat and rearview mirrors. Light simulation: Before the light simulation test begins, check if the light switch is reset, and confirm that all lights are completely turned off before requesting to start the test. Starting off: Before starting, always observe the surrounding traffic environment. If you turn the front of the car and then notice a vehicle approaching from behind, you will likely fail the test. During the drive: Keep your eyes looking straight ahead, focusing as far as possible, while continuously monitoring the movements of the vehicle in front, avoiding following too closely.
During the driving test (Subject 3), I had to pay constant attention to details to pass. Before starting, adjust the seat and rearview mirrors to ensure a clear view; after fastening the seatbelt, turn on the left signal, repeatedly check the left and right rearview mirrors and blind spots, and only release the clutch to start when it's safe. When turning or changing lanes, signal at least three seconds in advance, quickly scan the side mirrors, and turn your head to eliminate blind spots. When parking, smoothly pull over with the wheels less than 30 cm from the curb, and only turn off the engine after engaging the handbrake. These actions may seem simple, but any mistake or omission will result in points deduction. Before the test, I repeatedly practiced simulating road conditions, such as timely braking and slowing down when encountering traffic light changes, and maintaining a calm mindset was crucial. Looking back after passing, every detail helped me build driving confidence.
