What Causes the Yellow Light to Flash and the One-Button Start to Fail?

What are the differences between new energy vehicles and traditional vehicles?

New energy vehicles and traditional vehicles mainly have the following differences: 1. Electric vehicles are structurally simpler than fuel-powered vehicles, with fewer moving parts, significantly reducing daily maintenance requirements. They are easier to operate, simpler to repair, and more cost-effective. 2. Electric vehicles cause no environmental pollution as they produce no emissions, whereas traditional vehicles emit a large amount of carbon monoxide, carbon dioxide, hydrocarbons, and other exhaust gases. 3. Traditional vehicles generate noise pollution, primarily caused by the combustion engine, while electric vehicles produce very little noise. Therefore, replacing fuel-powered vehicles with electric vehicles is a major way to reduce urban noise pollution.

1

3

Share

How to reset the maintenance light on ATSL?

To reset the maintenance light on the ATSL, follow these steps: 1. Ensure the engine is turned off. 2. Turn on the ignition and within five seconds, fully depress the accelerator pedal three times. 3. Check the dashboard; if the "Change Engine Oil Soon" message does not appear, the maintenance light has been reset. Additional methods for resetting the maintenance light on the Cadillac ATSL include: 1. Use the driver information center control buttons on the right side of the steering wheel to navigate to the "Oil Life" display on the dashboard. When the remaining oil life is low, a "Change Engine Oil Soon" message will appear. 2. Press and hold the "SEL" button in the driver information center control area for several seconds to clear the "Change Engine Oil Soon" message. 3. After resetting the oil life system, the display will show "Oil Life 100%". 4. If the "Change Engine Oil Soon" message reappears after starting the vehicle, the oil life system has not been reset, and the procedure should be repeated. Be careful not to accidentally reset the oil life display unless the oil has been changed. Accurate resetting should only be done at the next oil change.

11

1

Share

Can You Turn Right at a Red Light Without an Arrow?

You can turn right at a red light without an arrow, but you must be in the rightmost motor vehicle lane before turning right. Under a red light, you can turn right directly in the following situations: Circular traffic light: If the circular traffic light at an intersection turns red, vehicles in the right-turn lane can turn right directly. However, you must be careful not to interfere with other vehicles, as well as pedestrians and vehicles on the road behind and to the right. Arrow-shaped right-turn indicator: If you encounter an arrow-shaped right-turn sign at an intersection, you cannot turn right when the red arrow is lit. If you turn right, you will be considered running a red light. Additional sign on a circular red light: At some intersections with complex road conditions, you may sometimes see a reminder above the traffic light indicating whether you can turn right on a red light. If the prompt says "Turn Right on Red," you can turn right. If it says "No Right Turn on Red," you must wait for the green light before turning. Laws and regulations: According to the "Regulations for the Implementation of the Road Traffic Safety Law of the People's Republic of China," motor vehicle and non-motor vehicle traffic signals indicate: When the green light is on, vehicles are allowed to pass, but turning vehicles must not hinder the passage of straight-moving vehicles and pedestrians. When the yellow light is on, vehicles that have already crossed the stop line can continue to pass. When the red light is on, vehicles are prohibited from passing. At intersections without non-motor vehicle or pedestrian crossing signals, non-motor vehicles and pedestrians should follow the instructions of the motor vehicle traffic signals. When the red light is on, right-turning vehicles can pass if they do not hinder the passage of other vehicles and pedestrians. According to the "Road Traffic Safety Law," the regulations on traffic lights are as follows: Article 25, Paragraph 2 states that traffic signals include traffic lights, traffic signs, traffic markings, and the directions of traffic police. Article 26 states that traffic lights consist of red, green, and yellow lights. A red light indicates prohibition, a green light indicates permission, and a yellow light indicates a warning. Article 38 states that vehicles and pedestrians should follow traffic signals; when directed by traffic police on-site, they should follow the directions of the traffic police; on roads without traffic signals, they should pass under the principle of ensuring safety and smoothness. Article 62 states that pedestrians should use crosswalks or pedestrian facilities when crossing intersections or roads; when crossing at intersections with traffic signals, they should follow the traffic signals; when crossing at intersections without traffic signals or crosswalks, or when crossing roads without pedestrian facilities, they should cross after confirming safety. Article 89 states that pedestrians, passengers, and non-motor vehicle drivers who violate road traffic safety laws and regulations regarding road passage will be given a warning or fined between 5 and 50 yuan; non-motor vehicle drivers who refuse to accept the fine may have their non-motor vehicles confiscated. Driving a motor vehicle in violation of traffic signals will result in a 6-point penalty. Precautions for right turns: Pay attention to straight-moving vehicles on the left: When turning right, you should observe both the right and left sides for vehicle conditions. Pay attention to left-turning vehicles from the opposite direction: In addition to observing straight-moving vehicles, you should also check for left-turning vehicles from the opposite direction. When turning right, pay attention to vehicles on the left, whether they are turning left or going straight, and let them pass first. Pay attention to pedestrians: When turning right, in addition to crosswalks before the intersection, there may also be crosswalks at the corner. Be sure to observe whether there are pedestrians on the crosswalks.

14

5

Share

Is It Serious If the Car's Wheel Hub Gets Scratched?

Scratches on a car's wheel hub can have certain impacts. Below are the specific reasons: 1. Some people may not pay much attention to these scratches, thinking they only affect the appearance. However, car owners should be concerned about whether the scratches will affect the wheel hub's lifespan and driving safety. 2. The scratches left behind can lead to oxidation of the wheel hub, causing the paint to peel off. Over time, this can affect the wheel hub's lifespan, so it should be repaired after being scratched. 3. If the scratches are deep, they may cause deformation of the wheel hub or lead to gaps and cracks. In such serious cases, it is best to replace the wheel hub with a new one.

19

1

Share

What Causes the Noise When Releasing the Brake?

There are several possible reasons for the noise when releasing the brake, as analyzed below: 1. False Fault: This noise is mainly caused by the driver releasing the brake too slowly when starting the car, which is a common issue for many automatic transmission car owners. When the brake pedal is released gradually, the engine is already driving, but since the brake is not fully released, the moving wheels are restrained by the brake system, resulting in noise. 2. True Fault: The noise can also be caused by the brake disc and brake pads sticking together due to rust. This can be fixed by applying butter or special lubricant to the connection between the brake pads and the brake calipers at a repair shop.

19

4

Share

Can a push-to-start car run without the key?

Push-to-start cars can operate without the key, provided the car was initially started with the key present. Here are some details about push-to-start functionality: 1. The principle of push-to-start involves transmitting a signal to the car. Once started, the car can continue driving as long as you press the accelerator. However, if the engine is turned off, it cannot be restarted without the key. 2. Most modern car models now feature push-to-start, significantly reducing the driver's operational complexity. Simply press the brake and push the start button to complete the ignition process, making it very convenient.

17

4

Share

What Causes the Yellow Light to Flash and the One-Button Start to Fail?

What are the differences between new energy vehicles and traditional vehicles?

How to reset the maintenance light on ATSL?

Can You Turn Right at a Red Light Without an Arrow?

Is It Serious If the Car's Wheel Hub Gets Scratched?

What Causes the Noise When Releasing the Brake?

Can a push-to-start car run without the key?

How much content can an 8GB dash cam store?

What type of battery does the Arrizo e use?

Where is the car temperature control switch generally located?

What are the effects of a broken car electric fan?