···
Log in / Register

What Causes the Water-like Noise When Accelerating?

1 Answers
AlexAnn
08/30/25 3:58am

Noise is related to engine speed. Below is a detailed introduction to various engine speed conditions that produce abnormal sounds: Noise occurs only at idle or low speeds: Causes include: excessive clearance between piston and cylinder wall; overly tight piston pin or connecting rod bearing assembly; excessive clearance between tappet and its guide hole; wear on the camshaft profile; sometimes, a loose starter clutch causing pulley noise (noticeable during speed changes). Irregular noise at a specific speed: Brief successive sounds during rapid deceleration. Causes include: cracked camshaft timing gear or loose fastening nut; broken crankshaft; loose piston pin bushing; excessive axial clearance of camshaft or loose bushing. Noise appears during rapid acceleration: Sound persists during high-speed operation. Causes include: loose connecting rod bearings; melted or mismatched bearing shells causing rotation; loose crankshaft bearings or melted bearing shells; broken piston pin; broken crankshaft.

Was this review help?
6
4
Share
More Forum Discussions

Under What Circumstances Will a Car Alarm Trigger?

Car alarms will trigger in cases of illegal door opening, ignition attempts, vibrations, or system tampering. Below is an introduction to car alarm-related information: Basic Information: A car alarm is an alert device installed in vehicles. If someone strikes, impacts, or moves the car, sensors send signals to the controller indicating vibration intensity. Depending on the vibration level, the controller emits warning sounds or activates a full alarm. This serves to deter thieves and alert the vehicle owner. Development Trends: From the 1990s to the present, car alarms have rapidly evolved with increasingly widespread applications. As car alarm technology matures, cost control is no longer a challenge, making car alarms essential equipment for every vehicle owner. In the next decade, onboard GPS receivers will open vast possibilities in the security field.
6
1
Share

Why does the Nissan Tiida key fault light stay on?

It is necessary to check whether the battery power of the remote control is insufficient. The following is the explanation of the car fault code: 1. Car fault code: The car fault code is the fault code reflected by the car computer ECU after the car has a fault. Therefore, the car has a fault at this time and the fault light stays on at this time. To completely eliminate the fault, a professional decoder (K81, laptop computer, etc.) is required to decode, which is commonly referred to as fault elimination. 2. Types of fault codes: Fault codes include real codes, historical codes and sporadic codes. Real codes are easy to check. Historical codes, as the name implies, are fault codes left over from the past that have not been cleared, but sporadic fault codes are not fixed.
10
3
Share

What are the tips for using paddle shifters?

Tips for using paddle shifters: 1. Depress the clutch and release the accelerator; 2. Quickly shift the gear lever from second to third gear; 3. Observe the engine tachometer, and when the RPM drops to 1,686, follow the clutch release operation to enter the semi-clutch state. As a quick shifting device, paddle shifters can enhance driving operability to a certain extent. When operating paddle shifters, drivers generally only need to shift into D, S, or manual mode. With paddle shifters, drivers can complete gear shifts without taking their hands off the steering wheel. Automatic transmission vehicles equipped with paddle shifters are undoubtedly semi-automatic, because the function of paddle shifters is to shift up or down. Although manual mode is used, the essence of the transmission remains an automatic transmission.
20
0
Share

What Causes Wavy Patterns in Car Paint Reflections?

Wavy patterns in car paint reflections are mainly caused by the following symptoms and their corresponding solutions: 1. Dirt Spots: This occurs when the paint booth is not properly cleaned during the painting process, leading to imperfections after painting. The general repair method involves sanding and polishing the paint surface. If the dirt spots are large or located in the underlying layers, a rework may be necessary. 2. Water Spots: This issue arises due to environmental humidity and inadequate maintenance of the air pump, which causes water accumulation in the painting lines. Typically, this problem is addressed by sanding and polishing based on the paint thickness. Otherwise, a rework might be required. 3. Solution: Glue Repair. As described above, if transparent spots appear, it means the painter has found small pits or dirt spots on the paint surface after painting and has used glue drops for repair.
6
4
Share

How to Open the Panoramic Sunroof on the X-Trail?

The panoramic sunroof switch on the X-Trail uses a rotary knob-style switch commonly found in Nissan vehicles. Sliding the knob controls the opening area of the sunroof and closes it. The advantages of the panoramic sunroof are as follows: 1. Due to its large area, it can better maintain fresh air inside the vehicle and quickly remove odors compared to regular sedans. 2. At high speeds, it is more effective in reducing interior noise compared to side windows. 3. It can rapidly lower the interior temperature, allowing a car exposed to the sun to cool down faster. 4. The panoramic sunroof is essentially a larger version of a regular sunroof, often featuring a full glass roof, providing an unobstructed view of the sky. It does not compromise the structural safety of the vehicle, making it a standout feature in mid-to-high-end cars.
8
4
Share

What car is the dx7?

dx7 is a compact car under the Southeast brand. The relevant introduction about dx7 is as follows: 1. The body dimensions of this car are 4585mm in length, 1900mm in width, and 1718mm in height. 2. dx7 uses two engines, one is a 1.5-liter turbocharged engine, and the other is a 1.8-liter turbocharged engine. 3. The 1.5-liter turbocharged engine of dx7 has a maximum torque of 156 horsepower and 215 Nm, and is matched with a 6-speed manual transmission or 6AT transmission. 4. The 1.8-liter turbocharged engine of dx7 has a maximum torque of 197 horsepower and 285 Nm, and is matched with a 6-speed dual-clutch transmission. 5. The front suspension of dx7 uses MacPherson independent suspension, and the rear suspension uses multi-link independent suspension.
15
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.