What Causes the Vehicle to Pull to One Side When Braking?

Can You Change Lanes When There's a Dotted Line Next to a Solid Line?

One side is a dotted line and the other is a solid line. You can change lanes in this case, but only from the dotted line side to the solid line side, and the lane change must be completed within the dotted line segment. If you exceed the end of the dotted line, it counts as driving over the line. Here are some precautions to take when changing lanes at a dotted line: 1. Violations: During peak traffic hours, do not force a lane change, as this may disrupt the normal flow of traffic behind you and could result in penalty points or fines. Additionally, when waiting in line at a traffic light, if the queue extends to the dotted line area, some drivers might try to squeeze into the adjacent lane if the vehicles there are slow to start. This is also considered a violation. 2. No consecutive lane changes: Even if the road is clear, you cannot change more than two lanes consecutively in a dotted line lane. Consecutive lane changes are a violation and can result in a 3-point deduction and a fine.

5

Share

Which Cars Can Drive Autonomously?

Currently, autonomous driving cars include: Tesla Model X, Volvo XC90, Audi Q7, Volkswagen Tayron, and Geely Binyue. The expansion of autonomous vehicles is as follows: 1. Definition: Autonomous vehicles, also known as driverless cars or computer-driven cars, are unmanned ground vehicles with transport power. 2. Levels: Level 0 is completely operated by the driver; Level 1 means the car can assist the driver in completing certain driving tasks under specific conditions; at Level 2, autonomous driving can complete certain driving tasks, but the driver needs to constantly monitor the surrounding environment and be ready to take over in case of danger, which is the autonomous driving technology that many current autonomous vehicles have achieved; Level 3 means the driver hardly needs to be ready to take over, and the car can independently complete all actions; Levels 4 and 5 represent fully autonomous driving technology, where the car no longer requires driver control, with the difference being that Level 4 is fully independent only under specific conditions such as highways, while Level 5 operates under any conditions.

20

5

Share

Where is the Audi Brake Pedal Located?

Audi's brake pedal is essentially the foot brake. Function of the Brake Pedal: For small vehicles descending long slopes: It is recommended to use lower gears and rely on engine braking to decelerate, minimizing the use of the brake pedal. For large vehicles descending long slopes: Large vehicles or heavily loaded trucks must avoid prolonged braking; engine braking must be utilized for deceleration. Pedal Position: The brake pedal, commonly referred to as the foot brake, features a small pedal connected to the brake lever, hence also called the brake pedal. Similarly, the clutch has a small pedal known as the clutch pedal—the clutch is on the left, and the brake is on the right.

18

5

Share

What causes a sudden complete power loss in a Buick GL8?

Buick GL8 sudden complete power loss may be caused by prolonged vehicle parking leading to battery discharge, battery reaching the end of its service life, engine damage, or insufficient battery electrolyte. Below are detailed explanations: 1. Car battery: Also known as storage battery, it's a type of battery that works by converting chemical energy into electrical energy. Typically, what people refer to as batteries are lead-acid batteries. These are mainly composed of lead and its oxides, with sulfuric acid solution as the electrolyte. Ordinary batteries have plates made of lead and lead oxides, with sulfuric acid solution as the electrolyte. Their main advantages are stable voltage and low cost; disadvantages include low specific energy (the amount of electrical energy stored per kilogram of battery), short service life, and frequent maintenance. 2. Dry-charged lead-acid battery: Its main characteristic is that the negative plate has high electrical storage capacity. In a completely dry state, it can preserve the obtained charge for two years. When in use, you only need to add electrolyte and wait 20-30 minutes before it can be used.

3

Share

Why Are There Many Rust Spots on the Hood of the Chery Arrizo 5?

The reason for rusting is insufficient anti-rust treatment of the components. Precautions for car rust: Most cases of paint rust are caused by collisions, scratches, or other damage to the paint surface, which gradually leads to rust spots. This may not significantly affect the car's functionality but can be very unsightly. Handling methods: For minor paint damage like scratches, you can use water sandpaper to remove the rust. Wet the sandpaper and carefully sand away the rust—avoid random or careless sanding. After removing the rust, apply primer yourself. However, if the paint damage is severe, it's best to visit a professional auto body shop for repainting as soon as possible. The more severe the rust, the more troublesome it is to fix.

14

4

Share

Under What Circumstances Should You Not Press the Brake Pedal?

You should not press the accelerator pedal when shifting gears because during gear shifting, the engine and transmission gears are in a separated state. Pressing the accelerator pedal at this time means the engine's power cannot be transmitted to the transmission, resulting in wasted effort, fuel consumption, and potential gear wear. Below is relevant information about car pedals: 1. Clutch Pedal: Most clutches use hydraulic assistance. If air enters this hydraulic system, it can cause incomplete clutch disengagement and difficulty in shifting gears. This is reflected in the pedal feel as a loose and spongy sensation, as if stepping on air. 2. Brake Pedal: The brake pedal is the largest and sturdiest among the three pedals. Its function is to slow down or stop the car. Different car models have varying brake sensitivity and pedal travel, which are related to the manufacturer's tuning. 3. Accelerator Pedal: The brake pedal is used to control the car's speed. Pressing the accelerator pedal increases the engine's RPM and power output, while releasing it decreases the engine's RPM and power.

1

4

Share

What Causes the Vehicle to Pull to One Side When Braking?

Can You Change Lanes When There's a Dotted Line Next to a Solid Line?

Which Cars Can Drive Autonomously?

Where is the Audi Brake Pedal Located?

What causes a sudden complete power loss in a Buick GL8?

Why Are There Many Rust Spots on the Hood of the Chery Arrizo 5?

Under What Circumstances Should You Not Press the Brake Pedal?

What does the EPC light on the Passat dashboard mean?

Which company produces NIO's batteries?

Where is the Dongfeng Fengguang 500 engine produced?

What is the curb weight of the Emkoo?