What Causes the Tire Pressure of a New Car to Drop to 1.9bar?

1 Answers
CeciliaFitz
07/29/25 12:27pm
The tire pressure of a new car drops to 1.9bar because the vehicle has been parked for too long, causing the tire pressure to decrease. When the car leaves the factory, the tire pressure is usually closer to the upper limit of the safe range. However, as the car remains parked for an extended period, the tire pressure will naturally decrease. Some manufacturers intentionally lower the tire pressure to prevent excessively high speeds. Since the car is new, it requires an adaptation period. During this period, reducing the tire pressure slightly helps prevent traffic hazards caused by high speeds. Tire damage: If there is an issue with the tires at the time of delivery or if the tires are punctured during use, the low tire pressure alarm in a new car should prompt a thorough inspection to check for any tire damage. Hazards of low tire pressure: Increased fuel consumption: Low tire pressure increases the contact area between the tires and the ground, thereby increasing friction and driving resistance, which naturally leads to higher fuel consumption. Shortened tire lifespan: Similarly, due to the larger contact area with the ground, tire wear is accelerated, reducing the overall lifespan of the tires. Increased risk of blowouts: The rise in friction causes the tire temperature to increase, making the tires softer and weaker. When the tires can no longer support the vehicle's load, especially during high-speed driving, the risk of a blowout becomes significantly higher.
Was this review help?
17
5
Share
More Forum Discussions

Why don't diesel engines use spark plugs for ignition?

This is because diesel has a relatively low ignition temperature. Here are the relevant explanations: 1. Introduction: With the motor driving the crankshaft to operate, it drives the engine's crank connecting rod mechanism, valve mechanism, fuel supply mechanism, etc. After intake and compression, the temperature of the compressed air at the end of compression reaches above 700 degrees. At this time, high-pressure diesel is injected into the cylinder in a mist form from the fuel injector, and the formed mixture is immediately ignited, pushing the crankshaft to continue operating. 2. Compression ignition: Diesel engines directly compress the mixture of air and fuel to the ignition point, causing spontaneous ignition, which is called compression ignition. There is no need for an external spark to ignite, so spark plugs are not used. Gasoline engines have a lower compression ratio compared to diesel engines and require ignition to make the gas in the cylinder combust.
20
3
Share

Is the Windshield Covered by Insurance?

If you have comprehensive glass insurance, you can file a claim for damage. However, if you only have front windshield insurance, it won't cover other glass parts, as typically only the front windshield is insured. Below is relevant information: 1. Insurance Claims: Insurance claims refer to the process where, when the insured property suffers damage or the insured's life is harmed due to an insured event, or when other insured events specified in the policy require payment of insurance benefits, the insurance company fulfills its compensation or payment obligations as per the contract. This directly reflects the function of insurance and the fulfillment of insurance responsibilities. 2. Documents Required for Insurance Claims: Original and photocopy of the motor vehicle insurance policy and endorsement; Notification of motor vehicle insurance claim and loss; Photocopy of vehicle registration and driver's license; Receipt for claim payment.
3
2
Share

What Causes the Driver's Side Window Button to Stop Working?

The reason the driver's side window button malfunctions is that the copper strips on the button's circuit board lose their elasticity under external pressure, leading to failure. Below is some information about car windows: 1. Introduction: Car windows are openings in the vehicle's walls designed to shield against wind and rain without obstructing visibility. They are typically made of glass materials, which have evolved significantly over time. Most automotive glass is made of silica glass, with silicon dioxide content exceeding 70%. 2. Types: Car windows are generally categorized into four types: front and rear windshields, ventilation windows, heat-insulating side windows, and sunroofs. The front and rear windows of a car usually feature curved glass that enhances visibility and aesthetics, secured to the frame with rubber seals or specialized adhesives.
8
4
Share

Why is the rear wheel of the car not turning?

The specific reasons for the rear wheel not turning are controller damage, inter-turn short circuit, etc. The details are as follows: Controller damage: Because the controller (three-phase AC inverter) suddenly breaks down due to high heat, it also causes a short circuit between the components of the output three-phase power supply. When pushing, the motor is in a short-circuit power generation state (working in the energy-consuming braking state), making it very difficult to push. Inter-turn short circuit: It is caused by a sudden inter-turn short circuit inside the motor. At this time, the pushing resistance will also be very large, and you can only find a vehicle to tow it to the repair shop for motor repair. The brushless motor of the electric vehicle is a permanent magnet three-phase AC motor, which will be in a power generation state when pushing. If there is a short circuit in the output, it cannot be pushed.
12
4
Share

How to Drive an Automatic Transmission Car at High Speed?

Methods for driving an automatic transmission car at high speed: First, check if there is a manual mode. If there is a manual mode, switch to manual mode and keep each gear at a high RPM for one or two minutes; if there is no manual mode, shift to L gear if available or S gear if available, press the accelerator to maintain a high RPM for one or two minutes. Driving at high speed allows all components of the car to break in and match, especially the transmission gears, which can achieve better break-in. It also improves the atomization effect of the fuel injector, making gasoline burn more fully. Due to the high-speed movement of the piston, the temperature in the cylinder is higher, and the flow and speed of air entering and exiting the valves are also high, resulting in more complete combustion. Driving at high speed helps remove carbon deposits from the valves.
4
2
Share

What is the speed limit on Russian highways?

Russian highways have a speed limit of 100 km/h. Russian speed limit regulations: National highways have a speed limit of 90 km/h, while urban areas have a speed limit of 60 km/h. Russian traffic rules: In Russia, vehicles drive on the right side of the road, the same as in mainland China. Due to Russia's vast territory and long winters, please ensure your vehicle is equipped with winter tires and drive at reduced speeds. Since English is not commonly spoken in Russia, road signs are displayed in Russian, so it's advisable to plan your route in advance. Headlights must be turned on at all times while driving. Local drivers tend to drive at relatively high speeds, so please pay attention to road safety. According to Russian traffic regulations, driving a dirty vehicle is prohibited. Violating this rule typically results in a fine ranging from 800 to 2,000 rubles.
16
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.