Browse

Antiques Collectibles Apparel Baby Kids Items Books， Movies And Music Electronics Free Stuff Garden Outdoor Health Beauty Home Goods Home Improvement Supplies Musical Instruments Office Supplies Pet Supplies Sporting Goods Ticket Toys Games Transportation Others

Used Cars New Cars Others

Business Crafts Design And Web Events Home Improvement Legal Lessons Personal Pets Photography Repair And Technical Support Wellness Writing， Translation， And Transcription Others

Activities & Groups Artists & Musicians Classes & Lessons Events Friendship & Networking Lost & Found Rideshare Sports Teams Volunteers Travel & Travel Partners Skills & Language Swap Other

What Causes the Steering Wheel of Volvo S90 to Make Abnormal Noises When Turning?

1 Answers

McHayden

07/29/25 9:23pm

Abnormal noises when turning the steering wheel may include sounds from the turn signal reset, noises from the steering column dust cover, sounds emanating from within the steering wheel, noises from the shock absorber plane bearing, or sounds from the stabilizer bar. Here are the specific details: 1. Sounds from the turn signal reset: If the turn signal is activated while turning, the noise might be from the rebound clip of the automatic turn signal reset mechanism. This situation requires confirmation. If it is indeed the case, then this is a normal occurrence. 2. Noises from the steering column dust cover: If the noise comes from below the steering wheel, it might be from the steering column dust cover. Due to insufficient lubrication of the dust cover, friction sounds can occur. In this case, applying some grease inside the dust cover will eliminate the noise. 3. Noises emanating from within the steering wheel If the noise comes from inside the steering wheel, the issue is most likely caused by the airbag clock spring inside. Remove the steering wheel airbag clock spring and apply some grease to see if the noise persists. If it still occurs, replace the airbag clock spring as it may be damaged. Be gentle when removing the steering wheel, or disconnect the airbag fuse to prevent the airbag from deploying. 4. Noises from the shock absorber plane bearing: If the noise originates outside the vehicle, it might be due to insufficient lubrication of the shock absorber plane bearing. Open the hood and listen to see if the noise is coming from the shock absorber top mount. This will confirm if the noise is from the plane bearing. Applying grease to the plane bearing may help. If the noise persists after greasing, replacement is necessary. 5. Noises from the stabilizer bar: If the noise is not from the shock absorber, check if the stabilizer bar bushings are loose or damaged. Loose or damaged stabilizer bar bushings can cause noises not only when turning the steering wheel but also when driving over uneven roads. Loose bushings can be fixed by adding shims, but damaged ones must be replaced.

Was this review help?

5

2

Share

More Forum Discussions

What Causes Gear Shift Jerking in the Mistra?

Reasons for gear shift jerking in the Mistra: Excessive carbon buildup on engine valves: Excessive carbon deposits on the engine throttle require cleaning. Jerking during driving is related to the engine, as ignition, air intake, and fuel injectors collectively determine fuel combustion, which is the source of engine power. If the air intake decreases, ignition weakens, or fuel injection reduces, the power output will be insufficient, resulting in a jerking sensation. Abnormal oil pressure: During the break-in period of a new car, slight jerking during driving is normal because the vehicle's power output and component engagement are not at their optimal levels. Additionally, the transmission computer has a self-learning mechanism that continuously adjusts oil pressure for gear shifting.

How Many Years Can the Original Built-in Tire Pressure Monitoring Last?

Built-in tire pressure monitoring sensors typically have a battery life of about 2-3 years, primarily depending on the designed power consumption. Below is relevant information: 1. Built-in tire pressure monitoring: This refers to sensors installed between the tire and the wheel rim, replacing the original valve stem. Therefore, professional tire shops are required for installation, and dynamic balancing must be performed. Advantages include: high accuracy in tire pressure measurement, theft and loss prevention, no need to remove the sensor when inflating tires, and a one-time installation for long-term use. 2. Tire pressure monitoring: This system automatically monitors tire pressure in real-time while driving, alerting to tire leaks and low pressure to ensure driving safety. When tire pressure is too high, the contact area between the tire and the ground decreases, increasing the pressure on the tire and affecting its grip.

How to Replace the Battery in a Car Remote Key?

Here is the method to replace the battery in a car remote key: 1. If the car remote key has a protective cover and key ring, remove them first. 2. Flip the car remote key to the backside, where you will see the rear cover divided into two parts. 3. Insert a flat-head screwdriver into the gap and gently pry upwards to lift a part of the rear cover. 4. Move the screwdriver along the gap to both sides, gradually widening the gap, until the entire rear cover is lifted. 5. On one side of the battery, you will see a protruding clip. Press the battery at the clip part, and the battery will pop up. Slide the battery towards the opposite side to remove it. 6. Prepare a new battery of the same model and insert it into the car remote key in the reverse direction of removal. 7. Align the rear cover with the car remote key and place it from the top. Press down gently to secure it.

What is the reason for the Audi A6L's hazard lights flashing rapidly continuously?

Audi A6L's hazard lights flashing rapidly continuously is caused by the power not being completely cut off, or a malfunction in the control box or hazard light relay. The following is an introduction to the car's hazard lights: Car Hazard Lights: Car hazard lights, correctly referred to as hazard warning flashers. According to traffic regulations, they must be used under certain road conditions. Use of Hazard Lights: When a vehicle breaks down or is involved in a traffic accident on the road, the hazard lights should be turned on to alert passing vehicles. When towing a faulty vehicle, both the towing vehicle in front and the towed faulty vehicle behind should turn on their hazard lights simultaneously to inform other vehicles on the road to maintain distance and be aware that there is another vehicle behind. When driving on the road and slowing down due to vehicle malfunction or other factors, turning on the hazard lights alerts other vehicles to detour or overtake.

How Often Should the Spark Plugs on a Jeep Cherokee Be Replaced?

How Often Should the Spark Plugs on a Jeep Cherokee Be Replaced? The spark plugs should be replaced every 40,000 kilometers. Methods to Determine if a Spark Plug is Damaged: Remove the spark plug and observe its condition based on the following appearance colors. A normal spark plug's insulator skirt and electrodes appear gray-white, gray-yellow, or light brown. A properly functioning spark plug has a reddish-brown insulator skirt, an electrode gap between 0.8-0.9mm, and no signs of electrode burning. If the spark plug is covered in oil or deposits but is not damaged, it can continue to be used after cleaning off the oil and deposits. If the spark plug is severely damaged, with signs such as blistering at the top, black streaks, cracks, or melted electrodes, the cause of the damage should be identified. After troubleshooting, replace the spark plug with a new one. Additionally, if the spark plug appears black as if smoked, it indicates that the wrong heat range was selected or that the air-fuel mixture is too rich, with oil creeping up.

What is the manual method to deactivate the Haima anti-theft system?

Use a diagnostic computer to read the fault codes from the anti-theft system to determine whether it is a wiring issue or another cause. If it is confirmed that the anti-theft system is truly locked, the only solution is to replace the anti-theft control box and then perform a matching procedure. There is no manual method to deactivate it. Here is some related information about Haima: 1. Logo: The logo of Haima Automobile features an abstract eagle shape embedded in a circle symbolizing the sun, representing "the rising sun and the soaring roc." It embodies the company's image of striving upward and aspiring to soar. 2. Models: From the launch of its first HX6380 hatchback in 1991 to the "Familia II" in 2006, Haima Automobile introduced a total of 30 models across 17 series in 15 years. Among them, the "Premacy" and "Familia" series played a pivotal role in reversing the company's difficult situation.

Trending Ranking

What is the fuel consumption of the Bugatti Veyron?

Where to Get Maintenance and Repair for Sehol?

What engine is used in the Skoda Karoq?

What is the normal idle speed for a cold engine?

Where is the drainage hole for the 10th generation Accord's door?

In which year was the Volkswagen T-Roc released?

Can you turn right when there is a dotted line next to the right turn?

How to remove the rear taillight of a Volkswagen Polo?

How to Use Vehicle Wipers?

What is the weight of the Viloran?

More Forum Discussions

Will Failing to Align the Rearview Mirror Lead to Disqualification?

What is the bolt pattern of the Geely Binrui wheel hub?

Why is the airbag light on in the Pajero?

Does the 2013 Audi A8 Executive Edition have keyless entry?

Help

Cookie

Cookie Settings

© 2025 Servanan International Pte. Ltd.