What Causes the Steering Noise in Changan Eado at Low Speeds?
2 Answers
Changan Eado produces steering noise at low speeds for the following reasons: 1. Sound from the turn signal reset. If the turn signal is activated during steering, the noise may come from the rebound clip of the automatic reset mechanism of the turn signal, which is normal. 2. Noise from the steering column dust cover. If the noise comes from below the steering wheel, it may be from the steering column dust cover. Due to lack of lubrication in the dust cover, friction sound occurs during steering. Applying some grease inside the dust cover can eliminate the noise. 3. Noise from inside the steering wheel. If the noise comes from inside the steering wheel, it may be from the airbag clock spring. Remove the steering wheel airbag clock spring and apply some grease to see if the noise persists. If it does, the airbag clock spring may be damaged and needs replacement. 4. Noise from the shock absorber top bearing. If the noise comes from outside the car, it may be due to lack of lubrication in the shock absorber top bearing. Open the hood to check if the noise comes from the shock absorber top mount. If confirmed, applying grease to the top bearing can eliminate the noise. If the noise persists after greasing, the top bearing needs replacement at a repair shop.
My Changan Eado keeps making a clunking noise when turning at low speeds. After careful observation, I found that worn and loose internal parts of the steering gear can produce this kind of sound. During the last maintenance, I noticed the dust cover was slightly cracked—once it's broken, sand and gravel get inside, causing the gears to grind and clatter. Pay extra attention to abnormal noises when turning the wheel to its limit—it's likely the CV boot is failing. When this part goes bad, the lubricant in the universal joint leaks out, leading to metal-on-metal contact, which naturally causes noise. Actually, aging rubber components in the suspension can also be problematic, especially when going over speed bumps while turning, producing creaking sounds—most likely due to worn control arm bushings. For safety, it's best not to delay. Take advantage of the next maintenance to lift the car and check if any suspension bolts are loose.
