What Causes the Squeaking Noise at the Rear of a Scooter?

1 Answers
LaXavier
07/29/25 7:55pm
Squeaking noises near the rear wheel are generally caused by worn brake pads or issues with the rear wheel bearings. Internal wear or rust in the pulley, as well as poor lubrication, can also produce sounds, though these typically don't result in squeaking. It's advisable to first inspect the rear brakes and wheel bearings. Related explanations are as follows: 1. Normal phenomenon: When starting the engine, especially in cold temperatures, the engine may run unevenly due to low temperature, which is a relatively normal occurrence. Additionally, during cold starts, the engine oil hasn't fully lubricated the components. Accelerating immediately in this state can increase engine wear. 2. Warm-up: After starting, it's recommended to let the engine warm up idly until it reaches operating temperature and the throttle responds smoothly before riding. This prevents throttle hesitation and significantly reduces wear during cold starts, which is crucial for minimizing engine failure rates and extending its service life.
Was this review help?
5
3
Share
More Forum Discussions

What engine does the Volkswagen Teramont use?

Volkswagen Teramont uses a total of three engines, which are the low-power version of the 2.0-liter turbocharged engine, the high-power version of the 2.0-liter turbocharged engine, and the 2.5-liter V6 turbocharged engine. The Teramont is a mid-to-large-sized SUV under Volkswagen, with a wheelbase of 2980 mm, and its length, width, and height are 5039 mm, 1989 mm, and 1773 mm respectively. The low-power version of the 2.0-liter turbocharged engine in the Volkswagen Teramont delivers 186 horsepower and a maximum torque of 320 Nm; the high-power version of the 2.0-liter turbocharged engine delivers 220 horsepower and a maximum torque of 350 Nm; the 2.5-liter turbocharged engine delivers 299 horsepower and a maximum torque of 500 Nm.
16
3
Share

How to Disassemble a Hyundai Mistra Key?

Hyundai Mistra key disassembly method: 1. Remove the mechanical key from the smart key, which is the L-shaped key; 2. Carefully observe the top of the smart key, where there are deep and shallow slots. Use the L-shaped key to pierce through the shallow slot of the smart key all the way to the bottom, and the back cover of the smart key will automatically pop out. The Hyundai Mistra is a mid-size sedan under the Hyundai brand. The dimensions of this car are 4710 mm in length, 1820 mm in width, and 1470 mm in height, with a wheelbase of 2770 mm. In terms of power, the Hyundai Mistra is equipped with two engines: one is a 1.6-liter turbocharged engine, which delivers 175 horsepower and a maximum torque of 265 Nm; the other is a 1.8-liter naturally aspirated engine, producing 143 horsepower and a maximum torque of 176 Nm.
3
5
Share

What are the routine maintenance methods for new energy vehicles?

Routine maintenance methods for new energy vehicles: 1. Correctly grasp the charging time. If the red and yellow lights on the battery gauge illuminate during normal driving, you should charge the vehicle to avoid over-discharging. The charging time should not be too long, as overcharging can cause the battery to heat up and shorten its lifespan. 2. Protect the charger. During the charging process, ensure the charger is well-ventilated; otherwise, it may not only reduce the charger's lifespan but also potentially damage the battery. 3. Maintain sufficient power. After daily use of a new energy vehicle, it is necessary to charge it promptly. If the daily mileage does not exceed 20 kilometers, it is generally recommended to recharge every two days. For daily mileage exceeding 50 kilometers, the vehicle should be charged on the same day to keep the battery fully charged. 4. Cleaning the electric vehicle. Electric vehicles also require timely cleaning. During cleaning, care should be taken to prevent water from entering the charging socket inside the vehicle, ensuring proper waterproofing measures are in place.
5
5
Share

What could be the issue when a Sagitar car won't start but has power?

If the battery has power but the engine won't start, there are generally two scenarios. The first is when attempting to start the vehicle, there is no response at all. The second is when attempting to start the vehicle, there is a starter motor sound, but the engine either fails to start or starts and then immediately stalls. 1. No response when attempting to start the vehicle: For some manual transmission vehicles, not depressing the clutch pedal can prevent the engine from starting. It is recommended to shift into neutral, depress the clutch pedal, and attempt to start the vehicle again. Starter motor failure. After prolonged use, the starter motor may develop faults, resulting in no response when attempting to start the vehicle. 2. Starter motor sound is present, but the engine fails to start or starts and then immediately stalls: Check the fuel level indicator to confirm if there is sufficient fuel in the tank. Poor fuel quality or excessive carbon buildup can lead to incomplete combustion, making the engine prone to stalling.
9
1
Share

How to use the automatic parking feature of the Mercedes-Benz GLC?

Usage method of the automatic parking feature in Mercedes-Benz GLC: 1. When the vehicle speed is below 30 mph, the automatic parking feature will activate automatically, and all prompts will be displayed on the central control screen; 2. After detecting a parking space, use the confirmation button on the steering wheel controls to select the parking mode; 3. The central control display will indicate whether it is a longitudinal or transverse parking space, and you can also adjust the display angle of the car's reversing camera; 4. After detecting the parking space, the owner needs to make the selection; 5. Once parking begins, the car system will automatically take over operations such as steering, gear shifting, and braking. The Mercedes-Benz GLC is a mid-size SUV under the Mercedes-Benz brand, with dimensions of 4764 mm in length, 1898 mm in width, and 1642 mm in height, and a wheelbase of 2973 mm.
8
1
Share

Can You Wax After Coating?

You can wax your car after coating because the coating itself does not have waterproofing functionality; it merely forms a hard protective film on the paint surface. Waxing can then provide waterproofing effects. However, it's important to note that coatings have hydrophobic properties, making them fully effective against ordinary rainy conditions. If the weather is not particularly harsh, waxing may not be necessary after coating. Advantages of Car Coating: High Gloss: The transparent and clear coating layer provides an extreme mirror-like effect, 2-3 times thicker than ordinary coatings, without reducing brightness. Antioxidant Properties: The silicone in the coating material is rich in protective agents, while titanium dioxide, a primary component in sunscreen, offers stability. Together, they form a protective layer on the car's paint surface that can last up to three years.
5
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.