What Causes the Rubber Seal on the Car Chassis to Fall Off?

1 Answers
AndresFitz
07/30/25 6:40am
It may be caused by aging or loosening of the rubber seal on the car chassis. Here is extended information about rubber components: 1. Leak prevention and isolation: It serves as a seal to block wind, dust, and water. Without it, metal would directly contact metal when closing the door, leading to deformation gaps over time, increased noise, and reduced air conditioning efficiency. It can be used with paper gaskets or directly applied to various shell contact surfaces as a rubber pad, or utilized for its adhesive properties to attach plastic films. 2. Precautions: It is recommended not to remove the buffer rubber pads to prevent door deformation, as they are directly linked to the safety of the driver.
Was this review help?
17
3
Share
More Forum Discussions

Why is the Audi airbag light on?

Here are the reasons why the Audi airbag light is on: Loose or poor contact in the wiring: Start with the simplest check by inspecting the airbag wiring under the seat. If the connector is loose, simply plug it back in securely. Airbag sensor malfunction: Replace the driver-side side airbag sensor. To diagnose airbag issues, check the seat belt sensor, airbag connectors, and airbag sensors. Airbag control unit failure: Replace the airbag control unit. If there are fault codes present, specialized equipment is needed to clear them. Here is some extended information about Audi cars: Models under the brand: Audi A3, Audi A5, Audi A6L, Audi Q3, Audi S4, etc. Introduction to the Audi A6L: It features a five-link independent suspension at the front and rear, powered by a 2.0T turbocharged engine with a maximum output of 190 PS, 140 kW, and 320 Nm of torque. It is paired with a 7-speed dual-clutch transmission. Audi is a German luxury car brand, symbolized by four interlocking rings. It is one of the oldest car manufacturers in Germany.
15
4
Share

Land Rover Discovery Sport Wading Depth?

Maximum wading depth is approximately 600mm. Additional information: Specific details: This vehicle's wading capability allows for a maximum depth of 600mm, roughly the height of the wheel arch upper edge. The wading sensing feature provides real-time depth alerts, significantly boosting driver confidence during navigation. However, during actual off-road adventures, caution is advised—never proceed without verifying water depth when visibility is compromised. Always stop and assess safety before continuing. Technical rationale: The air intake connects directly to the hood, optimally positioning it above water levels. While intake placement is primary, other factors like electronic component locations also critically influence wading performance.
18
0
Share

Where is the air filter element of Haojue 125 located?

Inside the right side cover of the motorcycle body. Extended information: Specific air filter element location: The air filter element of Haojue 125 motorcycle is located inside the right side cover of the body. Remove the right side cover and unscrew the screws of the air filter housing to see the air filter element, which is shaped like a sponge barrel. It can be cleaned or replaced according to the specific usage conditions. Specific method to remove the lock cover: To remove the right side cover of this model, first open the side cover lock, then pull the front of the side cover downward. After the front is pulled down, pull the side cover forward to remove it. Do not use excessive force during disassembly to avoid damaging the plastic side cover.
19
2
Share

Will the Tiguan automatically lock if the doors are left unlocked?

High-end models can. Additional information: High-end version: The high-end version of the Tiguan is equipped with Volkswagen's new technology, which automatically detects the infrared key. The key in your pocket will be automatically detected when near the door handle, automatically unlocking the doors. Similarly, it will automatically lock the car when you leave. Precautions when locking the car: When locking the car, it is more reliable to use the mechanical key, as this makes any interference devices ineffective. If you don't mind the inconvenience, using the mechanical key more often can save power and is even safer than using the smart key. When using the mechanical lock, make sure the doors are properly closed and you hear the sound of all doors locking; otherwise, the car has not been successfully locked.
1
0
Share

Is the Changan Oushang X5 equipped with the Blue Whale engine?

Yes, it is equipped with the Blue Whale engine. Additional information: Engine introduction: The Blue Whale engine is a turbocharged engine and also a naturally aspirated engine. It is a 1.6-liter four-cylinder naturally aspirated engine with a maximum power of 132 kW and a maximum torque of 300 Nm. Vehicle introduction: The Changan Oushang X5 is a compact SUV under the Changan brand. The dimensions of this vehicle are 4490mm in length, 1860mm in width, and 1580mm in height, with a wheelbase of 2710mm. This model is equipped with two types of engines: one is a 1.6-liter naturally aspirated engine, and the other is a 1.5-liter turbocharged engine.
5
2
Share

What is the real fuel consumption of the JAC Refine M4 gasoline version?

The comprehensive fuel consumption of the JAC Refine M4 gasoline version is 9.3-10.0L/100km. Currently, there are 6 models of the JAC Refine M4 gasoline version on sale: the manual comfort version, manual business travel version, manual business version, with a comprehensive fuel consumption of 9.3L/100km. The manual business version (China VI) and manual comfort version (China VI) have a comprehensive fuel consumption of 9.6L/100km. The automatic business travel version has a comprehensive fuel consumption of 10.0L/100km. The above figures are NEDC comprehensive fuel consumption, which is the fuel consumption data measured under the NEDC test procedure. The real fuel consumption is higher than this value, ranging from 8.0-13.5L. The fuel consumption of a car is directly related to five major factors: driving habits, the car itself, road conditions, natural wind, and environmental temperature. The specific factors that can increase a car's fuel consumption are as follows: Driving habits: Aggressive driving, such as sudden acceleration, frequent overtaking, and not releasing the throttle in advance when encountering a red light, will increase fuel consumption. The car itself: Cars with larger displacement generally consume more fuel than those with smaller displacement because larger displacement usually means greater power, requiring more gasoline to burn and perform work. Cars with greater weight will also have higher fuel consumption because greater weight requires more driving torque. Road conditions: Driving on dirt roads, muddy roads, soft surfaces, or mountainous roads increases resistance and fuel consumption. Natural wind: Driving against the wind or on windy days increases the car's resistance and fuel consumption. Low environmental temperature: When the engine block temperature is low during cold starts, the injected gasoline is less likely to atomize, requiring more gasoline to be injected for combustion, thus increasing fuel consumption. Additionally, at low temperatures, the engine's computer will control the engine to run at higher RPMs to warm up, which also increases fuel consumption.
3
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.